2002 HONDA ACCORD maintenance

Every time you check inf lation, you
should also examine the tires f or
damage, f oreign objects, and wear.
Youshouldlookfor:Bumps or bulges in the tread or
side of the tire. Replace the tire if
youfindeitherof theseconditions.
Cuts, splits, or cracks in the side
of the tire. Replace the tire if you
can see f abric or cord.
Excessive tread wear. In addition to proper inf lation,
correct wheel alignment helps to
decrease tire wear. If you f ind a tire
is worn unevenly, have your dealer
check the wheel alignment.
The tires were properly balanced by
the factory. They may need to be
rebalanced at some time bef ore they
are worn out. Have your dealer
check the tires if you f eel a consis-
tent vibration while driving. A tire
should always be rebalanced if it is
removed f rom the wheel f or repair.
Your car’s tires have wear indicators
molded into the tread. When the
tread wears down to that point, you
will see a 1/2 inch (12.7 mm) wide
band running across the tread. This
shows there is less than 1/16 inch
(1.6 mm) of tread lef t on the tire. A
tire that is this worn gives very little
traction on wet roads. You should
replace the tire if you can see the
tread wear indicator in three or more
places around the tire.
Inspection
Maintenance
Tires
Maint enance286
IINNDDIICCAATTOORRLLOOCCAATTIIOONNMMAARRKKSS
TTRREEAADDWWEEAARRIINNDDIICCAATTOORRSS

Block the rear wheels.
Fill the f uel tank.
Change the engine oil and f ilter
(see page ).
Wash and dry the exterior
completely.
Cleantheinterior.Makesurethe
carpeting, floor mats, etc. are
completely dry.
Leave the parking brake off. Put
the transmission in Reverse
(5-speed manual) or Park
(automatic).
If you need to park your car f or an
extended period (more than one
month), there are several things you
should do to prepare it f or storage.
Proper preparation helps prevent
deterioration and makes it easier to
get your car back on the road. If
possible, store your car indoors.
If the car is to be stored for a
longer period, it should be
supported on jackstands so the
tires are of f the ground.
Leave one window open slightly (if
the car is being stored indoors).
Disconnect the battery.
Support the f ront wiper blade
arms with a f olded towel or rag so
they do not touch the windshield.
To minimize sticking, apply a
silicone spray lubricant to all door
and trunk seals. Also, apply a
vehiclebodywaxtothepainted
surfaces that mate with the door
and trunk seals.Coverthecarwitha‘‘breathable’’
cover, one made f rom a porous
material such as cotton.
Nonporous materials, such as
plastic sheeting, trap moisture,
which can damage the paint.
If possible, run the engine f or a
while periodically (pref erably once
amonth).
If you store your car f or 12 months
or longer, have your Honda dealer
perf orm the inspections called f or in
the 24 months/30,000 miles (48,000
km) maintenance schedule (Normal
Conditions) as soon as you take it
out of storage (see page ). The
replacements called f or in the
maintenance schedule are not
needed unless the car has actually
reached that time or mileage.
252
240
St oring Your Car
Maint enance301

Repair chips and scratches in the
paint as soon as you discover them.
Inspect and clean out the drain
holes in the bottom of the doors
and body.
Check the f loor coverings f or
dampness. Carpeting and f loor
mats may remain damp f or a long
time, especially in winter. This
dampness can eventually cause
the f loor panels to corrode.
Two f actors normally contribute to
causing corrosion in your car:
Moisture trapped in body cavities.
Dirtandroadsaltthatcollectsin
hollows on the underside of the
car stays damp, promoting
corrosion in that area.
Removal of paint and protective
coatings f rom the exterior and
underside of the car. Many corrosion-preventive measures
are built into your Honda. You can
help keep your car f rom corroding
by perf orming some simple periodic
maintenance:
Use a high-pressure spray to clean
the underside of your car. This is
especially important in areas that
useroadsaltinwinter.Itisalsoa
good idea in humid climates and
areas subject to salt air. Cars
equipped with ABS have a sensor
and wiring at each wheel. Be
caref ul not to damage them.
Have the corrosion-preventive
coatings on the underside of your
car inspected and repaired
periodically.
1. 2.
Appearance Care
Corrosion Prot ect ion
309

ÎÎIn Canada, Honda vehicles comply
with the Canadian Motor Vehicle
Saf ety Standards (CMVSS) f or
Emissions valid at the time they are
manuf actured.
The burning of gasoline in your car’s
engine produces several byproducts.
Some of these are carbon monoxide
(CO), oxides of nitrogen (NOx) and
hydrocarbons (HC). Gasoline
evaporating from the tank also
produces hydrocarbons. Controlling
the production of NOx, CO, and HC
is important to the environment.
Under certain conditions of sunlight
and climate, NOx and HC react to
f orm photochemical ‘‘smog.’’ Carbon
monoxide does not contribute to
smog creation, but it is a poisonous
gas.
The United States Clean Air Act
sets standards f or automobile
emissions. It also requires that
automobile manufacturers explain to
owners how their emissions controls
workandwhattodotomaintain
them. This section summarizes how
the emissions controls work.
Scheduled maintenance is on page
.
Your car has a Positive Crankcase
Ventilation System. This keeps
gasses that build up in the engine’s
crankcase from going into the
atmosphere. The Positive Crankcase
Ventilation valve routes them from the crankcase back to the intake
manif old. They are then drawn into
the engine and burned.
As gasoline evaporates in the f uel
tank, an evaporative emissions
control canister f illed with charcoal
adsorbs the vapor. It is stored in this
canister while the engine is of f . Af ter
the engine is started and warmed up,
the vapor is drawn into the engine
and burned during driving.
The Onboard Ref ueling Vapor
Recovery (ORVR) system captures
the f uel vapors during ref ueling. The
vapors are adsorbed in a canister
f illed with activated carbon. While
driving, the f uel vapors are drawn
into the engine and burned of f .
240
The Clean Air Act
Crankcase Emissions Control
System Evaporative Emissions Control
System
Onboard Ref ueling Vapor
Recovery
T echnical Inf ormation
Emissions Cont rols
349

CONT INUED
...
Accessories and Modif ications . 202
................................
Accessories . 202
...
Additional Safety Precaution . 202
............................
Modif ications . 202
ACCESSORY (Ignition Key .......................................
Position) . 73
.............
Accessory Power Socket . 100
....................
Additives, Engine Oil . 252
.....................................
Airbag (SRS) . 9
.....................
Air Cleaner Element . 269
............................
Air Conditioning . 104
..............................
Maintenance . 281
.........................................
Usage . 104
.......................
Air Pressure, Tires . 284
.......................
Alcohol in Gasoline . 347
......................................
Antif reeze . 255
Anti-lock Brakes (ABS)
................................
Description . 220
...............................
Indicator . 57, 221
...................................
Operation . 220
.
Anti-thef t Steering Column Lock . 72
..........................
Appearance Care . 303
........
Audio System . 119, 131, 147, 164
.............
Automatic Speed Control . 185 ..............
Automatic Transmission . 212
..........................
Capacity, Fluid . 342
.......
Checking Fluid Level . 263, 264
.......................................
Shif ting . 212
.
Shif t Lever Position Indicator . 213
................
Shif t Lever Positions . 213
....................
Shif t Lock Release . 216
Battery ......
Charging System Light . 56, 326
............................
Jump Starting . 320
..............................
Maintenance . 276
............................
Specif ications . 343
..............................
Bef ore Driving . 193
..........................................
Belts, Seat . 8
.............................
Beverage Holder . 98
...................................
Body Repair . 310
Brakes
...........
Anti-lock System (ABS) . 220
.............
Break-in, New Linings . 194
....................
Bulb Replacement . 295
...........................................
Fluid . 267
.........................................
Parking . 95
.........................
System Indicator . 57 ........................
Wear Indicators . 219
.............................
Braking System . 219
........................
Break-in, New Car . 194
..
Brightness Control, Instruments . 65
........................
Brights, Headlights . 64
Bulb Replacement
..........................
Back-up Lights . 295
..............................
Brake Lights . 295
..............................
Ceiling Light . 298
..........................
Courtesy Light . 299
................
Front Parking Lights . 294
........
Front Side Marker Lights . 293
.................................
Headlights . 292
.........
High-mount Brake Light . 297
.................
License Plate Lights . 297
............................
Specif ications . 343
.....................................
Spotlight . 299
...............................
Trunk Light . 300
....................
Turn Signal Lights . 293
..............................
Bulbs, Halogen . 292
Index
A
B
I