2002 JEEP GRAND CHEROKEE wheel

[x] Cancel search: wheel

Page 633 of 2199

JEEP GRAND CHEROKEE 2002 WJ / 2.G Workshop Manual REMOVAL
The washer fluid level switch can be removed from
the washer reservoir without removing the reservoir
from the vehicle.
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the on

Page 634 of 2199

JEEP GRAND CHEROKEE 2002 WJ / 2.G Workshop Manual WASHER RESERVOIR
DESCRIPTION
A single washer fluid reservoir is used for both the
front and rear washer systems (Fig. 22). The molded
plastic washer fluid reservoir is concealed between
the left front

Page 635 of 2199

JEEP GRAND CHEROKEE 2002 WJ / 2.G Workshop Manual (3) Disconnect the two washer reservoir washer
hoses from the two engine compartment washer
hoses at the inline connectors located on the top of
the left front fender wheel house (Fig. 23).
(4) Open t

Page 636 of 2199

JEEP GRAND CHEROKEE 2002 WJ / 2.G Workshop Manual (6) Install and tighten the two screws that secure
the inboard mounting flange of the washer reservoir
to the left inner wheel house. Tighten the screws to
7.4 N´m (66 in. lbs.).
(7) Reconnect the le

Page 640 of 2199

JEEP GRAND CHEROKEE 2002 WJ / 2.G Workshop Manual REAR WIPERS/WASHERS
TABLE OF CONTENTS
page page
REAR WIPERS/WASHERS
DESCRIPTION.........................33
OPERATION...........................34
DIAGNOSIS AND TESTING - REAR WIPER &
WASHER SYSTEM....

Page 641 of 2199

JEEP GRAND CHEROKEE 2002 WJ / 2.G Workshop Manual ²Washer Reservoir- The rear washer system
shares a single reservoir with the front washer sys-
tem, but has its own dedicated washer pump/motor
and plumbing. The washer reservoir is concealed
between

Page 642 of 2199

JEEP GRAND CHEROKEE 2002 WJ / 2.G Workshop Manual stalk is moved to the rear Wash position, the Wash
position circuitry within the switch directs battery
current to the rear washer pump/motor unit, and to
both the rear wiper motor control and rear wa

Page 643 of 2199

JEEP GRAND CHEROKEE 2002 WJ / 2.G Workshop Manual (run-acc) circuit between the right multi-function
switch and the JB as required.
(7) Turn the ignition switch to the Off position.
Disconnect and isolate the battery negative cable.
Test the right mu