2002 HONDA CR-V flat tire

Unzip the flap around the lower
edge of the cover.Pull of f the center spacer. Using
the wheel wrench, loosen the
three wheel nuts and remove them.
Remove the spare tire from the
holder.
Pull out the bottom of the cover,
then gradually pull it of f .
12.
14.
13.
CONT INUED
On EX-L model in Canada
Hard plastic spare tire cover
T aking Care of t he Unexpect ed
Changing a Flat T ire
311
C CE
EN
NT TE
ER
R S
SPPA
A C
CEER
R

Loosen the f ive wheel nuts 1/2
turn with the wheel wrench.Locate the jacking point nearest
thetireyouneedtochange.Itis
pointed to by an arrow molded into
the underside of the body. Place
the jack under the jacking point.
Turn the end bracket clockwise
until the top of the jack contacts
the jacking point. Make sure the
center of the jacking point tab is
restinginthejacknotch.Use the extension and wheel
wrench as shown to raise the
vehicle until the f lat tire is of f the
ground.
15.
16.17.
T aking Care of t he Unexpect ed
Changing a Flat T ire
312
W WHHE
EE
EL
L N
NUUTT E
E
X
X T
TE
EN
NS SIIOON N
W
WH HE
EE
EL
L W
WR REEN
NC CHH
J
JA A C
CKKIINNG G P
PO
OI INNT T

CONT INUED
Put on the spare tire. Put the
wheel nuts back on f inger-tight,
then tighten them in a crisscross
pattern with the wheel wrench
until the wheel is f irmly against
the hub. Do not try to tighten
them f ully.
Bef ore mounting the spare tire,
wipeanydirtoff themounting
surface of the wheel and hub with
a clean cloth. Wipe the hub
carefully,itmaybehotfrom
driving.
Remove the wheel nuts and f lat
tire. Temporarily place the f lat tire
on the ground with the outside
surf ace of the wheel f acing up.
You could scratch the wheel if you
putitfacedown.
18.
19.20.
Changing a Flat T ire
T aking Care of t he Unexpect ed313
B BRRAA K
KEE H
HU
UB B

Put the flat tire on the spare tire
holder. Put the wheel nuts on
finger-tight, then tighten them
with the wheel wrench.
Put the center spacer in the center
of the wheel.
Store the jack in its holder. Turn
the jack’s end bracket to lock it in
place. Install the cover on the side
of the cargo area.
Tighten the wheel nuts securely in
the same crisscross pattern. Have
the wheel nut torque checked at
the nearest automotive service
f acility.
Tighten the wheel nuts to:
Remove the center cap from the
flat tire.
Lower the vehicle to the ground
and remove the jack.
23.
21.
22.
24.
25.
T aking Care of t he Unexpect ed
Changing a Flat T ire
314
C CEEN
NT TE
ER
R S
SPPA
A C
CEER
R
80 lbf·ft (108 N·m , 11 kgf·m)

CONT INUED
Step back to check the alignment
of the logo. If needed, pivot the
cover until the logo is straight.
Hold the cover at the 10 o’clock
and 2 o’clock positions, then place
the top of it over the spare tire.
Store the tool kit in the storage bin
under the cargo area f loor.
Close the tailgate.
Install the spare tire cover.
26.
27.
28.
29.30.
OnLXandEXmodelsintheU.S.and
Canada
Changing a Flat T ire
T aking Care of t he Unexpect ed
Sof t vinyl spare t ire cover
315
Loose items can fly around the
interior in a crash and could
seriously injure the occupants.
Store the wheel, jack, and tools
securely before driving.
Make sure the cover is at room
temperature bef ore you install it. If it’s
too cold, it won’t f it easily over the tire.

Starting at the top of the tire,
position the outside seam of the
cover slightly over the outside
edge of the tire. Pull the cover on,
a little at a time, and alternate side
to side along the tire until you
reach the bottom.If needed, readjust the cover to
smooth out any wrinkles. Pull the bottom of the cover over
the tire.
Zip the cover closed.
31. 32.
33.34.
Changing a Flat T ire
T aking Care of t he Unexpect ed316
S SP
PA
A R
REE T
TI
IRRE E B
BRRAA C
CKKEET
T
O
OU
UTTS
SI IDD E
E S
SEEA
A M
M

Place the top of the cover over the
spare tire, then gradually push the
bottom of the cover over the
bottom of the tire.Make sure the cover is horizontal.
If needed, pivot the cover until the
cover is horizontal.
Zip the cover closed.
35. 36.37.
On EX-L model in Canada
Changing a Flat T ire
T aking Care of t he Unexpect ed
Hard plastic spare tire cover
317

µ
µ
µ
If your vehicle needs to be towed,
call a prof essional towing service or,
if youbelongtoone,anorganization
that provides roadside assistance.
Never tow your vehicle behind
another vehicle with just a rope or
chain. It is very dangerous.
The tow
truck uses two pivoting arms that go
under the tires (f ront or rear) and lif t
them of f the ground. The other two
tires remain on the ground.
The tow
truck uses metal cables with hooks
on the ends. These hooks go around
parts of the f rame or suspension and
cables lif t that end of the vehicle of f
the ground. Your vehicle’s
suspension and body can be
seriously damaged.
There are three popular types of
prof essional towing equipment.
The operator
loads your vehicle on the back of a
truck. Any other
method of towing will damage the
drive system. When you contact the
towing agency, inf orm them that a
f lat-bed is required. Refer to
on page
for non-emergency towing
inf ormation. 224Wheel L if t Equipment
Sling-t ype Equipment
Flat -bed Equipment
Never tow your vehicle with
wheel lif t equipment.
T his method of
towing your CR-V is unacceptable.
T his is the only way to
transport your vehicle. Towing Your Vehicle
Behind a Motorhome
Emergency T owing
T aking Care of t he Unexpect ed337
Towing a 4WD CR-V with only two
tires on the ground will damage parts
of the 4WD system. It should be
transported on a f lat-bed truck or
trailer.