Page 160 of 378

COMFORT ADJUSTMENT
147
SV16044
Move seat fully back
CAUTION
A forward±facing child restraint system should be
allowed to be put on the front seat only when it is
unavoidable. Always move the seat as far back as
possible, because the force of the deploying front
passenger airbag could cause death or serious injury
to the child.
On vehicles with side airbags and curtain shield
airbags, do not allow the child to lean over the front
door or around the front door even if the child is
seated in a child restraint system. It is dangerous if
the side and curtain shield airbags inflate, because
the impact could cause death or serious injury to the
child.
SV16045
1. Sit the child on a booster seat. Run the lap and shoulder
belt through or around the booster seat and child following the
instructions provided by its manufacturer and insert the tab into
the buckle.
Make sure the shoulder belt is correctly across the child's
shoulder and that the lap belt is positioned as low as possible
on child's hips. See ºSeat beltsº on page 109 for details.
CAUTION
Always make sure the shoulder belt is positioned
across the center of child's shoulder. The belt s hould
be kept away from child's neck, but not falling off
child's shoulder. Failure to do so could reduce the
amount of protection in an accident and cause
serious injuries in a collision.
Page 161 of 378
COMFORT ADJUSTMENT
148
Both high±positioned lap belts and loose±fitting
belts could cause serious injuries due to sliding
under the lap belt during a collision or other
unintended result. Keep the lap belt positioned as
low on a child's hip as possible.
For child's safety, do not place the shoulder belt
under child's arm.
After inserting the tab, make sure the tab and buckle
are locked and that the lap and shoulder portions of
the belt are not twisted.
Do not insert coins, clips, etc. in the buckle as this
may prevent your child from properly latching the tab
and buckle.
If the seat belt does not function normally,
immediately contact your Lexus dealer. Do not use
the child restraint seat until the seat belt is fixed. It
cannot protect your child from injury.
SV16056
2. To remove the child restraint system, press the
buckle±release button and allow the belt to retract.
Page 162 of 378
COMFORT ADJUSTMENT
149
Using a top strap (Sedan)
SV16047
Follow the next procedure for a child restraint system that
requires the use of a top strap.
SV16072
Anchor brackets
Use the anchor bracket on the filler panel behind the rear seat
to attach the top strap.
Anchor brackets are installed for each rear seating position.
Page 163 of 378
COMFORT ADJUSTMENT
150
SV16062
Center seat position
1. Lower the head restraint.
2. Fix the child restraint system with the seat belt.
3. Latch the hook onto the anchor bracket and tighten the
top strap.
For instructions to install the child restraint system, see ºType
of child restraint systemº on page 137.
CAUTION
Make sure the top strap is securely latched, and
check that the child restraint system is secure by
pushing and pulling it in different directions.
Follow all the installation instructions provided by its
manufacturer.
SV16118
Side seat position
1. Remove the head restraint.
Page 164 of 378
COMFORT ADJUSTMENT
151
SV16153
2. Fix the child restraint system with the seat belt.
Latch the hook onto the anchor bracket and tighten the
top strap.
For instructions to install the child restraint system, see ºChild
restraint systemº on page 135.
CAUTION
Make sure the top strap is securely latched, and
check that the child restraint system is securely by
pushing and pulling it in different directions.
Follow all the installation instructions provided by its
manufacturer.
SV16119
3. Replace the head restraint.
Page 165 of 378
COMFORT ADJUSTMENT
152INSTALLATION WITH CHILD RESTRAINT LOWER
ANCHORAGES
SV16100
The lower anchorages for the child restraint system
interfaced with the FMVSS225 specification are installed
in the rear seat.
The anchorages are installed in the clearance between the
seat cushion and seatback of both outside rear seats.
Child restraint system interfaced with the FMVSS225
specification
can be fixed with these anchorages. In this case,
it is not necessary to fix the child restraint system with a seat
belt on the vehicle.
SV16136
Type A
Page 166 of 378
COMFORT ADJUSTMENT
153
SV16137
Type B
CHILD RESTRAINT SYSTEM INSTALLATION
Type A:
1. Widen the clearance between the seat cushion and
seatback a little and confirm the position of the lower
anchorages below the tag in the seatback.
2. Latch the hooks of lower straps onto the anchorages
and tighten the lower straps.
Type B:
1. Widen the clearance between the seat cushion and
seatback a little and confirm the position of the lower
anchorages below the tag in the seatback.
2. Latch the buckles onto the anchorages.
If your child restraint system has a top strap, it should be
anchored. (For the installation of the top strap, see ºUsing a top
strapº on page 149 in this section.)
For the installation details, refer to the instruction manual
equipped with each product.
Page 167 of 378
COMFORT ADJUSTMENT
154
CAUTION
When using the lower anchorages for the child
restraint system, be sure that there are no irregular
objects around the anchorages or that the seat belt is
not caught.
Push and pull the child restraint system in different
directions to be sure it is secure. Follow all the
installation instructions provided by its
manufacturer.
Do not put a child restraint system on the rear seat if
it interferes with the lock mechanism of the front
seats. This can cause severe injury to the child and
front passenger in case of sudden braking or a
collision.
Using a top strap (SportCross: Type A)
SV16109
Follow the next procedure for a child restraint system that
requires the use of a top strap.