2002 Peugeot 607 Dag seats

3YOUR AT A GLANCE
1Lights and direction indica
tors stalk.
2 Steering wheel adjustment.
3 Driver's front air bag.
Horn.
4 Instrument dials.
5 Windscreen wash/wipe
stalk.
Trip computer stalk.
6 Audio remote control stalk.
7 Hazard warning lights
switch.
8 Central adjustable
heating/ventilation vents and
air flow regulation.
9 Sunshine / brightness
sensor.
10 Windscreen demisting
vents.
11 Passenger air bag.
12 Glove compartment.
13 Side adjustable heating/ven
tilation vents and air flow
regulation. 14
Door window demisting
vent.
15 Passenger air bag disarming
switch.
16 Front seats heating switch.
17 Rear ashtray.
Rear lighter.
Rear seats heating switch.
18 Rear footwell heating vent.
19 Twoposition armrest with
compartments.
20 Handbrake.
21 Electronically controlled sus
pension switch.
Doors and boot locking
switch.
Sunroof switch.
Rear blind switch.
22 Front ashtray.
Front lighter.
23 Gear lever.
24 RM2 audio system or RT2
audio/telephone system with
PEUGEOT call button. 25
Heating/ventilation controls.
26 Multifunction display.
27 Steering lock and ignition.
28 Fuse box.
29 Speakers location.
30 Electric mirror controls.
Window controls.
Rear window locking control.
31 Headlamp height adjust
ment.
32 ESP disarming switch.
33 Alarm button.
34 Cruise control.
35 Memory buttons for:
Front seat settings
Electric mirror settings

YOUR AT A GLANCE8
THE SEATS
Manual front seats
1 Forwardsbackwards adjustment.
2 Seat angle adjustment*.
3 Seat height adjustment*.
4 Seat back angle adjustment.
5 Lumbar adjustment*.
6 Head restraint height and tilt adjust
ment (press the tab to slide it down).
* Driver's seat only.
Electric front seats
A Forwardsbackwards adjust
ment.
B Seat angle adjustment.
C Seat height adjustment
D Seat back angle adjustment.
E Lumbar adjustment.
F Head restraint height adjust
ment.
M Memorises settings.
 Switch on the ignition and
adjust the seat and the mirrors.
 Press button 'M'then within 4
seconds either button '1'for
the first position, or button '2'
for the second position.
1 Recalls the first position.
2 Recalls the
second position.
94
93

YOUR 607 IN DETAIL89
VENTILATION
1
Windscreen deicing or demisting vents
2 Front window deicing or demisting vents
3 Side vents
4 Centre vents
5 Air outlet to the front passengers' feet
6 Air outlet to the rear passengers' feet
Recommendations for use
For an even air distribution, make sure that you do not obstruct the air inlet grille at the base of the windscreen, the vents,
the air passages under the front seats and the air extractor in the boot.

YOUR 607 IN DETAIL93
THE SEATS
Manual front seats
1 Forwardsbackwards adjustment
Lift the lever and slide the seat forwards or backwards.
2 Seat cushion angle adjustment *
Raise the catch while pressing on or easing off the
seat back to obtain the required height.
3 Driver's seat height adjustment* Raise the catch to obtain the required height.
4 Seat back angle adjustment Raise the catch to obtain the required angle.
5 Lumbar adjustment *
Raise or lower the lever to obtain the correct position.
6 Head restraint height adjustment The head restraint has a frame with notches which
prevent the head restraint dropping down (safety
device in the event of an impact).
To raise the head restraint, push it upwards.
The setting is correct when the upper edge of the
head restraint is level with the top of the head.
To lower the head restraint, it is necessary to push
simultaneously :
–
the button located on the base of the head restraint frame ,
– the head restraint downwards.
The head restraint angle is also adjustable.
To remove the head restraint, lift it out by pressing the lug.
Warning : never drive with the head restraints removed; they
should be in place and correctly adjusted.
* Driver's seat only.

YOUR 607 IN DETAIL
94
Electric front seats
A Forwardsbackwards adjustment
Push the control forwards or backwards to slide the
seat.
B Seat cushion angle adjustment Tilt the front of the control upwards or downwards to
obtain the required angle.
C Seat height adjustment Tilt the rear part of the control upwards or downwards
to obtain the required height.
D Seat back angle adjustment Tilt the control to the front or the rear to obtain the co r
rect angle.
E Lumbar adjustment (mechanical adjustment) Raise or lower the lever to obtain the correct position.
F Head restraint height adjustment Tilt the control upwards or push it downwards to obtain
the correct height.
The setting is correct when the upper edge of
the head restraint is level with the top of the
head.
The head restraint angle is also adjustable manually.
To remove the head restraint, tilt the seat back to 45°
and place the head restraint in the high position, then
pull with both hands.
Note: the electrical functions of the driver's seat are inop
erative three minutes after the ignition has been switched
off.

YOUR 607 IN DETAIL95
Memorising using the buttons
To memorise:
 Place the ignition key in the 'run
ning' position (2nd notch),
 Adjust your seat and mirrors,
 Press button M,then button 1
(first driving position) or button 2
(second driving position) within
four seconds.
An audible signal confirms that a
position has been memorised.
Memorising a new position cancels
the previous one.
Recalling a memorised position
Engine off  Briefly press button 1 or 2to recall
the corresponding memorised
position. The end of the setting is
indicated by a bleep.
Note: after recalling a memorised
position five times in succession, the
function will be cancelled until the
engine is started.
Engine running
 Keep button 1 or 2pressed down
until the bleep indicates the end of
setting of the corresponding
memorised position.
Memorising seat
and mirror positions
Four driving positions can be memo
rised:
– two, using two remote control
keys (two users),
– two, using buttons M/1 and M/2.
Driving positions memorised by
the remote control key
When locking the doors, the remote
control key memorises the position
of the driver's seat and the exterior
mirrors.
When unlocking the doors, the dri
ver's seat and the exterior mirrors
resume the position memorised by
the remote control key if this has
changed in the meantime.
Each remote control key can
memorise a specific setting. Front and rear heated seats
controls
 Press the switch. The tempera
ture is regulated automatically.
 Press it again to stop operation.
Note: the command to activate heat
ing of the seat(s) remains in the
memory for two minutes after the
ignition is switched off.

YOUR 607 IN DETAIL
94
Electric front seats
A Forwardsbackwards adjustment
Push the control forwards or backwards to slide the
seat.
B Seat cushion angle adjustment Tilt the front of the control upwards or downwards to
obtain the required angle.
C Seat height adjustment Tilt the rear part of the control upwards or downwards
to obtain the required height.
D Seat back angle adjustment Tilt the control to the front or the rear to obtain the co r
rect angle.
E Lumbar adjustment (mechanical adjustment) Raise or lower the lever to obtain the correct position.
F Head restraint height adjustment Tilt the control upwards or push it downwards to obtain
the correct height.
The setting is correct when the upper edge of
the head restraint is level with the top of the
head.
The head restraint angle is also adjustable manually.
To remove the head restraint, tilt the seat back to 45°
and place the head restraint in the high position, then
pull with both hands.
Note: the electrical functions of the driver's seat are inop
erative three minutes after the ignition has been switched
off.

YOUR 607 IN DETAIL95
Memorising using the buttons
To memorise:
 Place the ignition key in the 'run
ning' position (2nd notch),
 Adjust your seat and mirrors,
 Press button M,then button 1
(first driving position) or button 2
(second driving position) within
four seconds.
An audible signal confirms that a
position has been memorised.
Memorising a new position cancels
the previous one.
Recalling a memorised position
Engine off  Briefly press button 1 or 2to recall
the corresponding memorised
position. The end of the setting is
indicated by a bleep.
Note: after recalling a memorised
position five times in succession, the
function will be cancelled until the
engine is started.
Engine running
 Keep button 1 or 2pressed down
until the bleep indicates the end of
setting of the corresponding
memorised position.
Memorising seat
and mirror positions
Four driving positions can be memo
rised:
– two, using two remote control
keys (two users),
– two, using buttons M/1 and M/2.
Driving positions memorised by
the remote control key
When locking the doors, the remote
control key memorises the position
of the driver's seat and the exterior
mirrors.
When unlocking the doors, the dri
ver's seat and the exterior mirrors
resume the position memorised by
the remote control key if this has
changed in the meantime.
Each remote control key can
memorise a specific setting. Front and rear heated seats
controls
 Press the switch. The tempera
ture is regulated automatically.
 Press it again to stop operation.
Note: the command to activate heat
ing of the seat(s) remains in the
memory for two minutes after the
ignition is switched off.