2002 HONDA S2000 bulb

The lef t or right turn signal light
blinks when you signal a lane change
or turn. If the light does not blink or
blinks rapidly, it usually means one
of the turn signal bulbs is burned out
(see page ). Replace the bulb as
soon as possible, since other drivers
cannot see that you are signalling.
This light comes on with the high
beam headlights. See page for
inf ormation on the headlight
controls.This indicator lights when you turn
the ignition switch to ON (II) with
the headlight switch of f and the
parking brake set. It should go of f if
youturnontheheadlightsorrelease
the parking brake. If it comes on at
any other time, it means there is a
problem with the DRL. There may
also be a problem with the high
beam headlights.
This indicator comes on f or a f ew
seconds when you turn the ignition
switch ON (II). It will then go of f if
you have inserted a properly-coded
ignition key. If it is not a properly-
coded key, the indicator will blink
and the engine will not start (see
page ).
WhenyouturnontheHazard
Warning switch, both turn signal
lights blink. All turn signals on the
outside of the car should f lash. This indicator also blinks several
times when you turn the ignition
switch f rom ON (II) to ACCESSORY
(I) or LOCK (0).
This light comes on as a reminder
that you must ref uel soon.
This lights when you set the cruise
control. See page f or inf ormation
on operating the cruise control.
51 55
198
57
Canadian models only
Indicator L ights
Inst rument s and Cont rolsTurn Signal and
Hazard Warning
Indicators
High Beam Indicator ‘‘Daytime Running
Lights’’ Indicator
Immobilizer System
Indicator
Low Fuel Indicator
Cruise Control Indicator
46

The interior light has a three-
position switch. In the OFF position,
the light does not come on. In the
center position, the interior light
comes on when you open either door.
In the ON position, the interior light
stays on continuously.If the three-position switch is in the
center position, the interior light will
come on when you remove the key
from the ignition switch.
In addition, when the three position
switch is in the center position with
both doors closed, the two bulbs in
the interior light can be turned on
separately by the pushbutton
switches next to them. Push the
switch to turn the light on or off.
Interior Lights
Inst rument s and Cont rols
81

This section also includes
Maintenance Schedules f or normal
driving and severe driving conditions,
a Maintenance Record, and instruc-
tions f or simple maintenance tasks
you may want to take care of
yourself .
This section explains why it is
important to keep your car well
maintained and how to f ollow basic
maintenance saf ety precautions.
If you have the skills and tools to per-
f orm more complex maintenance
tasks on your Honda, you may want
to purchase the Service Manual. See
page f or inf ormation on how to
obtain a copy, or see your Honda
dealer. ......................
Maintenance Saf ety . 150
.
Important Safety Precautions . 151
.................
Maintenance Schedule . 152
...
Required Maintenance Record . 159
.......
Owner Maintenance Checks . 161
..............................
Fluid Locations . 162
......................................
Engine Oil . 163
..................................
Adding Oil . 163
....................
Recommended Oil . 163
..............................
Synthetic Oil . 164
....................................
Additives . 164
.....
Changing the Oil and Filter . 165
.............................
Cooling System . 167
............
Adding Engine Coolant . 167
.......
Replacing Engine Coolant . 169
....................
Windshield Washers . 173
6-speed Manual Transmission
...........................................
Fluid . 174
..........................
Dif f erential Fluid . 175
................
Brake and Clutch Fluid . 176
................................
Brake Fluid . 176
............................
Brake System . 176
...........................
Clutch System . 177
.....................
Air Cleaner Element . 178
....................................
Hood Latch . 180 ....................................
Spark Plugs . 180
..............................
Replacement . 180
............................
Specif ications . 182
...........................................
Battery . 183
.................................
Wiper Blades . 186
..............
Air Conditioning System . 188
..................
DustandPollenFilter .189
.......................................
Drive Belt . 190
...............................................
Tires . 191
......................................
Inf lation . 191
..................................
Inspection . 193
..............................
Maintenance . 194
.............................
Tire Rotation . 194
...................................
Tire Wear . 194
...
Replacing Tires and Wheels . 195
......................
Wheels and Tires . 196
..........................
Winter Driving . 196
.............................
Snow Tires . 197
............................
Tire Chains . 197
.............................................
Lights . 198
........................
Replacing Bulbs . 200
...........................
Storing Your Car . 208
263
Maintenance
Maint enance
149

Check the operation of your car’s
exterior lights at least once a month.
A burned out bulb can create an
unsaf e condition by reducing your
car’s visibility and the ability to
signal your intentions to other
drivers.Maint enance
Lights
198
TTUURRNNSSIIGGNNAALL
LLOOWWBBEEAAMMHHEEAADDLLIIGGHHTTHHIIGGHHBBEEAAMMHHEEAADDLLIIGGHHTT
SSIIDDEETTUURRNNSSIIGGNNAALLLLIIGGHHTT
FFRROONNTTPPAARRKKIINNGGAANNDDSSIIDDEEMMAARRKKEERRLLIIGGHHTT

Check the f ollowing:Headlights (low and high beam)
Parking lights
Taillights
Brake lights
Turn signals
Back-up lights
Hazard light f unction
License plate light
Side marker lights
Daytime running lights
(Canadian cars)
If youfindanybulbsareburnedout,
replace them as soon as possible.
Refer to the chart on page to
determinewhattypeof replacement
bulb is needed. 253
Maint enance
Lights
199
SSIIDDEEMMAARRKKEERRLLIIGGHHTTBBAACCKK--UUPPLLIIGGHHTT
TTUURRNNSSIIGGNNAALLLLIIGGHHTT
SSTTOOPP//TTAAIILLLLIIGGHHTTLLIICCEENNSSEEPPLLAATTEELLIIGGHHTT

The low beam headlight bulbs are a
type of high voltage discharge tube.
High voltage can remain in the
circuit even with the light switch of f
and the key removed. Because of
this, you should not attempt to
examine or change a low beam
headlight bulb yourself . If a low
beam headlight bulb fails, take the
cartoyourdealertohaveitreplaced.Halogen bulbs are used f or the high
beam headlight bulbs. When
replacing a high beam headlight bulb,
handle it by its base and protect the
glass from contact with your skin or
hard objects. If you touch the glass,
clean it with denatured alcohol and a
clean cloth.
Lights
Maint enance
Replacing a Headlight Bulb 200
Halogen headlight bulbs get very hot
when lit. Oil, perspiration, or a scratch
on the glass can cause the bulb to
overheat and shatter.

Open the hood.
Remove the electrical connector
f rom the bulb by squeezing the
connector to unlock the tab, then
slide the connector of f the bulb.Remove the rubber weather seal
by pulling on the tab.
Pull the bulb straight out of its
socket.
If you need to change the high
beam headlight bulb on the lef t
side, remove the coolant reserve
tank f rom its holder by pulling it
straight up.
Unclip the end of the hold-down
wire f rom its slot. Pivot it out of
the way and remove the bulb
socket.Install the rubber seal over the
back of the headlight assembly.
Make sure it is right side up; it is
marked ‘‘TOP.’’
Push the electrical connector onto
the new bulb.
Push the new bulb straight into
the socket until it bottoms. Turn on the headlights to test the
new bulb.
Insert the socket back into the
headlight assembly. Make sure
the bulb is installed correctly by
looking through the headlight lens.
The pins on the base of the bulb
should f it in the holes in the
headlight assembly. Pivot the hold-
down wire back in place and clip
the end into the slot.
1. 2. 3. 4. 5.6. 7. 8.
Lights
Maint enance
201

If you are changing the bulb on
the driver’s side, start the engine,
turn the steering wheel all the way
to the right, and turn off the
engine. If you are changing the
bulb on the passenger’s side, turn
the steering wheel to the left.Pull the inner f ender cover back.
Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
Pull the bulb straight out of its
socket.Install the new bulb in the socket.
Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
Testthelightstomakesurethe
new bulb is working.
Put the inner f ender in place.
Install the two holding clips. Lock
each clip in place by pushing on
the center.
Use a f lat-tipped screwdriver to
remove the three holding clips
f rom the inner f ender.
1.
2. 3. 4. 5.6. 7. 8. 9.
Lights
Maint enance
Replacing Front Turn Signal and
Side Marker L ight Bulbs 202