Page 47 of 302

43 Tow-away protection
Te ch n ica l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index Tow - aw ay  al a rm
The switch is located in the center console.
1Press to switch off
2Indicator lamp
Once the alarm system has been armed, the exterior 
vehicle lamps will flash and an alarm will sound when 
someone attempts to raise the vehicle.The alarm will last approximately 3 minutes in the form 
of f lashing exterior lamps. At the same time an alarm 
will sound for 30 seconds. The alarm will stay on even if 
the vehicle is immediately lowered.
The tow-away alarm system is switched off automatically 
if the vehicle is unlocked with the electronic main key.
If the alarm stays on for more than 20 seconds, an 
emergency call is initiated automatically. See Tele Aid 
on page 156.
To prevent triggering the tow-away alarm feature, switch 
off the tow-away alarm before towing the vehicle, or 
when parking on a surface subject to movement, such 
as a ferry or auto train.
To do so, turn key in steering lock to position 1 or 0, or 
remove key from steering lock. Press tow-away alarm 
switch (1). The indicator lamp (2) illuminates briefly.
Exit vehicle, and lock vehicle with key or remote 
control.
The tow-away alarm remains switched off until the 
vehicle is locked again with key or remote control, at 
which time it is automatically reactivated. 
     
        
        Page 54 of 302
50 Seats
Te ch n ica l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index
Seat heater (SL 500 optional)
The seat heater switches are located on the center 
console.
The seat heaters can be switched on with the key in 
steering lock positions 1 or 2.Press switch to turn on seat heater:
1Normal seat heating mode. One indicator lamp in 
the switch lights up.
2Rapid seat heating mode. Both indicator lamps in 
the switch light up. After approximately 5 minutes 
in the rapid seat heating mode, the seat heater 
automatically switches to normal operation and only 
one indicator lamp will stay on.
Turning off seat heater:
If one indicator lamp is on, press upper half of switch.
If both indicator lamps are one, press lower half of 
switch.
If left on, the seat heater automatically turns off after 
approximately 30 minutes of operation.
P91.30-0270-26
12 
     
        
        Page 76 of 302

72 Rear view mirrors
Te ch n ica l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index
Exterior rear view mirrors
The switch is located on the center console.
Turn key in steering lock to position 2.
First select the mirror to be adjusted - turn switch:
1Left mirror
2Right mirror
To adjust, toggle the switch forward, backward or to 
either side.With the key in steering lock position 2, the driver’s 
side mirror reflection brightness responds to changes in 
light sensitivity.
With gear selector lever in position “R”, or with the 
interior lamp switched on, the driver’s side mirror 
brightness does not respond to changes in light 
sensitivity.
Notes:
The exterior mirrors have electrically heated glass. The 
heater switches on automatically, depending on outside 
temperature.
If the mirror housing is forcibly pivoted from its normal 
position, it must be repositioned by applying firm 
pressure until it snaps into place.
2
1
P82.00-0359-26
Wa r n i n g !
Exercise care when using the passenger-side 
mirror. The passenger-side exterior mirror is 
convex (outwardly curved surface for a wider field 
of view). Objects in mirror are closer than they 
appear. Check your inside rear view mirror or 
glance over your shoulder before changing lanes. 
     
        
        Page 120 of 302
116 Interior equipment
Te ch n ica l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index
Power w indows
Power window switches located on center consoleTurn key in steering lock to position 1 or 2.
Press switch in to resistance point:
kto open
jto close
Release switch when window is in desired position.
P54.25-0311-26
Wa r n i n g !
When closing the windows, be sure that there is no 
danger of anyone being harmed by the closing 
procedure.When leaving the vehicle, always remove the key 
from the steering lock, and lock the vehicle. Do not 
leave children unattended in the vehicle, or with 
access to an unlocked vehicle. Unsupervised use of 
vehicle equipment can cause serious personal 
injury.The closing procedures can be immediately 
reversed by either pressing the switch k, 
turning the key to the unlocking position, or 
pressing button Œ on the remote control, and 
holding it. 
     
        
        Page 122 of 302
118 Interior equipment
Te ch n ica l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index
Roll bar
The switch is located in the center console.
Turn key in steering lock to position 2.
Press switch
Upper half = to raise
Lower half = to lower
The lowering or raising procedure is immediately 
interrupted by releasing the roll bar switch.If the roll bar was raised using the switch, it will be 
automatically lowered when activating the soft top 
switch.
The roll bar will be automatically raised in an accident 
or in a potentially dangerous driving situation. A ratchet 
noise can be heard when the roll bar is automatically 
raised.
The roll bar can be lowered again after an automatic 
deployment by pressing the upper half of the roll bar 
switch (for at least 5 seconds) until the roll bar drive 
mechanism audibly engages. Then press the lower half 
of the switch to lower the roll bar.
P91.59-0202-26 
     
        
        Page 134 of 302
130 Interior equipment
Te ch n ica l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index
Ashtray with lighter
Ashtray in center console
By touching the bottom of the cover lightly, the ashtray 
opens automatically.
Prior to removing the ashtray insert, move the gear 
selector lever to position “N”.To remove ashtray:
Push sliding knob (1) toward the right to eject the 
insert.
To install ashtray:
Install insert into ashtray frame and push down to 
engage.
Wa r n i n g !
Remove front ashtray only with vehicle standing 
still. With the gear selector lever in position “N”, 
turn off the engine and set the parking brake. 
Otherwise the vehicle might move as a result of 
unintended contact with the gear selector lever. 
     
        
        Page 152 of 302
148 Wind screen
Te ch n ica l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index
Wind screen
The wind screen is stored in a trunk mounted 
container (1) which is fastened by clamps (arrows).Installation
1. Raise roll bar partially using switch on center 
console, see page 118.
P91.59-0202-26 
     
        
        Page 154 of 302
150 Wind screen
Te ch n ica l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index
Setting up
Push top of wind screen fully forward against internal 
stop.Removal
1. Fold down top of wind screen.
2. Raise roll bar using switch on center console.
3. Disconnect attachment strap latches by squeezing 
latch.
4. Lower roll bar partially.
Wa r n i n g !
The rear storage area should never be occupied by 
passengers since the vehicle is a 2 seater. 
Furthermore, with the wind screen in place there 
is a risk of injury, should the roll bar be deployed.
P65.00-0292-26