Page 28 of 248

2-20
Essential Safety Equipment
SRS Air Bags
Form No. 8Q42-EA-01F
When the ignition switch is turned to the
ON position, the passenger-side air bag
deactivation indicator light comes on for
about 6 seconds.
If the passenger-side air bag deactivation
switch is in the OFF position, the
indicator light remains on to warn that the
passenger-side air bag has been
deactivated.To Deactivate The Passenger-Side
Air Bag
1. Insert the key into the switch.
2. Turn the key clockwise until the key
points to OFF.
3. Remove the key.
4. Make sure the air bag deactivation indicator light remains on when the
ignition is in the ON position.
The passenger-side air bag will remain
deactivated until the passenger-side air
bag deactivation switch is turned to the
ON position.
NOTE
Have the passenger-side air bag
deactivation switch inspected by an
Authorized Mazda Dealer if any of
these conditions occur:
• The indicator doesn
’t come on
when the ignition switch is turned to
the ON position.
• The indicator doesn
’t remain on
when the ignition switch is in the
ON position and the passenger-side
air bag deactivation switch is in the
OFF position.
• The indicator remains on when the
ignition switch is in the ON position
and the passenger-side air bag
deactivation switch is in the ON
position.
Leaving the Key in the Passenger-
Side Air Bag Deactivation Switch:
Unintentional deactivation of the
passenger-side air bag is dangerous.
In an accident, the passenger will not
be properly protected. Serious injuries
or even death could occur. To avoid
unintentional deactivation, always
use the same key to operate the
passenger-side air bag deactivation
switch and the ignition switch, that
way you won
’t leave the key in the
passenger-side air bag deactivation
switch.
WARNING
J07L(02MY).book Page 20 Monday, June 11, 2001 4:52 PM
Page 29 of 248
2-21
Essential Safety Equipment
SRS Air Bags
Form No. 8Q42-EA-01F
To Activate The Passenger-Side
Air Bag
1. Insert the key into the switch.
2. Turn the key counterclockwise until the
key points to ON.
3. Remove the key.
4. Make sure the air bag deactivation indicator light goes off after 6 seconds
when the ignition switch is turned to
the ON position.
J07L(02MY).book Page 21 Monday, June 11, 2001 4:52 PM
Page 45 of 248

3-11
Knowing Your Mazda
Doors and Locks
Form No. 8Q42-EA-01F
3. Use the support rod to hold the hood open.
Before closing the hood, secure the rod in
its clip.
Closing the Hood
1. Check under the hood area to make
certain all filler caps are in place and
all loose items (e.g. tools, oil
containers, etc.) have been removed.
2. Close the hood so that it locks securely.
Key-Operated Trunk
To open the trunk lid, insert the key into
the slot and turn it clockwise.
To close, use both hands to push the lid
down until the lock snaps shut. Don
’t
slam it.
Then pull up on it to make sure it ’s secure.
Clip
Support rod
Trunk Lid
Open Trunk and Exhaust Gas:
Exhaust gas in the cabin of a vehicle
is dangerous. This gas contains CO
(carbon monoxide), which is
colorless, odorless, and highly
poisonous. If inhaled, it can cause
loss of consciousness and death.
Because exhaust gas can get into the
cabin through an open trunk, keep
the trunk closed when driving.
WARNING
Open
J07L(02MY).book Page 11 Monday, June 11, 2001 4:52 PM
Page 46 of 248
3-12
Knowing Your Mazda
Doors and Locks
Form No. 8Q42-EA-01F
Remote Trunk Lid Release
The remote trunk lid release is mounted in
the center console.
To open the console, pull the release
catch.
To release the trunk lid, pull up on the
trunk lid release lever.
Remote Trunk Lid Release Lock-
Out
The remote release may be canceled to
prevent anyone in the vehicle from
opening the trunk.
Close the trunk, insert the key, and turn it
counterclockwise, then return the key to
the center position and remove it.
To activate the remote release, insert the
key, turn it clockwise and open the trunk
lid at the same time.
Trunk lid
release
lever
NOTE
If the remote trunk lid release does not
work, insert the key and turn it
clockwise.
J07L(02MY).book Page 12 Monday, June 11, 2001 4:52 PM
Page 50 of 248
3-16
Knowing Your Mazda
Doors and Locks
Form No. 8Q42-EA-01F
Fuel-Filler Cap
To remove the filler cap, turn it
counterclockwise.
To replace the filler cap, turn it clockwise
until it clicks.
Make sure the fuel-filler cap is
tightened securely. The check engine
light comes on when the cap isn ’t
tightened securely. If the light remains
on (even after you have tightened the
cap securely, driven, and restarted the
engine several times), it may indicate a
different problem. Contact an
Authorized Mazda Dealer as soon as
possible.
Open
Close
CAUTION
J07L(02MY).book Page 16 Monday, June 11, 2001 4:52 PM
Page 115 of 248
6-5
Interior Comfort
Climate Control System
Form No. 8Q42-EA-01F
Control Switches
Temperature control dial
This dial controls temperature. Turn it
clockwise for hot and counterclockwise
for cold. Fan control dial
This dial allows variable fan speeds.
0
—Fan off
1 —Low speed
2 —Medium low speed
3 —Medium high speed
4 —High speed
Manual Type
A/C switch Fan control dial
Rear window defroster switch
Temperature control dial Air intake selector Mode selector dial(page 5-33)
Hot
Cold
J07L(02MY).book Page 5 Monday, June 11, 2001 4:52 PM
Page 127 of 248

6-17
Interior Comfort
Audio System
Form No. 8Q42-EA-01F
Power/Volume/Sound Controls ............................................................................................. 6-18
Clock ..................................................................................................................................... 6-22
Operating the Radio ........................................................................................................... .... 6-24
Operating the Cassette Tape Player ....................................................................................... 6-26
Operating the Mini Disc (MD) Player ................................................................................... 6-28
Operating the Compact Disc (CD) Player ............................................................................. 6-30
Operating the In-Dash CD Changer ...................................................................................... 6-32
Error Indications ............................................................................................................. ....... 6-35
Audio Set
CD PlayerIn-dash CD Changer
Cassette Tape Player Mini Disc (MD) PlayerIllustration is of a representative audio unit.
J07L(02MY).book Page 17 Monday, June 11, 2001 4:52 PM
Page 132 of 248

6-22
Interior Comfort
Audio System
Form No. 8Q42-EA-01F
Clock
Setting the time
The clock can be set at any time when the
ignition switch is in the ACC or ON
position.
1. To adjust the time, press the clock
button ( ) for about 2 seconds
until a beep is heard.
The clock ’s current time will flash.
2. To advance the hours, press the hour set button ( ). To advance the
minutes, press the minute set button
( ) while the time is flashing.
3. Press the clock button ( ) again to start the clock. Exact hour adjustment 1. To set the exact hour, press the clock
button ( ) for about 2 seconds
until a beep is heard.
The clock ’s current time will flash.
2. Press the clock button ( ) again and the time will be adjusted as
follows:
(Example)
12:01 —12:29
→12:00
12:30 —12:59
→1:00
Display Clock button
Hour set
button
Minute set
button
NOTE
If the power supply to the unit is
interrupted (if the fuse blows or the
vehicle ’s battery is disconnected), the
clock will need to be reset.
J07L(02MY).book Page 22 Monday, June 11, 2001 4:52 PM