Page 49 of 385

46 Seats
Te ch n i c a l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index
Power seat
The switches are located in each front door.
We recommend to adjust the power seat in the following 
order:
1Seat, up / down
Press the switch (up / down direction) until 
comfortable seating position with still sufficient 
headroom is reached.2Seat adjustment, fore / aft
Press the switch (fore / aft direction) until a 
comfortable seating position is reached that still 
allows you to reach the accelerator / brake pedal 
safely. The position should be as far rearward as 
possible, consistent with ability to properly operate 
controls.
3Seat cushion tilt
Press the switch in the direction of the arrow until 
your legs are lightly supported. 
4Backrest tilt
Press the switch in the direction of the arrow until 
your arms are slightly angled when holding the 
steering wheel.
5Head restraint
The height of the head restraint is adjusted 
automatically with the seat so that the back of the 
head is supported approximately at ear level. Adjust 
the head restraint using the switch to support the 
back of your head approximately at ear level.
5
41
3
2
2
J_G463.book Seite 46 Mittwoch, 19. September 2001 8:06 08 
     
        
        Page 53 of 385

50 Seats
Te ch n i c a l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index
Important!
Prior to operating the vehicle, the driver should check 
and adjust if necessary the seat height, seat position 
fore and aft, and backrest angle to insure adequate 
control, reach and comfort. The head restraint should 
also be adjusted for proper height. See also airbag 
section for proper seat positioning.
In addition, also adjust the steering wheel to ensure 
ad eq uate  con tr ol, r each,  operation  and  com fort. B ot h the  
inside and outside rear view mirrors should be adjusted 
for adequate rearward vision.
Fasten seat belts. Infants and small children should be 
seated in a properly secured restraint system that 
complies with U.S. Federal Motor Vehicle Safety 
Standard 213 and Canadian Motor Vehicle Safety 
Standard 213.
All seat, head restraint, steering wheel, and rear view 
mirror adjustments as well as fastening of seat belts 
should be done before the vehicle is put into motion.
Wa r n i n g !
Children 12 years old and under must never ride in 
the front seat, except in a Mercedes-Benz 
authorized BabySmart
TM compatible child seat, 
which operates with the BabySmart
TM system 
installed in the vehicle to deactivate the passenger 
side front airbag when it is properly installed. 
Otherwise they will be struck by the airbag when it 
inflates in a crash. If this happens, serious or fatal 
injury can result.
According to accident statistics, children are safer 
when properly restrained in the rear seating 
positions than in the front seating positions. 
Infants and small children must ride in back seats 
and be seated in an appropriate infant or child 
restraint system, which is properly secured with 
the vehicle’s seat belt, fully in accordance with the 
child seat manufacturer’s instructions.A child’s risk of serious or fatal injuries is 
significantly increased if the child restraints are 
not properly secured in the vehicle and the child is 
not properly secured in the child restraint.
J_G463.book Seite 50 Mittwoch, 19. September 2001 8:06 08 
     
        
        Page 62 of 385
59 Restraint systems
Te ch n i c a l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index Tighten the lap portion to a snug fit by pulling shoulder 
portion up.
The shoulder portion of the seat belt must be pulled 
snug and checked for snugness immediately after 
engaging it.
Adjust seat belt so that shoulder portion is located as 
close as possible to the middle of your shoulder (it 
should not touch the neck). For this purpose, you can 
adjust the height of the belt outlet. Five positions are 
available.4 Button for belt outlet height adjustment
To raise, slide belt height adjustment upward.
To lower, press button (4) and slide belt outlet 
downward.
Caution!
For safety reasons, avoid adjusting the seat or backrest 
into positions which could affect the correct seat belt 
positioning.
2302
4
J_G463.book Seite 59 Mittwoch, 19. September 2001 8:06 08 
     
        
        Page 81 of 385

78 Steering wheel adjustment
Te ch n i c a l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index
Steering wheel adjustment 
To operate the steering wheel adjustment switches, turn 
the electronic key in starter switch to position 1 or 2 
(with a front door opened, the steering wheel 
adjustment can also be operated with the electronic key 
removed or in starter switch position 0 for 
approximately 30 minutes).The switch is located on the driver’s door.
1Steering column, lengthen or shorten column
Move the switch to the front or rear.
2Steering column, height
Move the switch up or down.
Note:
The steering wheel adjustment can be stored together 
with the seat and exterior rear view mirror adjustment.
See page 48 for notes on the memory function.
Wa r n i n g !
Do not adjust the steering wheel while driving. 
Adjusting the steering wheel while driving could 
cause the driver to lose the control of the vehicle.When leaving the vehicle always remove the 
electroni c key  f rom  t he sta rter s wi tch a nd  lock  your 
vehicle.The steering wheel adjustment feature can also be 
operated with the driver’s door open. Do not leave 
children unattended in the vehicle, or with access 
to a n un locked  vehi cle. Un supervi sed  use of vehicl e 
equipment may cause serious personal injury.
1
2
2562
J_G463.book Seite 78 Mittwoch, 19. September 2001 8:06 08