2002 MAZDA MODEL PROTÉGÉ clutch

4-5
Before Driving Your Mazda
Form No. 8Q36-EA-01F
Before Starting the Engine
•Be sure the windows, outside mirror
(s), and outside lights are clean.
•Inspect inflation pressures and
condition of tires.
•Look under the vehicle for any sign of
a leak.
•If you plan to back up, make sure
nothing will be in your way.•Are all doors closed and locked?
•Are the inside and outside mirrors
adjusted?
•Is everyone’s seat belt fastened?
•Do all the lights work?
•Check all gauges.
•Check all warning lights when the
ignition switch is turned to the ON
position.
•Release the parking brake and make
sure the parking brake warning light
goes off.
Always be thoroughly familiar with your
Mazda.
Before Getting In
NOTE
Engine oil, engine coolant, brake/
clutch fluid, washer fluid, and other
fluid levels should be inspected daily,
weekly, or at refueling, depending on
the fluid. See Maintenance, Section 8.
After Getting In
J39L(02MY).book Page 5 Thursday, November 1, 2001 10:49 AM

5-3
Driving Your Mazda
Starting and Driving
Form No. 8Q36-EA-01F
ACC (Accessory)
The steering wheel unlocks and some
electrical accessories will operate.
ON
This is the normal running position after
the engine is started. The warning lights
(except brakes) should be inspected
before the engine is started (page 5-24).
START
The engine is started in this position. It
will crank until you release the key; then
it returns to the ON position. The brake
warning light can be checked after the
engine is started (page 5-24).

Ignition Key Reminder
If the ignition switch is in the LOCK or
ACC position, a beep will sound when
any door is opened.1. Occupants should fasten their seat
belts.
2. Make sure the parking brake is on.
3. Depress the brake pedal.
4. (Manual transaxle)
Depress the clutch pedal all the way
and shift into neutral.
Keep the pedal depressed while
cranking the engine.
(Automatic transaxle)
Put the vehicle in park (P). If you must
restart the engine while the vehicle is
moving, shift into neutral (N).
NOTE
If turning the key is difficult, jiggle the
steering wheel from side to side.
Starting the Engine
NOTE
Engine-starting is controlled by the
spark ignition system.
This system meets all Canadian
Interference-Causing Equipment
Standard requirements regulating the
impulse electrical field strength of
radio noise.
NOTE
The starter will not operate if the
clutch pedal is not
pushed down all the
way.
NOTE
The starter will not operate if the shift
lever is not
in P or N.
J39L(02MY).book Page 3 Thursday, November 1, 2001 10:49 AM

5-8
Driving Your Mazda
Starting and Driving
Form No. 8Q36-EA-01F

Brake Pad Wear Indicator
When the disc brake pads become worn,
the built-in wear indicators contact the
disc plates. This causes a screeching noise
to warn that the pads should be replaced.
When you hear this noise, consult an
Authorized Mazda Dealer as soon as
possible.

Manual Transaxle Shift Pattern
The shift pattern of the transaxle is
conventional, as shown.
Press the clutch pedal all the way down
while shifting; then release it slowly.
A safety feature prevents accidental
shifting from 5 to reverse. The shift lever
must be put in neutral before being shifted
to reverse.
NOTE
When the engine is jump-started to
charge the battery, uneven rpm occurs
and the ABS warning light comes on.
This is due to a weak battery, not a
malfunction.
Recharge the battery.
Driving with Worn Disc Pads:
Driving with worn disc pads is
dangerous. The brakes could fail and
cause a serious accident. As soon as
you hear a screeching noise consult
an Authorized Mazda Dealer.
WARNING
Manual Transaxle
Operation
Neutral position
J39L(02MY).book Page 8 Thursday, November 1, 2001 10:49 AM

5-9
Driving Your Mazda
Starting and Driving
Form No. 8Q36-EA-01F
Various Lockouts: •Keep your foot off the clutch pedal
except when shifting gears. Also,
don’t use the clutch to hold the
vehicle on an upgrade. This will
avoid needless clutch wear and
damage.
•Make sure the vehicle comes to a
complete stop before shifting to
reverse.
Shifting to reverse while the vehicle
is still moving may damage the
transaxle.
NOTE
If shifting to reverse is difficult, shift
into neutral, release the clutch pedal,
and try again.
CAUTIONAutomatic Transaxle
Controls
Indicates that you must depress the
brake pedal and hold in the lock-release
button to shift (The ignition switch must
be in the ACC or ON position).
Indicates the shift lever can be shifted
freely into any position.
Indicates that you must hold in the lock-
release button to shift.
Lock-release button
To prevent unsafe
shifting
Overdrive button
For gear selection with either
a three-speed or four-speed
transaxle
Shift pattern indicator
Shows shift lever
position
J39L(02MY).book Page 9 Thursday, November 1, 2001 10:49 AM

5-19
Driving Your Mazda
Starting and Driving
Form No. 8Q36-EA-01F

To C a n c e l
To turn off the system, use one
of these
methods:
•Press the CRUISE MAIN switch.
•Slightly depress the brake pedal.
• (Type A)
Pull the lever toward you.
(Type B)
Press the CANCEL button.• (Manual transaxle)
Depress the clutch pedal.
The system is off when the ignition is off.
NOTE
Cruise control will cancel at about 15
km/h (9 mph) below the preset speed
or below 40 km/h (25 mph).
J39L(02MY).book Page 19 Thursday, November 1, 2001 10:49 AM

8-1
Form No. 8Q36-EA-01F
8Maintenance and Care
How to keep your Mazda in top condition.
Introduction
................................................................................. 8- 2
Introduction ............................................................................. 8- 2
Scheduled Maintenance
.............................................................. 8- 3
Scheduled Maintenance (Except Chile) .................................. 8- 3
Scheduled Maintenance (Chile) .............................................. 8- 6
Owner Maintenance
.................................................................... 8- 8
Owner Maintenance Schedule ................................................. 8- 8
Owner Maintenance Precautions ............................................. 8- 9
Engine Compartment Overview .............................................. 8-10
Engine Oil ................................................................................ 8-11
Engine Coolant ........................................................................ 8-14
Brake/Clutch Fluid .................................................................. 8-16
Power Steering Fluid ............................................................... 8-18
Automatic Transaxle Fluid (ATF) ........................................... 8-18
Washer Fluid ............................................................................ 8-20
Body Lubrication ..................................................................... 8-21
Air Filter .................................................................................. 8-21
Wiper Blades ........................................................................... 8-22
Battery ..................................................................................... 8-25
Tires ......................................................................................... 8-26
Light Bulbs .............................................................................. 8-30
Fuses ........................................................................................ 8-39
Appearance Care
......................................................................... 8-43
How to Minimize Environmental Paint Damage ..................... 8-43
Exterior Care ........................................................................... 8-45
Interior Care ............................................................................ 8-48
J39L(02MY).book Page 1 Thursday, November 1, 2001 10:49 AM

8-5
Maintenance and Care
Scheduled Maintenance
Form No. 8Q36-EA-01F

Schedule 2
I
: Inspect and repair, clean, adjust, or replace if necessary.
(Oil-permeated air filter cannot be cleaned using the air-blow method.)
R
: Replace
L
: Lubricate
*1: According to state and federal regulations, failure to perform maintenance on these items will not void your
emissions warranties. However, Mazda recommends that all maintenance services be performed at the
recommended time or kilometrage (mileage) period to ensure long-term reliability.
*2: If the vehicle is operated in cold districts { below -18 degrees C (0 degrees F) }, replace the timing belt at
96,000 km (60,000 miles).
Maintenance
Interval
Maintenance
ItemNumber of months or kilometers (miles), whichever comes first
Months 4 8 12 16 20 24 28 32 36 40 44 48
×1000 Km 8 1624324048566472808896
(×1000 Miles) (5) (10) (15) (20) (25) (30) (35) (40) (45) (50) (55) (60)
Engine valve clearanceI
Engine timing belt
*2Inspect at 96,000 km (60,000 miles)
Replace every 168,000 km (105,000 miles)
Drive belts (tension) II
Engine oilExcept Puerto RicoRRRRRRRRRRRR
Puerto RicoReplace every 5,000 km (3,000 miles) (or 3 months)
Engine oil filterRRRRRRRRRRRR
Cooling systemII
Engine coolantReplace at first 72,000 km (45,000 miles) or 36 months ;
after that, every 48,000 km (30,000 miles) or 24 months
Engine coolant levelIIIIIIIIIIII
Idle speedII
Air filter
I
*1R
I *1R
Fuel lines & hoses*1II
Hoses & tubes for emission*1I
Spark plugsRR
Function of all lightsIIIIIIIIIIII
Brake lines, hoses & connectionsII
Brake & clutch fluid level IIIIIIIIIIII
Disc brakesIIII
Drum brakesII
Tire inflation pressure and tire wearIIIIIIIIIIII
Steering operation & linkagesII
Power steering fluid levelIIIIIIIIIIII
Front suspension ball jointsII
Driveshaft dust bootsII
Bolts & nuts on chassis & bodyIIII
Exhaust system heat shieldsII
All locks & hingesLLLLLLLLLLLL
Washer fluid levelIIIIIIIIIIII
Refrigerant amount (if installed) IIII
Compressor operation (if installed) IIII
J39L(02MY).book Page 5 Thursday, November 1, 2001 10:49 AM

8-7
Maintenance and Care
Scheduled Maintenance
Form No. 8Q36-EA-01F
I
: Inspect: Inspect and clean, repair, adjust, or replace if necessary . R: Replace
L
: Lubricate T
: Tightenan
*5: If the brakes are used extensively (for example, continuous hard driving or mountain driving) or if the vehicle
is operated in extremely humid climates, change the brake fluid annually.
*6: This is a full function check of electrical systems such as lights, wiper and washer systems (including wiper
blades), and power windows.
Maintenance
Interval
Maintenance
ItemNumber of months or km (miles), whichever comes first
Months 6 121824303642485460667278849096
×1000 Km 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160
(×1000 Miles) (6) (12) (18) (24) (30) (36) (42) (48) (54) (60) (66) (72) (78) (84) (90) (96)
E.G.R. system (if installed)IIIIIIII
Battery electrolyte level
and specific gravityIIIIIIII
Brake and clutch pedalsIIIIIIIIIIIIIIII
Brake lines, hoses and
connectionsIIIIIIII
Brake fluid*
5I I IRI I IRI I IRI I IR
Clutch fluidIIIIIIIIIIIIIIII
Parking brakeIIIIIIIIIIIIIIII
Power brake unit and hosesIIIIIIII
Disc brakesIIIIIIIIIIIIIIII
Drum brakesIIIIIIII
Power steering fluid and linesIIIIIIIIIIIIIIII
Steering operation and gear
housingIIIIIIII
Steering linkage, tie rod ends and
armsIIIIIIII
Manual transaxle oilRR
Automatic transaxle fluid levelIIII III
Automatic transaxle fluid
RRR
Front and rear suspension and
ball jointsIIII
Driveshaft dust bootsIIII
Exhaust system heat shieldsIIII
Wheel nutsTTTTTTTT
Bolts and nuts on chassis and
bodyTTTTTTTT
All electrical system
*6 IIIIIIII
Headlight alignmentIIIII
Body condition (for rust,
corrosion and perforation)Ins
pect annually
Tires
(including spare tire, with
inflation pressure adjustment)IIIIIIII
Hinges and catchesLLLLLLLL
Road testIIIIIIIIIIIIIIII
J39L(02MY).book Page 7 Thursday, November 1, 2001 10:49 AM