2002 Hyundai Getz warning

FEATURES OF YOUR HYUNDAI 1- 13
HTB026
HTB024
B080A01FC-GAT ADJUSTABLE SEATS B080B01FC-GAT FRONT SEATS Adjusting Seat Forward andRearward
To move the seat toward the front or rear, pull the lock release lever up-ward. This will release the seat on itstrack so you can move it forward orrearward to the desired position. When you find the position you want, release the lever and slide the seat forward orrearward on its track until it locks intothe desired position and cannot bemoved further.
WARNING:
1) Be careful that someone's head, hands and body are not trappedby a closing window.
2) Never try to operate the main switch on the driver's door andthe individual door window switch in opposing directions at the same time. If this is done, thewindow will stop and cannot beopened or closed.
3) Do not leave children alone in the
car. Always remove the ignition key for their safety.
!
!WARNING:
Never attempt to adjust the seat while the vehicle is moving. This could result in loss of control, or an accident which may cause death,serious injury, or property damage.
B080C01A-AAT Adjusting Seatback Angle

1- 14 FEATURES OF YOUR HYUNDAI
HTB027
B080E01O-AAT Lumbar Support Control
(Driver's Seat Only) (If Installed)
HFC2028
Lock knob
To recline the seatback, lean forward to take your weight off it, then pull upon the recliner control lever at theoutside edge of the seat. Now leanback until the desired seatback angle is achieved. To lock the seatback into position, release the recliner controllever. B080D02A-AAT Adjustable Headrests Headrests are designed to help re- duce the risk of neck injuries.To raise the headrest, pull it up. To lower it, push it down while pressing the lock knob.
WARNING:
To minimize risk of severe injury inthe event of a collision or a sudden stop, both the driver and passen- ger seatbacks should always be inan upright position while the ve-hicle is in motion. The protectionprovided by the seat belts andairbags may be reduced significant- ly when the seatbacks are reclined. There is greater risk that the driverand passenger will slide under theseat belt which may result in seri-ous injury if a crash occurs whenthe seatbacks are reclined. The seat belt cannot provide full protection to an occupant if the seat back isreclined.
!
o Do not operate the vehicle with the headrests removed as severe injury to an occupant may occurin the event of an accident. Head-rests may provide protectionagainst severe neck injuries whenproperly adjusted.
!WARNING:
o For maximum effectiveness in case of an accident, the headrest should be adjusted so the top of the headrest is at the same heightas the top of the occupant's ears.The use of a cushion that holdsthe body away from the seatbackis not recommended.
To adjust the lumbar support, turn the handle on the outboard or left side ofthe seat. To increase the amount oflumbar support, pull the lever forward.To decrease it, push the lever toward the rear.

FEATURES OF YOUR HYUNDAI 1- 15
HTB025
B080F01S-AAT Seat Cushion Height Adjustment (Driver's Seat Only) (If Installed) To raise or lower the front part of the seat cushion, turn the front knob for-ward or rearward. To raise or lower the rear part of the seat cushion, turn the rear knob forward or rearward. B130A01A-AAT REAR SEAT ENTRY (For 3-door model) The front passenger seatback should be tilted to enter the rear seat.By pulling up on the recliner control lever (1) at the outside of the front passenger seat, the seatback will tiltforward and the seat will automaticallyslide forward.Rear seat occupants can tilt the frontpassenger seatback by depressing the foot lever (2) as shown in the illustra- tion. WARNING:
Passengers sitting in the rear seatshould be careful not to acciden- tally press the foot lever (2) while the vehicle is moving, as this maycause the seatback to move for-ward and injure a front seat occu-pant.
HTB258
!
HTB028
Seatback folding lever
B080I01FC-GAT REAR SEAT Adjusting Seatback Angle
(1)
(2)

1- 16 FEATURES OF YOUR HYUNDAI
Lock Knob
B090A01FC-GAT Adjustable Headrests
(If Installed) Headrests are designed to help re- duce the risk of neck injuries.To raise the headrest, pull it up. To lower it, push it down while pressing the lock knob.
To recline the seatback, push theseatback folding lever toward the head-rest, and release it after the desiredseatback angle is achieved.When you recline the seatback to de- sired position, always be sure it has locked into position.
CAUTION:
When reclining the seatback angle,you should be adjust the seatbackfolding lever with standing.
!
HFC2028WARNING:
o For maximum effectiveness in case of an accident, the headrest should be adjusted so the top ofthe headrest is at the same height as the top of the occupant's ears.
The use of a cushion that holdsthe body away from the seatbackis not recommended.
o Do not operate vehicle with the headrests removed as severe in- jury to an occupant may occur in the event of an accident. Head-rests may provide protectionagainst severe neck injuries whenproperly adjusted.
!

1- 18 FEATURES OF YOUR HYUNDAI
WARNING:
o When you return the folded down seatback to its upright position, make sure the seat belts are inposition to be accessible and to function properly.
o When you return the folded down seatback to its upright position, be careful not to get your fingersor legs in.
o The purpose of the fold down rear seatback and the fold for-ward rear seat cushion is to in-crease cargo space. Do not allowpassengers to sit in the cargoarea while the car is moving. Thisis not a proper seating position and no seat belts are available for use when the seatback isfolded down. Passengers whoare not properly seated and wear-ing seat belts could sustain seri-ous injuries or death in case of an accident or a sudden stop.
3. A Type: Pull the seat cushion re-
lease handle rear ward, then lift up the entire seat cushion.B Type: Pull the seat cushion re-lease handle rear ward, then lift upa desired seat cushion.
A Type B Type 4. To secure the seat, hook the secur-
ing strap under the seat back to the headrest stay of front driver andpassenger seat.
5. To return the seatback and seat cushion to its normal position, re-verse the above procedure.
o When you return the seatback to its
upright position, always be sure it islocked into position by pulling andpushing on the top of seatback.
HTB030
Seat cushion release handle
HTB030A
Seat cushion release handle
HTB031Securing strap
!
Securing Strap Securing Strap

FEATURES OF YOUR HYUNDAI 1- 19
B100A01FC-GAT SEAT WARMER (If Installed)
The seat warmer is provided to warm the front seats during cold weather.When the engine is running, push ei- ther of the switches to warm the driver's seat or the passenger's seat.During mild weather or under condi-tions where the operation of the seatwarmer is not needed, keep theswitches in the "OFF" position.
o Objects should not extend higher
than the top of the frontseatbacks. This could allow cargoto slide forward and cause injuryor damage during sudden stops.
o When you return the folded down
seatback to its upright position, always be sure to install the head- rests in their proper positions.Headrests are important to thesafety of occupants in a rear col-lision. If the headrests are notinstalled in their proper position, serious injury or death could re- sult if a rear end collision occurs.
HTB194HTB195
B140A01B-GAT REAR SEAT WARNING For the safety of all passengers, lug- gage or other cargo should not be piledhigher than the top of the seatback.

FEATURES OF YOUR HYUNDAI 1- 21
B150G01A-AAT Do Not Lie Down To reduce the chance of injuries in the event of an accident, and to achievemaximum effectiveness of the restraintsystem, all passengers should be sit-ting up and the front seats should be in an upright position when the car is moving. A seat belt cannot provideproper protection if the person is lyingdown in the rear seat or if the front seatis in a reclined position. would be applied there, not at yourpelvic bones.This could cause serious internalinjuries.For proper protection when the ve-hicle is in motion, have the seatback upright. Then sit back in the seat and wear your seat belt properly. Seepage 1-22. B160A01A-AAT CARE OF SEAT BELTS Seat belt systems should never be disassembled or modified. In addition,care should be taken to assure thatseat belts and belt hardware are notdamaged by seat hinges, doors or other abuse.
WARNING:
Sitting in a reclined position or ly- ing down when your vehicle is inmotion can be dangerous. Even if you buckle up, your seat belts can't do their job when you're reclined.The shoulder belt can't do its jobbecause it won't be against yourbody. Instead, it will be in front ofyou. In a crash you could go into it with great force, receiving serious neck or other injuries.The lap belt can't do its job either. Ina crash the belt could go up overyour abdomen. The belt forces
!
WARNING:
When you return the rear seatback to its upright position after the rearseatback was folded down, be care-ful not to damage the seat belt web-bing or buckle. Be sure that thewebbing or buckle does not get caught or pinched in the rear seat.!
B160B01A-AAT Periodic Inspection It is recommended that all seat belts be inspected periodically for wear ordamage of any kind. Parts of the sys-tem that are damaged should be re-placed as soon as possible. B160C01A-AAT Keep Belts Clean and Dry Seat belts should be kept clean and dry. If belts become dirty, they can becleaned by using a mild soap solution and warm water. Bleach, dye, strong detergents or abrasives should not beused because they may damage andweaken the fabric. B160D01A-AAT When to Replace Seat Belts Entire in-use seat belt assembly or assemblies should be replaced if the vehicle has been involved in an acci- dent. This should be done even if nodamage is visible. Additional ques-tions concerning seat belt operationshould be directed to your HyundaiDealer.

1- 22 FEATURES OF YOUR HYUNDAI
B180A02A-GAT SEAT BELTS 3-Point System with Emergency Locking Retrac-
tor (If Installed)To Fasten Your Belt
B180A01L
To fasten your seat belt, pull it out of the retractor and insert the metal tab into the buckle. There will be an au-dible "click" when the tab locks into thebuckle.The seat belt automatically adjusts tothe proper length only after the lap belt is adjusted manually so that it fits snugly around your hips. If you leanforward in a slow, easy motion, the beltwill extend and let you move around. Ifthere is a sudden stop or impact, how-ever, the belt will lock into position. It
B170A04A-AAT HEIGHT ADJUSTABLE FRONT SEAT SHOULDER BELT (If Installed)
B170A01L
You can adjust the height of the shoul- der belt anchor to one of the 4 posi-tions.If the height of the adjusting seat belt istoo near your neck, you will not begetting the most effective protection. The shoulder portion should be adjusted so that it lies across yourchest and midway over your shouldernearest the door and not your neck.To adjust the height of the seat beltanchor, lower or raise the height ad- juster into an appropriate position. To raise the height adjuster, pull it up. To lower it, push it down while pressingthe height adjuster button.Release the button to lock the anchorinto position. Try sliding the releasebutton to make sure that it has locked into the position.
WARNING:
o The height adjuster must be in the locked position when the vehicle is moving.
o The misadjustment of height of the shoulder belt could reducethe effectiveness of the seat beltin a crash.
!