2002 MAZDA MODEL 626 wiper blades

1-4
Your Vehicle at a Glance
Form No. 8Q50-EA-01G
Exterior Overview
Doors and keys
Outside mirrors
Headlights Fuel-filler lid
Child safety lock
Tires
Windshield wiper blades
Hood
Front-turn signal lights / Parking lights
Rear-turn signal lights
Brake lights / TaillightsPower windows
Rear window defroster
Trunk lid
High-mount brake lightLicense plate lights
Reverse lights
(page 3-14)
(page 3-5)
(page 8-22)
(page 3-9)
(page 8-30) (page 8-32) (page 3-21) (page 8-25)(page 3-2) (page 3-7)
(page 8-33) (page 8-33)
(page 8-33) (page 8-33) (page 3-10) (page 8-33) (page 5-35)
J94S.book Page 4 Saturday, June 23, 2001 1:04 PM

5-34
Driving Your Mazda
Switches and Controls
Form No. 8Q50-EA-01G
The ignition switch must be in the ON
position.





Windshield Wipers
Turn the wipers on by pulling the lever
down.
INT — Intermittent
1 — Normal
2 — Fast
Variable-speed intermittent wipers
Set the lever to INT and choose the
interval timing by rotating the ring.
Windshield Wipers and
Wa s h e r
Frozen Washer Fluid:Using windshield washer fluid in
freezing temperatures is dangerous.
The washer fluid could freeze on the
windshield and block your vision.
You could have an accident. Don ’t use
the washer without first warming the
windshield.
NOTE
Because heavy ice and snow can jam
the wiper blades, the wiper motor is
protected by a circuit breaker. This
mechanism will automatically stop
operation of the blades, but only for
about 5 minutes.
If this happens, turn off the wiper
switch and park off the right-of-way,
and remove the snow and ice.
After 5 minutes, turn on the switch and
the blades should operate normally. If
they don ’t resume functioning, consult
an Authorized Mazda Dealer as soon
as possible.
WARNING
OFF
INT 1
2
OFF INT
J94S.book Page 34 Saturday, June 23, 2001 1:04 PM

8-1
Form No. 8Q50-EA-01G
8Maintenance and Care
How to keep your Mazda in top condition.
Introduction ................................................................................. 8- 2
Introduction ............................................................................. 8- 2
Scheduled Maintenance .............................................................. 8- 3
Scheduled Maintenance ........................................................... 8- 3
Owner Maintenance .................................................................... 8- 7
Owner Maintenance Schedule ................................................. 8- 7
Owner Maintenance Precautions ............................................. 8- 8
Engine Compartment Overview .............................................. 8- 9
Engine Oil ................................................................................ 8-10
Engine Coolant ........................................................................ 8-13
Brake/Clutch Fluid .................................................................. 8-15
Power Steering Fluid ............................................................... 8-17
Automatic Transaxle Fluid (ATF) ........................................... 8-18
Washer Fluid ............................................................................ 8-20
Body Lubrication ..................................................................... 8-21
Air Filter .................................................................................. 8-21
Wiper Blades ........................................................................... 8-22
Battery ..................................................................................... 8-24
Tires ......................................................................................... 8-25
Light Bulbs .............................................................................. 8-29
Fuses ........................................................................................ 8-35
Appearance Care ......................................................................... 8-40
How to Minimize Environmental Paint Damage ..................... 8-40
Exterior Care ........................................................................... 8-42
Interior Care ............................................................................ 8-45
J94S.book Page 1 Saturday, June 23, 2001 1:04 PM

8-22
Maintenance and Care
Owner Maintenance
Form No. 8Q50-EA-01G
2. Lift off the air filter cover and remove the filter.
3. Wipe inside the air cleaner housing with a damp cloth.
4. Replace the filter.
5. Install in the reverse order of removal.
Replace the filter according to Scheduled
Maintenance (page 8-3). Contamination of either the windshield or
the blades with foreign matter can reduce
wiper effectiveness. Common sources are
insects, tree sap, and hot wax treatments
used by some commercial car washes.
If the blades are not wiping properly,
clean the window and blades with a good
cleaner or mild detergent; then rinse
thoroughly with clean water. Repeat if
necessary.





Replacing Windshield Wiper
Blades
When the wipers no longer clean well, the
blades are probably worn or cracked.
Replace them.
Air filter cover
Air filter
Wiper Blades
Hot waxes applied by automatic car
washes have been known to affect the
cleanability of windows.
To prevent damage to the wiper blades,
don’t use gasoline, kerosene, paint
thinner, or other solvents on or near
them.
To prevent damage to the wiper arms
and other components, don ’t move the
wipers by hand.
CAUTION
CAUTION
CAUTION
J94S.book Page 22 Saturday, June 23, 2001 1:04 PM

8-23
Maintenance and Care
Owner Maintenance
Form No. 8Q50-EA-01G
1. Raise the wiper arm and turn the blade assembly to expose the plastic locking
clip.
Compress the clip and slide the
assembly downward; then lift it off the
arm.
2. Hold the end of the rubber and pull until the tabs are free of the metal
support. 3. Remove the metal stiffeners from the
blade rubber and install them in new
blades.
To prevent damage to the windshield,
don’ t let the wiper arm fall on it.
Push
Plastic locking clip
CAUTION
Tabs pull out
Metal support
•
Don ’t bend the stiffeners. You need
to use them again.
• If the metal stiffeners are switched,
the blade’ s wiping efficiency could
be reduced.
So don’ t use the driver ’s side metal
stiffeners on the passenger ’s side, or
vice versa.
• Be sure to reinstall the metal
stiffeners in the new blade rubber so
that the curve is the same as it was
in the old blade rubber.
Stiffeners
CAUTION
J94S.book Page 23 Saturday, June 23, 2001 1:04 PM

11-6
Index
Form No. 8Q50-EA-01G
T
Trunk Release Handle ...................... 3-12
Turn and Lane-Change Signals
....... 5-33
V
Vanity Mirrors ................................. 6-44
Vehicle Information Labels
............. 10-2
W
Warning Lights ................................ 5-23
ABS
.......................................... 5-28
Air bag system
.......................... 5-28
Brake system
............................ 5-25
Charging system
....................... 5-26
Check engine
............................ 5-27
Door-ajar
................................... 5-28
Engine oil pressure
................... 5-26
Immobilizer system
.................. 5-29
Low fuel
.................................... 5-27
Low washer fluid level
............. 5-27
Seat belt
.................................... 5-25
TCS
........................................... 5-27
Warranty
............................................ 9-8
Washer Fluid
.................................... 8-20
Weights
............................................ 10-5
Wheel Replacement
......................... 8-28
Windows Power windows
.......................... 3-7
Windshield Washer
.......................... 5-35
Windshield Wipers
.......................... 5-34
Blades replacement
................... 8-22
Winter Driving
................................... 4-9
J94S.book Page 6 Saturday, June 23, 2001 1:04 PM