2002 MAZDA MODEL MX-5 MIATA ignition

3-5
Knowing Your Mazda
Doors and Locks
Form No. 8Q42-EA-01F
This system locks and unlocks the doors
and opens the trunk.
It can also help you signal for attention in
an emergency.
Press the button slowly and accurately.
Keyless Entry System
To avoid damage to the transmitter, do
not:
•Drop it.
• Get it wet.
• Disassemble it.
• Expose it to heat or sunlight.
CAUTION
NOTE
•The keyless entry system is
designed to operate up to about 2.5
m (8 ft) from the center of the
vehicle, but this may vary because
of local conditions.
• The system doesn
’t operate when
the ignition switch is in the ON
position.
• If the transmitter does not operate
when pressing a button or the
operation range becomes too small,
the battery may be dead. To install a
new battery, refer to Maintenance
(page 3-7).
• Additional transmitters can be
obtained at an Authorized Mazda
Dealer. Up to 3 additional
transmitters can be used with the
keyless entry system per vehicle.
Bring all transmitters to an
Authorized Mazda Dealer when the
electronic codes need to be reset.
J07L(02MY).book Page 5 Monday, June 11, 2001 4:52 PM

3-9
Knowing Your Mazda
Doors and Locks
Form No. 8Q42-EA-01F

Service
If you have a problem with the keyless
entry system, consult an Authorized
Mazda Dealer.
If your transmitter is lost or stolen, bring
all remaining transmitters to an
Authorized Mazda Dealer as soon as
possible for a replacement and to make
the lost or stolen transmitter inoperative. The ignition switch must be in the ON
position for the power windows to
operate.
• Changes or modifications could
void your right to operate the
keyless entry system.
• Damage to your keyless entry
system will affect the vehicle
warranty coverage.
CAUTION
Power Windows
Closing Power Windows:
Closing power windows are
dangerous. A person
’s hands, head,
or even neck could be caught by the
window and result in serious injury or
even death.
This warning applies especially to
children. Make sure the opening is
clear before closing a window.
To prevent burning out the fuse and
damaging the power window system,
don ’t open or close more than two
windows at once.
WARNING
CAUTION
J07L(02MY).book Page 9 Monday, June 11, 2001 4:52 PM

3-18
Knowing Your Mazda
Doors and Locks
Form No. 8Q42-EA-01F
•To help prevent burglary or vandalism
and to ensure that the passenger
compartment stays dry, close the top
securely and lock all doors when
leaving the vehicle.
• Don
’t drive through an automatic car
wash; it may damage the top.
• Don
’t raise or lower the top when the
temperature is below 5 °C (41 ° F) ; this
will damage the top material.
• Don
’t lower the top when it ’s wet. If
the top dries while folded, it will
deteriorate and shrink.
• Lowering the top while it
’s wet can
also cause water to drip into the
passenger compartment.
• Don
’t raise or lower the top when the
wind is strong; the wind could damage
the top.

Lowering the Convertible Top
1. Park the vehicle on a level surface and
firmly set the parking brake.
2. Lower the side windows, then turn off the ignition.
3. Pull down the sunvisors.
4. Remove all objects in the top storage area. 5. Push the unlock buttons and fully
release the top latches.
6. Lift up on the front section of the top to release it from the windshield header.
Sunvisor Sunvisor
Objects in the Storage Area:
Putting heavy or sharp objects in the
top storage area is dangerous.
During a sudden stop or collision,
they can become projectiles that
might hit and injure passengers.
Don’t place heavy or sharp objects in
the top storage area.
WARNING
Unlock button
Top latch
Windshield header
J07L(02MY).book Page 18 Monday, June 11, 2001 4:52 PM

3-20
Knowing Your Mazda
Doors and Locks
Form No. 8Q42-EA-01F

Raising the Convertible Top
1. Park the vehicle on a level surface and
firmly set the parking brake.
2. Lower the side windows, then turn off the ignition.
3. Pull down the sunvisors.
4. Undo the fasteners and straps.
5. Remove the top covering and store it properly in the trunk.
6. Unlock the top latches and open them fully.
7. Hold the top lift handle and pull the top up and forward until it ’s against the
windshield header. 8. After securely hooking the top latches
onto the windshield header, push each
latch up with the palm of your hand
until the lock buttons click and the
latches are locked.
Sunvisor Sunvisor
Windshield header
Fastening Mechanisms:
It is dangerous to place your hands or
fingers near the fastening
mechanism. Your hands or fingers
could be caught and injured by the
mechanism. Always keep your hands
and fingers away from the fastening
mechanisms when moving the top.
Fastening Mechanisms:
It is dangerous to place your hands or
fingers near the fastening
mechanism. Your hands or fingers
could be caught and injured by the
mechanism. Always keep your hands
and fingers away from the fastening
mechanisms when moving the top.
WARNING
WARNING
J07L(02MY).book Page 20 Monday, June 11, 2001 4:52 PM

3-23
Knowing Your Mazda
Doors and Locks
Form No. 8Q42-EA-01F
•When removing the hardtop, make sure
objects inside the vehicle aren
’t blown
away by the wind.
• Secure all loose objects inside when
driving with the hardtop removed.
• Don
’t drive through an automatic car
wash; it may damage the hardtop.
• Don
’t remove or install the hardtop
when the wind is strong; the wind
could damage the hardtop.
• When removing the hardtop, make sure
the operation is performed by 2
persons.
• Before removing the hardtop, lower the
antenna.
• Removing the hardtop while it
’s wet
can cause water to drip into the
passenger compartment.

Removing the Detachable
Hardtop
1. Park the vehicle on a level surface and
firmly set the parking brake.
2. Lower the side windows, then turn off the ignition.
3. Pull down the sunvisors. 4. Push the unlock buttons and fully
release the top latches.
5. Push the unlock buttons and fully release the side latches.
6. Disconnect the rear window defroster coupler.
Sunvisor Sunvisor
Unlock button
Top latch
Unlock button
Side latch
Rear window defroster coupler
J07L(02MY).book Page 23 Monday, June 11, 2001 4:52 PM

3-25
Knowing Your Mazda
Doors and Locks
Form No. 8Q42-EA-01F

Installing the Detachable
Hardtop
1. Park the vehicle on a level surface and
firmly set the parking brake.
2. Lower the side windows, then turn off the ignition.
3. Pull down the sunvisors.
4. Unlock the top latches and the side latches on the hardtop.NOTE
Points to remember when storing the
detachable hardtop.
•Do not place the hardtop on a hard
surface, such as concrete or asphalt.
Place it on a cushioning material,
such as an old blanket.
• Be sure the top and side latches are
locked.
• Do not lean the hardtop against a
wall or stand it in an unstable way.
• Store the hardtop in a dry clean
area, and cover it with a soft
material, such as an old blanket.
Do not attempt to install the hardtop
with the top covering also installed.
Remove the top covering before
installing the hardtop, otherwise
damage will occur to the top covering.
NOTE
• Be sure to place the top latches in
the locked position.
• Make sure the convertible top is
completely lowered before
installing the hardtop. Also confirm
that the rear window defroster
coupler is disconnected.
CAUTION
Sunvisor
Sunvisor
Top latch assembly
Slide latch assembly
J07L(02MY).book Page 25 Monday, June 11, 2001 4:52 PM

3-28
Knowing Your Mazda
Form No. 8Q42-EA-01F
Security System
The immobilizer system allows the engine
to start only with a key the system
recognizes.
If someone attempts to start the engine
with an unrecognized key, the engine will
not start, thereby helping to prevent the
theft of your vehicle.

Immobilizer System Warning
Light
If the immobilizer system is working
properly, the light will come on when the
ignition switch is turned to the ON or
START position. The light will go out
when confirmation by the immobilizer
system is completed.
If the light flashes rapidly, fails to come
on, or comes on and stays on, it indicates
a system malfunction. If any of these
occur, contact an Authorized Mazda
Dealer as soon as possible.
Immobilizer System
Changes or modifications not
expressly approved by Mazda could
void the user
’s authority to operate the
equipment.
NOTE
This device complies with part 15 of
the FCC Rules and with RSS-210 of
Industry Canada. Operation is subject
to the following two conditions: (1)
This device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation. (Outside
transmissions may momentarily
interfere with the device ’s operation.)
CAUTION
J07L(02MY).book Page 28 Monday, June 11, 2001 4:52 PM

3-29
Knowing Your Mazda
Security System
Form No. 8Q42-EA-01F

Maintenance
If you have a problem with the
immobilizer system or the key, consult an
Authorized Mazda Dealer.
NOTE
• If the warning light comes on and
stays on when the ignition switch is
turned to the ON position, the
engine will not start.
• Signals from a TV or radio station,
or from a transceiver or a mobile
telephone, could interfere with your
immobilizer system. If you are
using the proper key and your
engine fails to start, check the
warning light. If it is flashing,
remove the ignition key and wait 2
seconds or more, then reinsert it and
try starting the engine again. If it
doesn
’t start after 3 or more tries,
contact an Authorized Mazda
Dealer.
• If the warning light flashes
continuously while you are driving,
don’
t shut off the engine. Go to an
Authorized Mazda Dealer and have
it checked. If you shut off the
engine while the light is flashing
you won ’t be able to restart it.
• To avoid damage to the key, do not:

Drop the key.
 Get the key wet.
 Expose the key to any kind of
magnetic field.
 Expose the key to high
temperatures on places such as
the dashboard or hood, under
direct sunlight.
• When starting the engine, do not let
the following materials touch the
key grip. The engine may not start:

Spare keys.
 Keys for other vehicles equipped
with an immobilizer system.
 Metal objects that touch or pass
through the hole in the key.
CAUTION
J07L(02MY).book Page 29 Monday, June 11, 2001 4:52 PM