2002 PEUGEOT 206 CC light

INSTRUMENTS AND CONTROLS29
Front and side air bags warning light The warning light comes on
for a few seconds when the ignition is switched on. Switching on of this warning light, with the engine running, is accompanied byan audible signal and a message onthe multifunction display indicating afault in the air bags.
Contact a PEUGEOT dealer.
Seat belt not fastened warning light* When the ignition is switched
on, the warning light comes on when the driver has not fastened his seat belt. Engine autodiagnostics warning light This comes on each time the
ignition is switched on. If it comes on when the engine is run-ning, it indicates a malfunction in theinjection, ignition or emission control
system. There is a risk of damage to
your catalytic converter.
Contact a PEUGEOT dealer rapidly.
Low fuel level warning light When the warning light first
comes on, you have enough fuel to drive at least 35 miles (50 km) (the tank capac-
ity is approximately 47 litres (10.3 gallons).
Coolant temperature indicator light
Ð When the needle is in zone (A), the
temperature is correct.
Ð When the needle is in zone ( B), the
temperature is too high. The central
STOP warning light flashes.
You must stop immediately.
Contact a PEUGEOT dealer.
Dynamic stability control (ESP/ASR) warning light This comes on for a few seconds each time the igni-
tion is switched on. If the warning light remains on or comes on with the engine running, it isaccompanied by an audible signal andthe message "ESP/ASR not opera-
tional" on the multifunction display;
contact a PEUGEOT dealer. With the engine running and the vehi- cle moving, it flashes when the systemcomes into operation (if there is a dif-ference between the trajectory fol-lowed by the vehicle and that desiredby the driver). It comes on permanently when the system is disarmed.
* According to destination.
Passenger air bag disarming indicatorlight*
Switching on of this indicator light is accompanied by an audible signal andthe message "Passenger air bag dis-
armed" on the multifunction display.
If the passenger air bag is disarmed,the indicator light switches on andremains on. In all cases, if the warning light flashes,
contact a PEUGEOT dealer.
Battery charge warning light This can indicate any of the
following situations:
Ð faulty operation of the charging circuit,
Ð loose battery or starter terminals, Ð a cut or slack alternator belt,Ð an alternator fault.
Contact a PEUGEOT dealer.
07-10-2002

INSTRUMENTS AND CONTROLS29
Front and side air bags warning light The warning light comes on
for a few seconds when the ignition is switched on. Switching on of this warning light, with the engine running, is accompanied byan audible signal and a message onthe multifunction display indicating afault in the air bags.
Contact a PEUGEOT dealer.
Seat belt not fastened warning light* When the ignition is switched
on, the warning light comes on when the driver has not fastened his seat belt. Engine autodiagnostics warning light This comes on each time the
ignition is switched on. If it comes on when the engine is run-ning, it indicates a malfunction in theinjection, ignition or emission control
system. There is a risk of damage to
your catalytic converter.
Contact a PEUGEOT dealer rapidly.
Low fuel level warning light When the warning light first
comes on, you have enough fuel to drive at least 35 miles (50 km) (the tank capac-
ity is approximately 47 litres (10.3 gallons).
Coolant temperature indicator light
Ð When the needle is in zone (A), the
temperature is correct.
Ð When the needle is in zone ( B), the
temperature is too high. The central
STOP warning light flashes.
You must stop immediately.
Contact a PEUGEOT dealer.
Dynamic stability control (ESP/ASR) warning light This comes on for a few seconds each time the igni-
tion is switched on. If the warning light remains on or comes on with the engine running, it isaccompanied by an audible signal andthe message "ESP/ASR not opera-
tional" on the multifunction display;
contact a PEUGEOT dealer. With the engine running and the vehi- cle moving, it flashes when the systemcomes into operation (if there is a dif-ference between the trajectory fol-lowed by the vehicle and that desiredby the driver). It comes on permanently when the system is disarmed.
* According to destination.
Passenger air bag disarming indicatorlight*
Switching on of this indicator light is accompanied by an audible signal andthe message "Passenger air bag dis-
armed" on the multifunction display.
If the passenger air bag is disarmed,the indicator light switches on andremains on. In all cases, if the warning light flashes,
contact a PEUGEOT dealer.
Battery charge warning light This can indicate any of the
following situations:
Ð faulty operation of the charging circuit,
Ð loose battery or starter terminals, Ð a cut or slack alternator belt,Ð an alternator fault.
Contact a PEUGEOT dealer.
07-10-2002

INSTRUMENTS AND CONTROLS
30
Instrument panel display After switching on the ignition, three functions are shown in succession:
Ð service indicator (see corresponding section),
Ð engine oil level indicator,Ð total distance recorder/total and trip distances.Note:
the total and trip distances are displayed for 30 seconds when the ignition
is switched off, on opening the driver's door, as well as on locking and unlocking the vehicle. Engine oil level When the ignition is switched on, the engine oil level is indicated for approximately 10 seconds, after the servicing information.
Maximum Check the level using the dipstick to confirm whether the level indicated is correct; a surplus ofoil can cause damage to the engine.
Consult a PEUGEOT dealer without delay. Minimum Check the level with the dipstick and top it up. The level indicated is only correct if the vehiclehas been on stable, level ground, with the enginestopped, for 10 minutes. Oil level gauge fault The 6 segments flash to indicate a fault in the oil level gauge. There is a risk the engine will be damaged.
Consult a PEUGEOT dealer.
Engine oil temperature indicator light When the engine is running, it indi- cates the oil temperature:
Ð When the needle is in zone
(C), the
temperature is correct,
Ð When the needle is in zone (D), the
temperature is too high. To lower the oil temperature, reduce yourspeed.
07-10-2002

INSTRUMENTS AND CONTROLS
30
Instrument panel display After switching on the ignition, three functions are shown in succession:
Ð service indicator (see corresponding section),
Ð engine oil level indicator,Ð total distance recorder/total and trip distances.Note:
the total and trip distances are displayed for 30 seconds when the ignition
is switched off, on opening the driver's door, as well as on locking and unlocking the vehicle. Engine oil level When the ignition is switched on, the engine oil level is indicated for approximately 10 seconds, after the servicing information.
Maximum Check the level using the dipstick to confirm whether the level indicated is correct; a surplus ofoil can cause damage to the engine.
Consult a PEUGEOT dealer without delay. Minimum Check the level with the dipstick and top it up. The level indicated is only correct if the vehiclehas been on stable, level ground, with the enginestopped, for 10 minutes. Oil level gauge fault The 6 segments flash to indicate a fault in the oil level gauge. There is a risk the engine will be damaged.
Consult a PEUGEOT dealer.
Engine oil temperature indicator light When the engine is running, it indi- cates the oil temperature:
Ð When the needle is in zone
(C), the
temperature is correct,
Ð When the needle is in zone (D), the
temperature is too high. To lower the oil temperature, reduce yourspeed.
07-10-2002

INSTRUMENTS AND CONTROLS31
Hazard warning lights
Press the button, the direction indica- tors flash.
They can operate with the ignition off.
Automatic lighting of hazard warning lights*
When braking in an emergency, depending on the force of decelera-tion, the hazard warning lights come
on automatically. They switch off auto-matically the first time you accelerate.
It is also possible to switch them off by pressing the button.
* According to destination.Total distance recorder Briefly pressing button 1alternates
between the total distance and trip dis- tance displays.
To reset the trip recorder to zero, when it is displayed press and hold the resetbutton for just over 3 seconds.Lighting rheostat With the lights on, press the button to vary the intensity of the lighting on theinstrument panel and the multifunction
display. When the lighting reaches theminimum (or maximum) setting, releasethe button then press it again toincrease (or reduce) the brightness. As soon as the lighting is of the required brightness, release the button.
07-10-2002

07-10-2002
YOUR 206 CC IN DETAIL
46
The control unit This is located in the glove box. 1.
CD-ROM eject button.
2. CD-ROM compartment.
3. ON indicator light indicates that the control unit is supplied
with power.
4. CD indicator light shows that there is a CD-ROM in theunit.
5. Remote control storage compartment. The last voice message recall control
Pressing the button on the endof the lights stalk allows the lastvoice message to be repeated,
or, if appropriate, a voice mes-sage to be heard and a moredetailed display of the approach-
ing landscape to be displayed.
The CD-ROM This contains all the mappingdata. It must be inserted with the printed face upwards.
Use only CD-ROMs approved by PEUGEOT.
The use of copied compact discs may cause faults.

YOUR 206 CC IN DETAIL
58
AIR CONDITIONING
1. Air conditioning control The air conditioning is intended to operate in all seasons. In summer itallows the temperature to be reduced
and in winter, above 0 ¡C, it increases
the effectiveness of the demisting. Press the switch to activate
the air conditioning. The indi-cator light comes on. The air conditioning does not ope-rate when the air flow adjustmentcontrol is in the "OFF" position. Note It is quite normal that the condensa- tion created by the air conditioningresults in a flow of water under the
vehicle when it is stationary.
2. Temperature adjustment
To be set according to your requirements.
From blue (cold when the air condi- tioning is on) to red (hot).
07-10-2002

YOUR 206 CC IN DETAIL61
5.
Air distribution
Successive presses of this button allow the air flow to bedirected alternately to:
Ð the windscreen (demisting or de-icing),
Ð the windscreen and the footwells,
Ð the footwells,
Ð the central and side vents and the footwells,
Ð the central and side vents.
7. Air intake Press this button to recycle
the interior air. Recirculation,
shown on the display, pre-vents the entry of unpleasant
odours and fumes from the outside.
Avoid prolonged recirculation of the
interior air. To do this, press again toreturn the system to automatic pro-cessing of the air intake.
4. Air conditioning
Press this button to stop the
air conditioning. The "ECO"symbol lights up. Press againto return to automatic opera-
tion of the air conditioning. The "A/C"symbol is displayed. 8. Switching the system off
The "OFF" button enables theentire system to be switched
off.
Temperature-related comfort is nolonger guaranteed. Pressing the "OFF", "AUTO" or "Visi-
bility" button again reactivates the
system with the values set before it
was switched off.
9. De-icing the rear window
and the mirrors
Press this button to de-ice the rear screen and the mirrors.The de-icing system switches
off automatically. It is possible
to stop the de-icing before it switches
off automatically by pressing the but-ton again. Note: this function is disarmed when
the roof is stored in the boot. Important precaution Operate the air conditioning system for 5 to 10 minutes, once or twice amonth, to keep it in perfect working
order. If the system does not produce cold
air, do not use it and contact your
PEUGEOT dealer.
* According to specification.
Manual operation
If you wish you can make a different
choice from the one offered by the sys-
tem, by changing a setting. The otherfunctions will still be managed automat-
ically. Press the "AUTO" button to returnto completely automatic operation.
6. Air flowThe air flow may beincreased or reducedby pressing the buttons
+ or Ð respectively.
Note
The condensation created by the air condi- tioning causes a normal flow of water
under the vehicle when it stops. To preventcondensation on the inside of the vehicle in
cold or wet weather, you are advised toavoid using the "ECO" mode.
07-10-2002