Page 90 of 406

87 Restraint systems
Te ch n i c a l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index
Wa r n i n g !
The “LATCH” mounting fittings are intended for 
children up to 22 kg (50 lbs) in weight.Children too big for child restraint systems must 
ride in back seats using regular seat belts. Position 
shoulder belt across chest and shoulder, not face or 
neck. A booster seat may be necessary to achieve 
proper belt positioning for children from 41 lbs. to 
the point where a lap/shoulder belt fits properly 
without one.Before installing the child seat, make sure the 
mounting fittings (1) are folded out and locked in 
place.Install child seat according to manufacturer’s 
instructions.The child seat must be firmly attached in the right 
and left side mounting fittings (1).An incorrectly mounted child seat may come loose 
during an accident which could result in serious 
injury or death to your child.
Damaged or impact damaged child seats or child 
seat mounting fittings must be replaced.Do not leave children unattended in the vehicle, 
even if the children are secured in a child restraint 
system.
OM_203.book  Seite 87  Donnerstag, 31. Mai 2001  11:57 11 
     
        
        Page 226 of 406

223 Interior equipment
Te ch n i c a l
data Instruments 
and controlsOperationDrivingInstrument 
cluster displayPractical hints Car care Index Loading instructions
(Vehicle with enlarged cargo area)
The total load weight including vehicle occupants and 
luggage/cargo should not exceed the vehicle capacity 
weight indicated on the certification tag which can be 
found on the left door pillar.The handling characteristics of a fully loaded vehicle 
depend greatly on the load distribution. It is therefore 
recommended to load the vehicle according to the 
illustrations shown, with the heaviest items being 
placed towards the front of the vehicle.
Always place items being carried against front or rear 
seat backrests, and fasten them as securely as possible.
The heaviest portion of the cargo should always be kept 
as low as possible since it influences the handling 
characteristics of the vehicle.
Note:
The trunk is the preferred place to carry objects.
The enlarged cargo area should only be used for items 
which do not fit in the trunk alone.
OM_203.book  Seite 223  Donnerstag, 31. Mai 2001  11:57 11 
     
        
        Page 345 of 406

342 Battery
Te ch n i c a l
data Instruments 
and controlsOperation DrivingInstrument 
cluster displayPractical hintsCar care Index
warm tires only if pressure has dropped below the 
pressure listed in the table and the respective operating 
conditions are taken into consideration.
An underinflated tire due to a slow leak (e.g. due to a 
nail in the tire) may cause damage such as tread 
separation, bulging etc. Regular tire pressure checks 
(including the spare tire) at intervals of no more than 
14 days are therefore essential.
If a tire constantly loses air, it should be inspected for 
damage.
The spare tire should be checked periodically for 
condition and inflation. Spare tire will age and become 
worn over time even if never used, and thus should be 
inspected and replaced when necessary.Battery
Important!
Battery replacement information:
The maintenance-free battery is located in the engine 
compartment on the right hand side.
The service life of the battery is dependent on its 
condition of charge. The battery should always be kept 
sufficiently charged, in order to last an optimum length 
of time.
Wa r n i n g !
Do not overinflate tires. Overinflating tires can 
result in sudden deflation (blowout) because they 
are more likely to become punctured or damaged 
by road debris, potholes etc. Follow recommended 
inflation pressures.Do not overload the tires by exceeding the specified 
vehicle capacity weight as indicated by the label on 
the driver’s door latch post). Overloading the tires 
can overheat them, possibly causing a blowout.
Wa r n i n g !
Failure to follow these instructions can result in 
severe injury or death.Never lean over batteries while connecting, you 
might get injured.Battery fluid contains sulfuric acid. Do not allow 
this fluid to come in contact with eyes, skin or 
clot hin g. In  cas e i t d oes , i mm ed ia tely  f lus h a f fected  
area with water and seek medical help if necessary.A battery will also produce hydrogen gas, which is 
flammable and explosive. Keep flames or sparks 
away from battery, avoid improper connection of 
jumper cables, smoking etc.
OM_203.book  Seite 342  Donnerstag, 31. Mai 2001  11:57 11 
     
        
        Page 350 of 406

347 Towing the vehicle
Te ch n i c a l
data Instruments 
and controlsOperation DrivingInstrument 
cluster displayPractical hintsCar care Index Towing the vehicleImportant!
When towing the vehicle, please, note the following:
With the automatic central locking activated and the 
electronic key in starter switch position 2, the vehicle 
doors lock if the lef t front wheel as well as the right rear 
wheel are turning at vehicle speeds of approximately 
9 mph (15 km / h) or more.
To prevent the vehicle door locks from locking, 
deactivate the automatic central locking. See the 
individual setting menu “VEHICLE” – “AUTOMATIC 
DOOR LOCK” on page 131.
Towing of the vehicle should only be done using the 
properly installed towing eye bolt. Never attach tow 
cable, tow rope or tow rod to vehicle chassis, frame 
or suspension parts.
Notes:
The selector lever will remain locked in position “P” and 
the electronic key cannot be turned in the starter switch 
if the battery is disconnected or discharged. See battery 
on page 342 or jump starting on page 344.
Transmission selector lever, manually unlocking, see 
page 350.
Wa r n i n g !
Prior to towing the vehicle with all wheels on the 
ground, make certain that the electronic key is in 
starter switch position 2.If the electronic key is left in the starter switch 
position 0 for an extended period of time, it can no 
longer be turned in the switch. In this case, the 
steering is locked. To unlock, remove electronic key 
from starter switch and reinsert.When towing another vehicle, observe that the 
gross vehicle weight of the vehicle being towed 
does not exceed the towing capacity of your vehicle.
OM_203.book  Seite 347  Donnerstag, 31. Mai 2001  11:57 11