2002 Lancia Ypsilon weight

96
G
Never fit a standard tyre to a rim
to be used for the space-saver
spare wheel. Have the punctured
tyre repaired and fitted back on as
soon as possible.
No more than one space-saver
spare wheel must be used at the
same time.
Do not grease the bolt threads be-
fore fitting them, they could un-
screw themselves.
The jack must only be used to
change wheels on the vehicle with
which it is supplied or on vehicles
of the same model. All other uses,
for example raising other vehicles,
must be excluded. Under no cir-
cumstances use the jack to carry
out repairs under the vehicle.
If the jack is not used correctly,
the raised vehicle may fall.Do not use the jack to lift weights
above that indicated on the label
attached to the jack itself.
Never start the engine while the
car is raised by the jack. If travel-
ling with a trailer, detach the
trailer before raising the car.
Snow chains cannot be fitted to
the spare wheel, consequently if a
front tyre is punctured (front drive)
and snow chains need to be fitted,
a standard wheel must be removed
from the back axle and the space-
saver spare wheel fitted in its
place. In this way there will be two
standard wheels on the front and
the snow chains can be fitted.
Incorrect fitting of the wheel hub
could result in the hub coming off
when the vehicle is travelling.Never tamper with the inflation
valve.
Do not insert any type of tool be-
tween the rim and the tyre.
Periodically check the tyre pres-
sure including that of the spare-
saver spare wheel as per the val-
ues given in “Technical Specifica-
tions”.
fig. 3
P4C00401
fig. 2
P4C00400
4C090-119 ING 11-03-2008 12:00 Pagina 96

114
fG
WITH A SHOP JACK
Front end
The car may only be raised by plac-
ing the jack arm under the transaxle,
with a block of wood or rubber as il-
lustrated in (fig. 38).IF THE CAR NEEDS
TO BE RAISED
WITH THE JACK
See “If a tyre is punctured”, in this
section.
The jack should only be
used to change a wheel on
the vehicle with which it is
supplied or on vehicles of the same
model. All other uses, for example
raising other vehicles, must be ex-
cluded. Under no circumstances
use the jack to carry out repairs
under the vehicle.
If the jack is not used
correctly, the raised vehi-
cle may fall. Do not use the
jack to lift weights above that in-
dicated on the label attached to the
jack itself.
It must be remembered that:
– the jack does not require adjust-
ments;
– the jack cannot be repaired. If it
breaks, it must be changed with an-
other new jack;
– only the jack handle described in
the chapter “If a tyre is punctured”
can be fitted onto the jack.
fig. 38
P4C00393
4C090-119 ING 13-03-2008 12:51 Pagina 114

TECHNICAL SPECIFICATIONS
Motor and engineering enthusiasts as well as
those “in the trade” will probably start reading
from this point in the manual. This, in fact, is
where a section jam-packed with facts, figures,
formulae, measurements and tables begins. In a
sense, it is the Lancia Y’s identity card.
A document that introduces the car and explains
in technical jargon all the features that go together
to make it a model designed to give you superla-
tive driving satisfaction.VEHICLE IDENTIFICATION DATA ............... 145
ENGINE CODE - BODY VERSIONS............... 146
ENGINE......................................................... 147
TRANSMISSION............................................. 150
BRAKES......................................................... 151
SUSPENSION ................................................. 152
STEERING..................................................... 152
WHEELS........................................................ 153
WHEEL GEOMETRY ..................................... 155
ELECTRICAL SYSTEM ................................. 155
PERFORMANCE............................................ 156
WEIGHTS...................................................... 157
DIMENSIONS................................................. 158
CAPACITIES .................................................. 160
TYRE PRESSURE .......................................... 163
FLUIDS AND LUBRICANTS .......................... 164
FUEL CONSUMPTION -
CO
2EMISSIONS ............................................. 166
144
G
4C144-167 ING 11-03-2008 12:02 Pagina 144

145
G
VEHICLE
IDENTIFICATION
DATA
CHASSIS MARKING (fig. 1)
This is stamped on the passenger
cabin floor, near the front right seat.
It can be reached by lifting the flap
in the carpet, and it bears:
– vehicle model .........ZLA 840000
– chassis serial number.ENGINE MARKING
The marking is stamped on the
cylinder block and includes the model
and serial number.
MODEL PLATE (fig. 2)
The plate (fig. 2)is applied to the
front cross member of the engine
compartment(fig. 3).
The plate bears the following iden-
tification data:
A- Manufacturer’s name.
B- Homologation number.C- Vehicle ID code.
D- Chassis serial number.
E- Maximum fully-laden vehicle
weight.
F- Maximum train weight of the
fully-laden vehicle plus trailer.
G- Maximum vehicle weight on first
(front) axle.
H- Maximum vehicle weight on sec-
ond (rear) axle.
I- Engine type.
L- Body version code.
M- Number for spares.
fig. 1
P4C00010
fig. 2
P4C00145
ffig. 3
P4C00415
4C144-167 ING 11-03-2008 12:02 Pagina 145

157
G
WEIGHTS
Weights (kg)
Kerb weight
(including fuel, spare, tools and accessories):
Payload (1) including the driver:
Maximum loads permitted (2)
– front axle:
– rear axle:
– total:
Maximum load on the roof (3):
Towable weight
– trailer with brakes:
– trailer without brakes:
Maximum load on the ball joint
(trailer with brakes):1.2
16V
910
480
750
750
1390
50
900
400
70 1.2
860
470
750
750
1330
50
900
400
70
(1) If special equipment is fitted (sunroof, air conditioner, tow hitch etc.) the unladen weight increases, thus reducing the payload as specified in the max-
imum loads allowed.
(2) Loads not to be exceeded: the driver must arrange the goods in the boot and/or load surface so that they comply with these limits.
(3) Including the weight of the roof rack.
4C144-167 ING 11-03-2008 12:02 Pagina 157

180
fdG
Three-way catalytic converter . 4
Tools ....................................... 96
Top speeds .............................. 156
Towing a trailer
– tow hitch installation ... 172-174
– warnings .......................... 84
Towing the car ........................ 116
Transmission ratios ................. 150
Transporting children in safety 26
Tyre pressure .............. 74-136-163
Tyres...................... 74-94-136-153
Useful accessories .................. 89
Ventilation ........................... 39
Warning lights
– ABS anti-locking system
failure................................ 35
– airbag failure ..................... 34
– brake light failure .............. 36
– direction indicators ............ 36
– doors not closed properly ... 34
– EOBD self-diagnostic
system ............................... 35
– external lights .................... 36
– handbrake on ................... 34
– hazard lights...................... 35
– Lancia CODE ................... 35
– low battery recharging ....... 34
– low brake fluid .................. 34Warning lights
– low engine oil pressure....... 34
Warning lights
– main beam headlights........ 36
– passenger airbag off .......... 36
Washer fluid level.................... 129
Washer nozzles ........................ 139
Weights ................................... 157
Wheel
– replacing a wheel ............... 94
– spare ........................... 96-154
Wheel geometry (toe-in) ......... 155
Wheel rims .............................. 153
Windows (cleaning )................ 142
Windows (rear) ....................... 47
Windscreen washer
– control .............................. 42
– fluid level ......................... 129
Windscreen wiper
– control ............................. 42
– blades ................................ 138
Windscreen wiper
– nozzles............................... 139
Wiper blades ........................... 138
4C177-184 Indice ING 13-03-2008 13:31 Pagina 180