H–6
CLUTCH UNIT
Clutch Cover and Disc Removal Note
1. Install the SSTs.
2. Loosen each bolt one turn at a time in a crisscross pattern until spring tension is released.
3. Remove the clutch cover and disc.
Flywheel Removal Note
1. Hold the flywheel using the SST.
2. Remove the bolts evenly and gradually in a crisscross pattern.
3. Remove the flywheel.
Flywheel Installation Note
1. Install the flywheel to the crankshaft.
2. When reusing the bolts, clean threads and hole, then apply locking compound to the threads.
Note
•No locking compound is needed when using new bolts.
3. Hand-tighten the flywheel lock bolts.
4. Install the SST to the flywheel.
5. Gradually tighten the flywheel lock bolts in a
crisscross pattern.
Tightning torque
151.3—161.1 N·m
{15.43—16.42 kgf·m, 111.6—118.8 ft·lbf}
49 SE01 310A
49 E011 1A0
A6E4920W011
49 E011 1A0
5
4
3
61
2
8
7
A6E4920W012
49 E011 1A0
5
4
3
61
2
8
7
A6E4920W013
CLUTCH UNIT
H–7
H
Clutch Disc Installation Note
1. Hold the clutch disc position using the SST.
Clutch Cover Installation Note
1. Install the SSTs.
2. Tighten the bolts evenly and gradually in a
crisscross pattern.
Tightening torque
25—33 N·m {2.6—3.3 kgf·m, 19—24 ft·lbf}
End Of SieCLUTCH COVER INSPECTION (A65M-R MANUAL TRANSAXLE MODELS)A6E4920164102011. Measure the wear of the diaphragm spring
fingers.
•If not as specified, replace the clutch cover.
Depth
0.6 mm {0.024 in} max.
2. Measure the flatness of the pressure plate with a
straight edge and a feeler gauge.
•If not as specified, replace the clutch cover.
Maximum clearance
0.3 mm {0.012 in}
3. When checking the diaphragm spring fingers,
mount a dial indicator on the cylinder block.
49 SE01 310A
A6E4920W014
5
4
3
49 SE01 310A
49 E011 1A06
1
2
A6E4920W015
XME4920W010
XME4920W011
