2002 Peugeot 406 C ignition

Electrical adjustment of the front seats
A - Forwards-backwards adjustmentPush the switch forwards or backwards to slide the seat.
B - Adjusting the seat cushion angle Tilt the front part of the switch up or down.
C - Adjusting the driver's seat height Push the switch up or down.
D - Seat back angle adjustment Tilt the switch forwards or backwards
E - Tilting the seat back Pull the lever and tilt the seat back forwards. As long as you hold the seat back in the tilted position, the seat moves forward automatically (when the dooris closed, the ignition must be switched on in order tomove the seat forwards). On repositioning, the seat resumes its original settings.
YOUR 406 COUPE IN DETAIL
92
01-07-2002

Recalling a memorised position
¥ Door open and ignition off Within ten minutes of switching off
the ignition and opening the door, ashort press on button 1or 2recalls
the memorised position of the seat,then of the exterior mirrors.
¥ Door closed or ignition on:
- keeping the button pressedadjusts the seat and the exteriormirrors. When adjustment is completed a bleep will sound.
YOUR 406 COUPE IN DETAIL 93
Memorising the seat and mirror positions
Two driving positions can be memo- rised.
To memorise:
- place the ignition key in the acces- sories position;
- adjust your seat and mirrors;
- simultaneously press button " M"
and button " 1" for the first driving
position or button " 2" for the
second driving position. When the position has been memorised, you will hear twobleeps. Memorising a new position cancels the previous one. Heated seat controls Press the switch.The temperature is controlled auto-
matically. Pressing a second time stops opera- tion.
01-07-2002

SEAT BELTS
To adjust the height of the front seat belts Pinch control 1and slide it.
To lock the seat beltsPull the strap, then insert the buckle into the stalk. Pre-tensioning and force-limitingfront seat belts Safety in the event of a frontal impact has been improved by the introduc-tion of pre-tensioning and force-limit-ing front seat belts. Depending onthe seriousness of the impact, thepre-tensioning system instantly tight-ens the seat belt firmly against thebody of the occupant. The pre-tensioning seat belts are active when the ignition is on. The force-limiting device reduces the pressure of the seat belt against theoccupant's body in the event of anaccident. Rear seat belts The rear seats are fitted with two three-point inertia reel belts.
YOUR 406 COUPE IN DETAIL
98
To be effective, a seat belt must be tightened asclose to the body as pos-sible.
Depending on the nature and theseriousness of the impact, thepre-tensioners may be triggeredbefore and independently of theair bags. In all cases, the air bag warning light comes on. Following a collision, have the system checked by a PEUGEOT
dealer. The system has been designed to be fully operational for ten years. Have it replaced after this period.
01-07-2002

THE KEYS The keys allow you to switch on the ignition and to independently operatethe locks on the doors, the fuel fillercap, the glove box and the passen-ger air bag disarming switch. Central locking From the doors the keys allow you to lock, deadlock and unlock the doorsand the boot, as well as fold back theexterior mirrors. If one of the front doors or the boot is open, central locking is not possible.In this case a bleep indicates lockingby remote control. The remote control performs the same functions at a distance. The remote control LockingPress button Ato lock the vehicle. This is confirmed by fixed lighting of the direction indicators for approxi-mately 2 seconds. Note:
in addition to locking, pressing
button Aautomatically closes the
windows and the sunroof. Deadlocking Deadlocking renders ithe internal and external door controls inopera-tive. Press button Ato deadlock the vehi-
cle. This is confirmed by fixed light- ing of the direction indicators forapproximately two seconds. Note : a long press on button A, in
addition to deadlocking, automatical- ly closes the windows and the sun-roof. Another press on button A, within
five seconds of deadlocking, changes this to normal locking. This is confirmed by fixed ighting of the direction indicators for approxi-mately two seconds, accompaniedby a brief sound of the horn. Unlocking Press button Bto unlock the vehicle.
This is confirmed by rapid flashing of the direction indicators. Note:
avoid handling the button of
your remote control when out of
range of your vehicle. You run therisk of stopping it from working. Itwould then be necessary to repro-gramme the remote control.
YOUR 406 COUPE IN DETAIL
84
ELECTRONIC ENGINE IMMOBILISER This locks the engine management system as soon as the ignition has
been switched off and therefore pre-vents starting of the vehicle by any-
one who does not have the key. The ignition key has an electronic chip which has a special code. Whenthe ignition is switched on, the codeis recognised and starting is possi-ble. If the system does not function
correctly, an audible signal sounds,
accompanied by a message on the
multi-function display.
WARNING: your vehicle is no longer
protected in this event.
Contact a PEUGEOT dealer as soon as possible.
01-07-2002

YOUR 406 COUPE IN DETAIL85
Changing the battery of the remote control The information 'battery flat'is
given by an audible signal accompa- nied by a message on the
multiÐfunction display.
To replace the battery, unclip the casing using a coin at the ring(CR2016/3 volt battery). If the remote control does not work after the battery has been changed,reprogramme the remote control.
Confidential card The confidential card contains the identification code necessary for anywork carried out by a PEUGEOT
dealer on the system. This code ishidden by a film, which should be
removed only if necessary. Keep your card in a safe place, never inside the vehicle. Reprogramming the remote control
 Switch off the ignition.
 Switch the ignition on again.
 Press button Aimmediately.
 Switch off the ignition and remove the remote control key from the
ignition. The remote control is nowworking again.
Key in ignition
A buzzer sounds on opening the dri-
ver's door, if the key has been left inthe ignition.
Locating your car
To locate your car, if you have locked it, in a car park:  press button A.The courtesy
lights come on and the directionindicators flash for a few seconds.
01-07-2002

YOUR 406 COUPE IN DETAIL
86
Make a careful note of the number of each key. This number is coded on the label attached to the key. If the key is lost, your PEUGEOT dealer can rapidly supply you with new keys. The high frequency remote control is a sensitive system.
Do not operate it while it is in your pocket as there is a possibility that it may unlock your vehicle.The remote control cannot operate while the key is in the ignition, even if the ignition is off, except for reprogramming.
However, do not operate the deadlocking system if there is someone inside the vehicle.As a safety measure (when there are children on board), remove the key from the ignition when you leave the vehicle, even for a short time.
Avoid operating the remote control buttons out of range of your vehicle; you run the risk of stopping it from working. It would then be necessary to reprogramme it. When buying a second-hand vehicle:
- check that you have been given the confidential card;
- have the keys memorised by a PEUGEOT dealer to be sure that the keys in your possession are the only ones which can start the vehicle.
Do not make any modifications to the electronic engine immobiliser system.
01-07-2002

THE ALARM SYSTEM Setting and deactivating the alarm The alarm completes the security
equipment for your vehicle. It offerstwo types of protection. ¥ exterior protection: when it is set,
the alarm sounds if a door, the
boot or the bonnet is opened;
¥ interior protection: when it is set,
the alarm sounds if the sensors detect a variation in the air move-
ment inside the vehicle (break-ing of a window) or movementinside the vehicle.
The alarm is also equipped with ananti-tamper function. If an attempt is made to tamper with the wires to the siren, control unit or
the battery, the alarm is triggered:the siren sounds and the headlampscome on. Setting the alarm (interior and exterior protection) Switch the ignition off and get out of the vehicle. Press the locking button of the
remote control key. The doors lock.The direction indicators light for two seconds. The red light on the switch flashes once a second.
5 seconds later, exterior protection is set.
50 seconds later, interior protection is set. Note:
when the alarm is triggered,
the siren sounds for thirty seconds. After the thirty seconds it stops, butthe alarm remains set.
Warning: If, on setting the alarm, a
door, the boot or the bonnet are not
closed correctly, the siren sounds fora moment. If the vehicle is closedcorrectly in the following 45 seconds,the alarm is set and the directionindicators remain on for twoseconds. In all cases, the alarm isset after 45 seconds. Disarming the alarm (interior and exteriorl protection) Press the unlocking button of the
remote control key. The doors unlock.The direction indicators flash for two seconds. The red warning light on the switch goes out. Note:
if the warning light continues
to flash after disarming the alarm, it is a sign that the alarm has been trig-
gered. The flashing will stop whenthe ignition is switched on.
SPECIAL FEATURES 135
01-07-2002

Emergency cut-off (If the remote control is not work- ing)
Unlock the doors with the key.
Open the door.
The alarm is triggered. You have ten
seconds in which to switch it off. ¥ Switch on the ignition.
¥ Immediately press interior protec-tion button 1.
¥ The siren stops and the alarm is disarmed. Selecting the type of protectionLocking without setting the alarm Special precautions
To set the alarm with exterior
protection only. If, while you are away from the vehi- cle, you wish to leave a window par-tially open or a pet inside the vehicle,you need to select exterior protectiononly:
¥ Switch off the ignition.¥ Within the next ten seconds, press
the interior protection button 1until
the light comes on continuously.
¥ Get out of the vehicle.¥ Press the locking button of the remote control.
¥ The doors lock.
¥ The direction indicators come on for two seconds.
¥ The red light on the switch flashes once a second.
To disarm exterior protection only
Press the unlocking button on the remote control. The doors unlock and the courtesy lights come on. The direction indicators flash for two seconds. The red light on the switch goes out. To lock the vehicle without setting the alarm It is the remote control which sets the alarm. Therefore, to lock the vehicle with-
out setting the alarm: use the key.
To recharge or replace the battery: ¥ Switch on the ignition.¥
You have 10 seconds after switching
on the ignition to press the interior protection button 1and hold it down
for two seconds.
¥ The indicator light flashes rapidly for three seconds.
¥
You can now disconnect the battery.
After reconnecting the battery:
¥ Lock, then unlock the vehicle using the remote control.
The alarm will be set the next time the vehicle is locked.
SPECIAL FEATURES
136
Do not make any modi- fications to the alarmsystem.
01-07-2002