2002 HONDA PASSPORT remove seats

Driver and Passenger Safety26
3.Secure the child in the child
seat. Make sure the child is
properly strapped in the child
seat according to the child seat
maker ’ s instructions. A child
who is not properly secured in
a child seat can be thrown out
of the seat in a crash and
seriously injured.
Storing a Child Seat
When you are not using a child
seat, either remove it and store it
in a safe place, or make sure it is
properly secured. An unsecured
child seat can be thrown around
the vehicle during a crash or
sudden stop and injure someone.Protecting Infants
Child Seat Type
Only a rear-facing child seat
provides proper support for a
baby’ s head, neck, and back.
Infants up to about one year of
age must be restrained in a
rear-facing child seat.
Two types of seats may be used:
a seat designed exclusively for infants, or a convertible seat used
in the rear-facing reclining mode.
Placing a rear-facing child seat
in the front seat can result in
serious injury or death if the
airbags inflate.
Always place a rear-facing child
seat in the back seat, not the
front.
We recommend that an infant be
restrained in a rear-facing child
seat until the infant reaches the
seat maker
’s weight or height
limit and is able to sit up without
support.

Driver and Passenger Safety34
unlatch the belt, allow it to
retract fully, then repeat these
steps.
To deactivate the locking
mechanism in order to remove a
child seat, unlatch the buckle,
unroute the seat belt, and let the
belt fully retract. Installing a Child Seat With the
Lap Belt
To install a forward-facing child
seat in the center back seat with
the lap belt, follow instruction
number 1 on page 32 for routing
and latching the seat belt. Then
pull hard on the loose end of the
belt to remove any slack (it may
help to put weight on the child
seat while pulling on the belt). Finally, follow instruction number
5 on page 33 to verify that the
child seat is secure.
Protecting Larger Children
When a child reaches the
recommended weight or height
limit for a forward-facing child
seat, the child should sit in one of
the outer back seats and wear a
lap/shoulder belt. The
lap/shoulder belt provides better
protection than the lap belt.
If a child is too short for the
shoulder part of the belt to fit
properly, we recommend that the
child use a booster seat until the
child is tall enough to use the seat
belt without a booster.

94Seats
Head restraints are designed to
help reduce the risk of neck
injuries.
They are most effective when you
adjust them so the back of the
occupant’
s head rests against the
center of the restraint. A taller
person should adjust the restraint
as high as possible. Push the lock knob to unlock the
head restraint. Move the restraint
up or down as required.
Push to
release
the lock.
Adjust the head restraint before
you start driving. Trying to adjust
it while driving could cause you
to lose control of the vehicle.
To remove a head restraint for
cleaning or repair, push the
release button and pull the
restraint out of the seat-back. The rear seat can be folded
forward to provide additional
cargo area.
Folding
1. Pull the strap toward the
outside of the seat and fold the
seat cushion up.
Pull the
strap.
Rear Seat

95Seats
2. To remove a head restraint,
press the release knob and pull
up on the restraint.
Push to release
the lock.
3. Fold the seat-back down bypulling the release knob, and
pulling the seat-back forward.
Pull the
release
knob.
4. Unsnap the strap on the seatbottom. Thread it through the
buckle on the seat-back and
pull it tight.