2002 ISUZU AXIOM tailgate

8H±14SECURITY AND LOCKS
Anti-Theft System
General Description
The circuit consists of the starter switch, anti±theft &
keyless entry controller, anti±theft horn, front door and
tailgate key switch (detect and tamper) switch, door lock
actuator for each door, engine hood switch, clutch start
switch (M/T), ANTI±THEFT indicator light and mode
switch (A/T).
The system operates as follows: After locking the starter
switch and removing the starter key (this sets the alarm),
if the door is unlocked in any way other than with the
proper key, the headlights will start flashing, the horn
sounds, and the starter circuit is disabled. (However, the
engine hood and all the doors must be locked and closed.)
Once the system has been placed in the warning or alarm
condition, it can be released only when the starter switch
is shifted from ªOFFº to ªACCº by the starter key, or when
the lock of the front door or the tailgate is released (to
activate the detect switch) by the starter key.
Anti±Theft & Keyless Entry Control-
ler
Removal
1. Disconnect the battery ground cable.
2. Remove the glove box from the instrument panel
assembly (1).

Refer to
the Instrument Panel Assembly in Body
Structure section.
3. Remove the anti±theft & keyless entry controller (2).

Disconnect the connector.

Remove two fixing screws.
826RW007
Installation
To install, follow the removal steps in the reverse order.
Anti±Theft Indicator
Removal and Installation
Refer to GPS in Entertainment section.
Anti±Theft Horn
Removal
1. Disconnect the battery ground cable.
2. Remove the anti±theft horn (1).

Disconnect the connector.

Remove a fixing bolt.
828RW001
Installation
To install, follow the removal steps in the reverse order.

EXTERIOR/INTERIOR TRIM8J±9
Interior Trim Panels
Interior Trim Panels and Associated Parts
643R200003
Legend
(1) Assist Grip (Front & Rear)
(2) Door Finisher (Front & Rear)
(3) Upper Quarter Pillar Trim Cover
(4) Upper Rear Pillar Trim Cover
(5) Rear Roof Trim Cover
(6) Tailgate Weather Strip
(7) Multi Hook(8) Rear End Floor Trim Cover
(9) Lower Quarter Trim Cover
(10) Sill Plate (Front & Rear)
(11) Lower Center Pillar Trim Cover
(12) Upper Center Pillar Trim Cover
(13) Dash Side Trim Cover
(14) Front Pillar Trim Cover
Removal
1. Disconnect the battery ground cable.
2. Remove the sill plates (Front & Rear).
3. Remove the dash side trim cover.
4. Remove the lower center pillar trim cover.

Remove the lower anchor bolt cover and lower
anchor bolt from the front seat belt.

Pry the trim cover with the clips from the body panel.
5. Remove the door finishers (Front & Rear).

8J±10EXTERIOR/INTERIOR TRIM
6. Remove the upper center pillar trim cover.

Remove the cover (1) and screw.

Remove the shoulder anchor cap (2) and upper
anchor bolt (3) from the front seat belt.

Pry the trim cover with the clip from the body panel.
760R200006
7. Remove the front pillar trim cover.

Ply the trim cover with the clips from the body panel.
8. Remove the tailgate weather strip.
9. Remove the rear end floor trim cover.

Remove the four screw cover and nine fixing
screws.
10. Remove the rear roof trim cover.

Pry the trim cover with the clips from the body panel.
11. Remove the tonneau cover assembly (1).
643R200001
12. Remove the multi hooks.

While raising the notch of the hook with the
screwdriver, pull out the hook by turning 180
.
643R200004
13. Remove the lower quarter trim cover (1).

Remove the lower anchor bolt cover (4) and the
lower anchor bolt (3) from the rear seat belt.

Pull the trim cover at the five clip positions (2).

Disconnect the accessory socket connectors (LH
side).
643R200006
14. Remove the upper quarter pillar trim cover (1).

Remove the cover and screw, pull the trim cover at
the two clip positions (2).

Remove the shoulder anchor cap (4) and upper
anchor bolt (3) from the rear seat belt.

8J±20EXTERIOR/INTERIOR TRIM
Power Door Mirror System
General Description
The system consists of the starter switch, door mirror
switch, rear defogger/mirror defogger switch and door
mirrors on both sides.
When the door mirror switch is operated with the starter
switch at either ªACCº or ªONº position, the motor in the
door mirror (on either side) rotates to allow the horizontal
and vertical adjustment of mirror angles.
When the rear defogger/mirror defogger switch is turned
ªONº with the starter switch ªONº, the heater of the left
and right mirrors and the tailgate glass are activated.
Door Mirror Switch
Removal
1. Disconnect the battery ground cable.
2. Remove the instrument panel lower cover (2).
Refer to the
Instrument Panel Assembly in Body
Structure section.
3. Remove the door mirror switch (1).
825RW094
Rear Defogger/Mirror Defogger Switch
Refer to the Rear Defogger/Mirror switch removal and
installation steps in Lighting System section.
Door Mirrors
Refer to Door Mirror Assembly in this section.

SEAT BELT SYSTEM9A±5
Rear Seat Belt
Rear Seat Belt and Associated Parts
760R200017
Legend
(1) Adjustable Shoulder Anchor Assembly
(2) Upper Quarter Pillar Trim Cover
(3) Seat Belt Upper Anchor Bolt
(4) Shoulder Anchor Cap
(5) Rear Seat Belt Assembly
(6) Tailgate Weather Strip(7) Rear End Floor Trim Cover
(8) Lower Quarter Trim Cover
(9) Anchor Cover
(10) Seat Belt Lower Anchor Bolt
(11) Rear Sill Plate
(12) Retractor
(13) Rear Door Seal Finisher
Removal
1. Disconnect the battery ground cable.
2. Remove the tailgate weather strip.
3. Remove the rear end floor trim cover.
4. Remove the rear sill plate.
5. Remove the anchor cover and the lower anchor bolt.
6. Remove the lower quarter trim cover.

Refer to Interior Trim Panel in Exterior/Interior Trim
section.
7. Remove the seat belt upper anchor bolt (3).

Remove the shoulder anchor cap (4).