2002 HONDA ACCORD COUPE ECU

To replace the battery, place a cloth
on the edge of the transmitter and
remove the upper half by carefully
prying on the edge with a small f lat-
tip screwdriver.
Panic mode allows you to remotely
activate your car’s security system to
attract attention. When activated, the
horn will sound, and the exterior
lights will f lash, f or about 30 seconds.
To activate panic mode, press and
hold the PANIC button for about two
seconds.
To cancel Panic mode bef ore 30
seconds, press any button on the
remote transmitter. You can also
turn the ignition switch to ON (II).
When the remote transmitter’s
battery begins to get weak, it may
take several pushes on the button to
lock or unlock the doors, and the
LED will not light. Replace the
battery as soon as possible.
Battery type: CR2025
If you unlock the doors with the
remote transmitter, but do not open
either door within 30 seconds, the
doors automatically relock and the
security system sets.
You cannot lock or unlock the doors
with the remote transmitter if either
door is not f ully closed or the key is
in the ignition switch.
To open the trunk, push the Trunk
Release button f or approximately
one second.
The trunk will not open if the key is
in the ignition switch.
Keys and Locks
Inst rument s and Cont rols
Panic Mode
Replacing the Battery
80

Make sure all rear shoulder belts are
positioned in f ront of the rear seat-
back whenever the seat-back is in its
upright position.
Never drive with the seat-back
f olded down and the trunk lid open.
Seeon
page .
To lock the seat-back upright, push it
f irmly against the trunk panel. Make
sure it is latched in place by pulling
on the top of the seat. Make sure all items in the trunk, or
items extending through the opening
into the back seat, are secured.
Looseitemscanflyforwardand
cause injury if you have to brake
hard. See
on page
.
To release the seat-back from inside
the trunk, pull the release under the
trunk panel. Push the seat-back
down, then let go of the release.
Do not put any heavy items on the
seat-back when it is folded. 184
52
Carbon Monoxide Hazard Carrying Cargo
Seat A djustments
Inst rument s and Cont rols92
R RE
EL
LEE A
A S
SEE

.....................
Heating and Cooling .108
.........
What Each Control Does . 108
............
How to Use the System . 111
..........
To Turn Everything Of f . 114
...............
Climate Control System . 115
.......
Fully-automatic Operation . 117
.......
Semi-automatic Operation . 118
Sunlight Sensor/ ............
Temperature Sensor . 122
..........
Audio System (LX, LX-V6) . 123
....
AM/FM/CD Audio System . 123
.................
Operating the Radio . 124
.................
Adjusting the Sound . 128
............
Audio System Lighting . 129
.........
Operating the CD Player . 130 .....
Operating the CD Changer . 132
....
CD Player Error Indications . 133
CD Changer Error .............................
Indications .134
Operating the Cassette .....................................
Player .135
............
Tape Search Functions . 136
..........
Audio System (EX, EX-V6) . 138
AM/FM/Cassette/ .
CD Changer Audio System . 138
.................
Operating the Radio . 139
.................
Adjusting the Sound . 143
............
Audio System Lighting . 144
....................
Radio Frequencies . 144
........................
Radio Reception .144
Operating the Cassette .....................................
Player .146
............
Tape Search Functions . 147
Caring f or the Cassette .....................................
Player .150
.....
Operating the CD Changer . 151
Loading CDs in the .............................
Changer .152
...............................
Operation .154
Removing CDs from the .............................
Changer .156 .......
Protecting Compact Discs . 158
CD Changer Error .............................
Indications .159
...........
Remote Audio Controls . 160
Audio System (Special Edition ..................................
models) .161
.................
Operating the Radio . 162
.................
Adjusting the Sound . 166
....................
Radio Frequencies . 167
........................
Radio Reception .167
.........
Operating the CD Player . 169
Operating the Optional CD .................................
Changer .171
.......
Protecting Compact Discs . 172
.....
CD Player Error Indication . 173
CD Changer Error Indications. 174
Operating the Cassette .....................................
Player .175
Caring f or the Cassette .....................................
Player .178
.......................
Thef t Protection .179
............................
Security System .180
................................
Cruise Control .181
HomeLink Universal .................................
Transceiver .185
Comf ort and Convenience Features
Comf ort and Convenience Feat ures107

Once the security system is set,
opening either door (without using
the key or the remote transmitter),
or the hood, will cause it to alarm. It
also alarms if the radio is removed
f rom the dashboard or the wiring is
cut.
The security system helps to protect
your car and valuables f rom thef t.
The horn sounds and a combination
of headlights, parking lights, side
marker lights and taillights f lashes if
someone attempts to break into your
carorremovetheradio.Thisalarm
continues f or two minutes, then the
system resets. To reset an alarming
system bef ore the two minutes have
elapsed, unlock either door with the
key or the remote transmitter.
The security system sets auto-
matically fifteen seconds after you
lock the doors, hood, and trunk. For
the system to activate, you must lock
the doors f rom the outside with the
key, lock tab, door lock switch, or
remote transmitter. The security
system light next to the driver’s door
lock starts blinking immediately to
show you the system is setting itself . With the system set, you can still
open the trunk with the master key
or the remote transmitter (if the
transmitter is equipped with a trunk
opener) without triggering the alarm.
The alarm will sound if the trunk
lock is f orced, or the trunk is opened
with the trunk release handle or the
emergency trunk opener.
The security system will not set if
the hood, trunk, or either door is not
f ully closed. If the system will not set,
check the Door and Brake Lamp
Monitor on the instrument panel
(see page ), to see if the doors
and trunk are f ully closed. Since it is
notpartofthemonitordisplay,
manually check the hood.
Do not attempt to alter this system
or add other devices to it.
61
Standard on Special Edition, EX, and
EX-V6 models
Security System
Comf ort and Convenience Feat ures180
S SE EC
CU UR RIITT Y
Y S
SYYSSTTE
EM
M L
LIIGGH HT
T

The HomeLink Universal
Transceiver built into your car can
be programmed to operate remotely-
controlled devices around your home,
such as garage doors, lighting, or
home security systems. It can
replaceuptothreeremote
transmitters.
If you have problems with training
the HomeLink Universal Transceiver,
or would like inf ormation on home
products that can be operated by the
transmitter, call (800) 355-3515. On
the Internet, go to www.homelink.
com.Always ref er to the operating
instructions and saf ety inf ormation
that came with your garage door
opener or other equipment you
intend to operate with the HomeLink
Universal Transceiver. If you do not
have this inf ormation, you should
contact the manuf acturer of the
equipment.
While training or using HomeLink,
make sure you have a clear view of
the garage door or gate, and that no
one will be injured by its movement.
If you are training HomeLink to
operate a garage door or gate, it is
recommended that you unplug the
motor f or that device during training.
Repeatedly pressing the remote
control button could burn out the
motor.
HomeLink stores the code in a
permanent memory. There should
be no need to retrain HomeLink if
your car’s battery goes dead or is
disconnected.
If your garage door opener was
manuf actured bef ore April 1982, you
may not be able to program
HomeLink to operate it. Garage door
openers manuf actured bef ore that
date do not have a safety feature that
causes them to stop and reverse if an
obstacle is detected during closing,
increasing the risk of injury. If you
have questions, call (800) 355-3515.
On EX-V6 model
Customer Assistance
Important Saf ety Precautions General Inf ormation
Comf ort and Convenience Feat ures
HomeL ink Universal T ransceiver
185

CONT INUED
Canadian Owners:
The remote control you are training
from may stop transmitting after two
seconds. This is not long enough f or
HomeLink to learn the code. Release
and press the button on the remote
control every two seconds until
HomeLink has learned the code.For security purposes, newer garage
door opening systems use a ‘‘rolling’’
or variable code. Inf ormation f rom
the remote control and the garage
door opener are needed bef ore
HomeLink can operate the garage
door opener.
The‘‘Training HomeLink’’ procedure
trains HomeLink to the proper
garage door opener code. The
f ollowing procedure synchronizes
HomeLink to the garage door opener
so they send and receive the correct
codes.
The red light in HomeLink should
begin f lashing. It will f lash slowly
at first, then rapidly.
When the red light f lashes rapidly,
release both buttons. HomeLink
should have learned the code from
the remote control.
Plug in the garage door opener
motor, then test the HomeLink
transceiver button by pushing it. It
should operate the garage door.
If the button does not work, repeat
this procedure to train it again. If it
still does not work, you may have a variable or rolling code garage
door opener. Test this by pressing
and holding the HomeLink
transceiver button you just trained.
If the red light blinks f or two
seconds,thenstayson,youhavea
rolling code garage door opener.
You may be able to verify this with
the manufacturer’s documentation.
Go to ‘‘Training With a Rolling
Code System.’’
Repeat these steps to train the
other two HomeLink buttons to
operate any other remotely-
controlled devices around your
home (lighting, automatic gate,
security system, etc.).
5.
6.
7.
8.T raining With a Rolling Code
System
HomeL ink Universal T ransceiver
Comf ort and Convenience Feat ures187

CONT INUED
4-cylinder models
Pull the support rod out of its clip
by holding the grip and insert the
end into the hole on the f ront of
the hood around the center.
If you can open the hood without
lifting the hood latch handle, or the
hood latch handle moves stif f ly or
does not spring back as bef ore, the
mechanism should be cleaned and
lubricated (see page ).
To close the hood, lif t it up slightly to
remove the support rod f rom the
hole. Put the support rod back into
its holding clip. Lower the hood to
about a f oot (30 cm) above the
fender,thenletitdrop.
After closing the hood, make sure it
is securely latched.
3.
269
Service Station Procedures
Bef ore Driving195
S SU
UP PP
PO
OR RTT R
ROOD D
4
4- -c
cy yl liinn d
de
err m
m o
od
de
ellss
G
GR
RIIPP

Remove the dipstick (orange
handle).
Lif t the hood up most of the way.
The hydraulic supports will lif t it
uptherestof thewayandholdit
up.
To close the hood, lower it to about a
f oot (30 cm) above the f ender, then
press down f irmly with your hands.
Afterclosingthehood,makesureit
is securely latched. Check the engine oil level every time
you f ill the car with f uel. Wait a f ew
minutes af ter turning the engine of f
bef ore you check the oil.
1.
6-cylinder models
Service Station Procedures
Bef ore Driving
Oil Check
196
D D
I
IPP S
ST TI
ICCK K
6
6- -c
cy yl liinn d
de
err m
m o
od
de
ellss
6
6-
-c
cy yl liinn d
de
err m
m o
od
de
ellss
4
4--c
cy yl liinn d
de
err m
m o
od
de
ellss D
D
I
IPP S
ST TI
ICCK K