Page 149 of 394
2-76 Cruise Light
United States Canada
The CRUISE light comes on whenever you set your
cruise control. See ªCruise Controlº in the Index.
Tow/Haul Light
This light is displayed
when the tow/haul mode
has been activated.
For more information see, ªTow/Haul Modeº in the Index.
Fuel Gage
United States Canada
When the ignition is on, the fuel gage tells you about
how much fuel you have left in your tank.
The gage will first indicate empty before you are out of
fuel, and you should get more fuel as soon as possible.
Page 150 of 394

2-77
Here are some situations you may experience with
your fuel gage. None of these indicate a problem
with the fuel gage.
At the gas station, the fuel pump shuts off before
the gage reads full.
It takes a little more or less fuel to fill up than the
fuel gage indicated. For example, the gage may have
indicated the tank was half full, but it actually took
a little more or less than half the tank's capacity to
fill the tank.
The gage goes back to empty when you turn off
the ignition.
Message Center
The message center is located on the left side of the
instrument panel cluster. It gives you important safety
and maintenance facts. When you turn the ignition on,
the entire center lights up for just a few seconds.
As needed, the message center will display one of the
following messages. The message center is capable
of alternating among different messages if needed.
Battery
If this message is displayed
when the engine is running,
you may have a problem
with your charging system.
The battery display will also stay on while the key is in
RUN until the engine is started.
If the message stays on after starting the engine it could
indicate a problem with the generator drive belt, or some
other charging system problem. Have it checked right
away. Driving with this message displayed could drain
your battery.
If you must drive a short distance with this message
displayed, it helps to turn off all your accessories,
such as the radio and the air conditioner.
Page 154 of 394
2-81 Low Washer Fluid
This message is displayed
when the vehicle is low on
windshield washer fluid.
The message is only
displayed for 15 seconds
at the start of each
ignition cycle.
For more information see, ªWindshield Washer Fluidº
in the Index.
Cargo Lamp On
This message is displayed
when the cargo lamp is
turned on and the ignition
key is turned to RUN.
Low Fuel
This message is displayed
when your vehicle is
low on fuel.
Refer to the fuel gage for a better indication of the
amount of fuel remaining in the fuel tank.
Page 155 of 394
2-82
Secondary Information Center (SIC)
This section explains the features of your SIC.
The SIC provides instant information about fuel,
mileage and vehicle history in addition to allowing you
to personalize certain features of your vehicle. If you
would like to skip to the section on personalizing your
vehicle, see ªMenuº listed later in this section.
Fuel
Each press of the FUEL button will change the
display between the fuel remaining range, average
fuel economy, instantaneous fuel economy and a
blank display.
The average fuel economy can be reset using the
RESET button.
Trip
Each press of the TRIP button will change the display
between personal trip computer, business trip computer,
timer, vehicle history, annual mileage and a blank display.
Page 156 of 394

2-83
Personal Trip Computer and Business
Trip Computer
Each press of the arrow button will change the
display between on/off, trip odometer, fuel used,
average fuel economy and average speed.
The ON/OFF button will turn the trip computer on
and off. The information on the trip computer only
gets updated when it is turned on. The personal
and business computers function independently, i.e.
turning one of them on does not turn the other off.
All information associated with the trip computer
will be reset when the RESET button is pressed.
If the RESET button is pressed and held for more
than two seconds, all of the trip computer settings
will reset starting from the last ignition cycle
(turning the ignition from OFF to RUN).
Timer
Each press of the ON/OFF button will turn the timer
on or off.
The RESET button will reset the timer to 00:00:00.
If turned on, the timer will accumulate whenever
the SIC is powered (the engine does not have to
be running).
The timer will rollover after 99:59:59.Vehicle History Last 15 Days
The first press of the arrow button will display the
maximum speed and accumulated mileage for the
current day.
Every press of the arrow button after will display the
maximum speed and accumulated mileage for the
previous day.
This feature requires the date and time to be set
correctly. Refer to the setting of day/date/time under
ªMenuº explained later in this section.
Annual Mileage
The annual mileage displayed is the mileage
accumulated since the annual mileage was reset.
Pressing the RESET button will reset the annual
mileage to 0.
Pressing the arrow button will display the ratio of
personal trip computer mileage to annual mileage as
a percent.
Pressing the arrow button again will display the ratio
of business trip computer mileage to annual mileage
as a percent.
Page 157 of 394

2-84 Menu
Press the MENU button to choose a feature you
would like to personalize (the features are listed below).
Each press of the button will display a new item that
can be personalized. Use the arrow button to choose the
setting you would like to use within the chosen feature.
For example, you would prefer to personalize the
automatic door locks so that the automatic locking
feature is disabled. You would do the following:
1. First press the MENU button until you reach the
Automatic Door Lock screen.
2. Next, press the arrow button until you find the
Disabled setting.
3. The setting is now actually set without having to
do anything else. You can do one of three things
at this point:
You can leave the personalization mode by
pressing FUEL or TRIP.
You can just let the SIC exit the personalization
mode on its own by waiting approximately
15 seconds without touching any buttons.
The SIC will then display the day/date.
Or you can press the MENU key to move on to
the next programmable feature.The following is a list of the personal settings that can
be changed:
Automatic Door Lock
Enabled: Doors automatically lock when vehicle
speed is above 15 mph (24 km/h) for two seconds.
Disabled: Doors do not lock automatically.
Automatic Door Unlock:
Driver: Driver's door unlocks when the key is
removed from the ignition.
All: All doors unlock when the key is removed
from the ignition.
Disabled: Doors do not unlock automatically.
Remote Lock Feedback
Horn: Horn chirps on second press of the LOCK
button on the keyless entry transmitter.
Lamps: Parking lamps flash on each press of the
LOCK button on the keyless entry transmitter.
Horn and Lamps: Parking lamps flash on each
press, horn chirps on second press of LOCK on the
keyless entry transmitter.
None: No horn or lamp feedback to the LOCK
button on the keyless entry transmitter.
Page 163 of 394

3-4
Recirculation will not be available in floor, blend, or
defrost modes. This helps reduce window fogging.
If the recirculation button is pressed in these modes,
the LED indicator for recirculation will flash three times
indicating that outside air is activated and recirculation
is not available.
If the air conditioning system is activated and system
demand is high in situations such as city traffic, idling,
or very hot weather, the system will automatically
switch from outside air to recirculation. The LED
indicator will not change. After demand on the system
is reduced, the system will return to outside air.
A/C (Air Conditioning): This button is used to
control the air conditioning compressor. Turning the
system on will allow air to be cooled and dehumidified
inside the vehicle.
Air conditioning will be automatically disabled when
the outside air temperature drops below a level at which
air conditioning is effective.
Air Conditioning
On hot days, open the windows long enough to let hot
air inside escape. This reduces the time it takes for your
vehicle to cool down. Then keep your windows closed
for the air conditioner to work its best.
The A/C button, located below the mode knob, allows
the air coming into your vehicle to be cooled. This
setting is useful for normal cooling on hot days. When
you use air conditioning with the recirculation button
pressed, turn off recirculation as soon as the vehicle
reaches a comfortable interior temperature.
Using air conditioning with the recirculation mode
active allows the air inside your vehicle to be
recirculated. This setting helps to maximize your air
conditioner's performance and your vehicle's fuel
economy. This setting also cools air the fastest and can
be used to keep unwanted odors and/or dust from
entering the vehicle. When using the air conditioner,
turn off recirculation and use outside air after the vehicle
reaches a comfortable interior temperature. When the
right knob on the control panel is between floor and
defrost, recirculation will not function to reduce window
fogging.
Page 198 of 394

4-15 Before You Go Off-Roading
There are some things to do before you go out. For
example, be sure to have all necessary maintenance and
service work done. Check to make sure all underbody
shields (if so equipped) are properly attached. Is there
enough fuel? Is the spare tire fully inflated? Are the
fluid levels up where they should be? What are the local
laws that apply to off
-roading where you'll be driving?
If you don't know, you should check with law
enforcement people in the area. Will you be on
someone's private land? If so, be sure to get the
necessary permission.
Loading Your Vehicle for Off-Road Driving
There are some important things to remember about
how to load your vehicle.
The heaviest things should be on the load floor and
forward of your rear axle. Put heavier items as far
forward as you can.
Be sure the load is secured properly, so driving on
the off
-road terrain doesn't toss things around.
CAUTION:
Cargo on the load floor piled higher than
the seatbacks can be thrown forward
during a sudden stop. You or your
passengers could be injured. Keep cargo
below the top of the seatbacks.
Unsecured cargo on the load floor can be
tossed about when driving over rough
terrain. You or your passengers can be
struck by flying objects. Secure the cargo
properly.
Heavy loads on the roof raise the vehicle's
center of gravity, making it more likely to
roll over. You can be seriously or fatally
injured if the vehicle rolls over. Put heavy
loads inside the cargo area, not on the roof.
Keep cargo in the cargo area as far forward
and low as possible.
You'll find other important information in this manual.
See ªVehicle Loadingº and ªTiresº in the Index.