2002 Peugeot 306 Dag ignition

1
89
YOUR 306 IN DETAIL
To adjust the height of the front seat belts Pull the knob 1and slide it.
To lock the seat beltsPull the strap, then insert the end into the buckle. Pre-tensioning and force-limiting front seat belts* Safety in the event of a frontal impact has been improved by the introduc-tion of pre-tensioning and force-limit-ing front seat belts. Depending on theseriousness of the impact, the pre-tensioning system instantly tightensthe seat belts firmly against the bodyof the occupant. The pre-tensioning seat belts are armed when the ignition is on. The force-limiting device reduces the pressure of the seat belt against the
occupantÕs body in the event of anaccident. Rear seat belts 4-door:
the rear seats are fitted with
3 three-point inertia reel seat belts.
3/5-door, estate: The rear seats are
fitted with 2 three-point inertia reel seat belts and one lap belt. Use the buckle retaining hooks when the rear seats are not occupied.
* According to specification. To be effective, a seat belt must be tensioned asclose to the body as pos-sible.
Depending on the nature and seri-ousness of the impact the pre-ten-sioning system may be triggeredbefore and independently of theairbags. In all cases, the airbag warning light comes on. Following an impact, have the system checked by a PEUGEOT
dealer. The system has been designed to be fully operational for ten years. Have it replaced at the end of this period.
SAFETY: SEAT BELTS

YOUR 306 IN DETAIL
78
THE REMOTE CONTROL
A single press on button Alocks the
doors and boot or tailgate, this is dis- played by the direction indicatorsstaying on for about 2 seconds.
A single press on button Bunlocks the
vehicle, this is displayed by the direc-
tion indicators flashing rapidly.
KEYS
Without central locking The key individually Iocks and unlocks the doors and boot or tailgate.
With central locking
Turning the key in the driverÕs door lock will lock or unlock the doors andboot or tailgate. If either of the frontdoors is not closed, the central lockingwill not work. CHANGING THE REMOTE
CONTROL BATTERIES
To gain access to the battery, unclip the key casing with a coin where youcan see the ring (CR1620/3 volt battery). If the remote control does not work after the battery has been changed,re-programme the remote control. PROGRAMMING THE REMOTE CONTROL Manual synchronisation
- Switch off the ignition,
- Switch on the ignition,
- Immediately after switching on the
ignition press button A.
The remote control is now working again. Automatic synchronisation
- Switch on the ignition (position M),
- Switch off the ignition and, during the next four minutes, lock the vehicle using the remote control(button A).
The remote control is now workingagain.
Note: do not repeatedly press the
button of your remote control out of
range of your vehicle. You risk causingit not to work and the remote controlwould have to be reprogrammed.
A
B

A
79
YOUR 306 IN DETAIL
DOORS Opening the doors from outside
Take careful note of the numbers on the keys. The key number is coded on the label attached to
the key. If the key is lost
your PEUGEOT dealer can rapidlysupply you with new keys or aremote control. As a safety precaution (with chil- dren on board) remove the ignitionkey when you leave the vehicle,even for a short time. The high frequency remote control is a high-performance systemwhich has a powerful beam. There-fore do not operate it while it is inyour pocket as there is a possibil-ity that it may unlock your vehicle.
Opening the doors frominside LOCKING FROM INSIDE THEVEHICLE
Without central locking
To lock, press button
A. The button
locks that door.
With central locking
To lock, press button A.
Locking the driverÕs door locks the front and rear doors and the tailgate. On the other doors the button only
locks that door.

80
YOUR 306 IN DETAIL
Locking or unlocking the boot or tailgate 3 or 5 door without central locking
Turn the key in the tailgate lock. 4 door or estate Using the key: turn the key in the boot or tailgate lock. Using the remote control*: the boot or tailgate locks and unlocks at the sametime as the doors. Locking the boot only (4 door)
Turn the key to the right in the boot lock. The boot will be locked whatever the action of the remote control or the
driverÕs door lock.
To open, turn the key to the left in the
boot lock. The boot will then be lockedat the same time as the central lockingof the doors. The seat back locking control enables you to prevent unauthorised entry tothe boot, even if the doors are open. Locking or unlocking the bootor tailgate 3 or 5 door with central locking The tailgate locks and unlocks at the same time as the doors.
Tailgate release In the event of a central locking oper- ating fault, this enables the tailgate tobe unlocked:
- fold the rear seats to gain access
to the control from inside the vehicle.
- Insert the ignition key in the opening and slide it to unlock the tailgate.
Child lock This prevents opening of the rear doors from inside the vehicle.
Turn control 1a quarter turn using the
ignition key. It is still possible to open the doors from outside the vehicle.
* According to specification.
1

YOUR 306 IN DETAIL
82
Fuel filler flap
To open*:
firmly pull the handle on the
floor to the outside of the driverÕs seat.
To close: from outside, push the flap
back and check that it is secured
correctly.
* According to specification. Filling with fuel Switch off the engine. There is a holder for the fuel filler cap.
A label on the inside of the flap shows which fuels are permitted and whichare not allowed. The capacity of the tank is approx- imately 13 gallons (60 litres). Use the ignition key to open and close the fuel filler cap independently ofopening the doors.

AB
90
YOUR 306 IN DETAIL
LIGHTING CONTROL Front lights
Selection is by turning ring A.
* According to specification.
Lights off. Side lights on.
Dipped beam/main beam. Dipped beam/main beam change Pull the stalk fully towards you.
Front and rear (ring B) Lights off. Front fog lamps on.
These operate with the side lights and the dipped/main beam headlamps. Front and rear foglamps on. These operate with the side lights and the
dipped/main beam headlamps. When
the side lights are switched off, thereis a return to the front fog lamps onlyposition.
Direction indicators(flashers) Left : downwards.Right : upwards.
Front and rear fog lights
To switch on, turn the ring. The posi- tion is confirmed by the light on theinstrument panel.
Note:
when the ignition is switched
off, if the driverÕs door or front pas-senger door* is left open, a buzzersounds if you forget that you have leftyour lights on.
Horn Press the end of the lighting stalk.

3
2
1
0
4A
91
In good weather or in rain, both day and night, if therear fog lamp is lit itcauses glare and is pro-hibited.
Do not forget to switch it off assoon as it is no longer needed. Do not cover the rain detector located on the windscreen behind
the interior mirror. When using an automatic car wash, switch off the ignition orcheck that the wiper control is notin the automatic position. In winter it is advisable to wait for the windscreen to completely clearof ice before operating the auto-matic wipe.
YOUR 306 IN DET AIL
WINDSCREEN WIPERS Front windscreen wipers 3 Fast wipe.
2 Normal wipe.
1 Intermittent or automatic wipe.
0 Park.
4 Single wipe.
Windscreen and headlight wash* Pull the wipers stalk towards you. The headlamp wash works if the dipped or main beam headlamps areon. Automatic windscreen wiper* In position
1, the wipers operate auto-
matically and adjust their speed to
the rainfall. After switching off the ignition or after starting, this function must bere-set, so the sensor can detect thecondition of the windscreen.
To do this, change the stalk position :
Ð from 1to 0then back to 1(con-
firmed by a single wipe),
Ð change from 1to 2, then back to 1
(confirmed by two wipes).
Rear screen wiper (estate)
Turn ring Ato the first notch,
for intermittent wiping. Rear screen wash (estate)
Turn ring Abeyond the first
notch.
* According to specification.

1
234
99
YOUR 306 IN DETAIL
Electric windows*
1. DriverÕs electric window control
You have two options*: Manual operation: Push or pull switch 1, lightly. The window stops when the
switch is released.Automatic operation: Push or pull switch 1firmly. Pressing once opens or
closes the window completely. Automatic opening and closing operate only when the engine is switched on.
2. Passenger electric window control. Push or pull switch 2
.The window stops when the switch is released.
3. Left rear electric window control.
4. Right rear electric window control. Temporary locking of the rear windows (child safety) control This allows the rear windows to be locked in any position. NOTE:
as a safety measure (children
on board), remove the ignition key when leaving the vehicle even for ashort time.
* According to specification.