2002 FORD THUNDERBIRD parking brake

considered normal and will not affect function durability of the
transmission. Once the vehicle is at operating temperature it may take
several shifts at the same operating condition for the transmission to
properly adapt. Over time the adaptive learning process will fully update
transmission operation. The more varied the driving habits, speed and
torque, the longer it may take to adapt but the more complete the
process will be.
When the battery is disconnected or a new battery installed, the
transmission must learn its adaptive strategy. As a result of this, the
transmission may shift firmly. This operation is considered normal and
will fully update transmission operation to its optimum shift feel.
Understanding gearshift positions
Pull the gearshift lever towards you and downward to the desired gear.
The gearshift positions are displayed on the floor console next to the
gearshift lever and on the instrument cluster.
Hold the brake pedal down while you move the gearshift lever
from P (Park) to another position. If you do not hold the brake
pedal down, your vehicle may move unexpectedly and injure someone.
P (Park)
Always come to a complete stop
before shifting into P (Park). Make
sure the gearshift lever is securely
latched in P (Park). This position
locks the transmission and prevents
the rear wheels from turning.
Always set the parking
brake fully and make sure
the gearshift lever is latched in P
(Park). Turn off the ignition
whenever you leave your vehicle.
Driving
142

If you use the temporary spare tire continuously or do not follow
these precautions, the tire could fail, causing you to lose control
of the vehicle, possibly injuring yourself or others.
When driving with the temporary spare tiredo not:
²exceed 80 km/h (50 mph) under any circumstances
²load the vehicle beyond maximum vehicle load rating listed on the
Safety Compliance Label
²tow a trailer
²use tire chains
²drive through an automatic car wash, because of the vehicle's reduced
ground clearance
²try to repair the temporary spare tire or remove it from its wheel
²drive for long distances when the temporary-use spare is on
²operate the vehicle with more than one temporary-use spare tire
²improperly inflate the temporary-use spare
²use the wheel for any other type of vehicle
Tire change procedure
To prevent the vehicle from moving when you change a tire, be
sure the parking brake is set, then block (in both directions) the
wheel that is diagonally opposite (other side and end of the vehicle) to
the tire being changed.
If the vehicle slips off the jack, you or someone else could be
seriously injured.
1. Park on a level surface, activate
hazard flashers and set parking
brake.
2. Place gearshift lever in P (Park),
turn engine OFF, and block the
diagonally opposite wheel.
Roadside emergencies
165

Preparing your vehicle
Your battery is located in the trunk of your vehicle.
When the battery is disconnected or a new battery is installed, the
transmission must relearn its adaptive strategy. As a result of this, the
transmission may shift firmly. This operation is considered normal and
will not effect function or durability of the transmission. Over time, the
adaptive learning process will fully update transmission operation to its
optimum shift feel.
1.Use only a 12±volt supply to start your vehicle.
2. Do not disconnect the battery of your disabled vehicle as this could
damage the vehicle's electrical system. Keep the battery vent hose
attached at all times.
3. Park the booster vehicle close to the trunk of your disabled vehicle
making sure the two vehiclesdo nottouch. Set the parking brake on
both vehicles and stay clear of the engine cooling fan and other moving
parts.
4. Check all battery terminals and remove any excessive corrosion before
you attach the battery cables.
5. Turn the heater fan on in both vehicles to protect any electrical
surges. Turn all other accessories off.
Connecting the jumper cables
1. Connect the positive (+) booster cable to the positive (+) terminal of
the discharged battery.
Note:In the illustrations,lightning boltsare used to designate the
assisting (boosting) battery.
+–+–
Roadside emergencies
170

SERVICE RECOMMENDATIONS
To help you service your vehicle:
²We highlight do-it-yourself items in the engine compartment for easy
location.
²We provide a scheduled maintenance guide which makes tracking
routine service easy.
If your vehicle requires professional service, your dealership can provide
the necessary parts and service. Check yourWarranty Guideto find out
which parts and services are covered.
Use only recommended fuels, lubricants, fluids and service parts
conforming to specifications. Motorcraft parts are designed and built to
provide the best performance in your vehicle.
PRECAUTIONS WHEN SERVICING YOUR VEHICLE
Be especially careful when inspecting or servicing your vehicle.
²Do not work on a hot engine.
²When the engine is running, keep loose clothing, jewelry or long hair
away from moving parts.
²Do not work on a vehicle with the engine running in an enclosed
space, unless you are sure you have enough ventilation.
²Keep all lit cigarettes, open flames and other lit material away from
the battery and all fuel related parts.
If you disconnect the battery, the engine must ªrelearnº its idle
conditions before your vehicle will drive properly, as explained in the
Batterysection in this chapter.
Working with the engine off
1. Set the parking brake and ensure the gearshift is securely latched in P
(Park).
2. Turn off the engine and remove the key.
3. Block the wheels to prevent the vehicle from moving unexpectedly.
Working with the engine on
1. Set the parking brake and ensure the gearshift is securely latched in P
(Park).
2. Block the wheels to prevent the vehicle from moving unexpectedly.
Note:Do not start your engine with the air cleaner removed and do not
remove it while the engine is running.
Maintenance and specifications
195

3. Set the parking brake and ensure the gearshift is securely latched in P
(Park).
4. Open the hood. Protect yourself from engine heat.
5. Locate and carefully remove the
engine oil level indicator (dipstick).
6. Wipe the indicator clean. Insert the indicator fully, then remove it
again.
²If the oil level isbetween the MIN and MAX marks,the oil level is
acceptable.DO NOT ADD OIL.
²If the oil level is below the MIN
mark, add enough oil to raise the
level within the MIN-MAX range.
²Oil levels above the MAX mark may cause engine damage. Some oil
must be removed from the engine by a service technician.
7. Put the indicator back in and ensure it is fully seated.
Maintenance and specifications
198

If you see any corrosion on the battery or terminals, remove the cables
from the terminals and clean with a wire brush. You can neutralize the
acid with a solution of baking soda and water.
Batteries normally produce explosive gases which can cause
personal injury. Therefore, do not allow flames, sparks or lighted
substances to come near the battery. When working near the battery,
always shield your face and protect your eyes. Always provide proper
ventilation.
When lifting a plastic-cased battery, excessive pressure on the
end walls could cause acid to flow through the vent caps,
resulting in personal injury and/or damage to the vehicle or battery.
Lift the battery with a battery carrier or with your hands on opposite
corners.
Keep batteries out of reach of children. Batteries contain sulfuric
acid. Avoid contact with skin, eyes or clothing. Shield your eyes
when working near the battery to protect against possible splashing of
acid solution. In case of acid contact with skin or eyes, flush
immediately with water for a minimum of 15 minutes and get prompt
medical attention. If acid is swallowed, call a physician immediately.
Battery posts, terminals and related accessories contain lead and
lead compounds.Wash hands after handling.
Because your vehicle's engine is electronically controlled by a computer,
some control conditions are maintained by power from the battery. When
the battery is disconnected or a new battery is installed, the engine must
relearn its idle and fuel trim strategy for optimum driveability and
performance. To begin this process:
1. With the vehicle at a complete stop, set the parking brake.
2. Put the gearshift in P (Park), turn off all accessories and start the
engine.
3. Run the engine until it reaches normal operating temperature.
4. Allow the engine to idle for at least one minute.
5. Turn the A/C on and allow the engine to idle for at least one minute.
Maintenance and specifications
201

A
Accessory delay ..........................64
Air bag supplemental restraint
system ................................109, 119
and child safety seats ............110
description ......................109, 119
disposal ....................................122
driver air bag ..................111, 120
indicator light ...........12, 113, 121
operation .........................111, 120
passenger air bag ...........111, 120
passenger deactivation
switch ......................................114
side air bag ..............................119
Air cleaner filter .......221±222, 227
Air conditioning ..........................35
Air filter, cabin ............................48
Antifreeze
(see Engine coolant) ................202
Anti-lock brake system
(see Brakes) ......................136±137
Anti-theft system ........................94
arming the system ....................94
disarming a triggered system ..94
Automatic transmission
driving an automatic
overdrive .................................141
fluid, adding ............................221
fluid, checking ........................221
fluid, refill capacities ..............228
fluid, specification ..................231
Auxiliary power point .................63
Axle
lubricant specifications ..229, 231
refill capacities ........................228B
Battery .......................................200
acid, treating emergencies .....200
charging system warning
light ............................................13
jumping a disabled battery ....169
maintenance-free ....................200
replacement, specifications ...227
servicing ..................................200
Belt minder ...............................104
Brakes ........................................136
anti-lock ...........................136±137
anti-lock brake system
(ABS) warning light .........12, 137
brake warning light ..................12
fluid, checking and adding ....220
fluid, refill capacities ..............228
fluid, specifications .........229, 231
lubricant specifications ..229, 231
parking ....................................138
shift interlock ..........................140
Break-in period .............................6
C
Capacities for refilling fluids ....228
Cassette tape player ...................19
Certification Label ....................233
Child safety restraints ..............122
child safety belts ....................122
Child safety seats ......................123
attaching with tether straps ..127
in front seat ............................125
in rear seat ..............................125
LATCH .....................................130
Cleaning your vehicle
engine compartment ..............188
exterior ....................................192
Index
237

Lumbar support, seats ...............96
M
Manual transmission
fluid capacities ........................228
lubricant specifications ..........231
Master lighting switch ................49
Mirrors
side view mirrors (power) .......65
Motorcraft parts ................214, 227
O
Octane rating ............................212
Odometer .....................................17
Oil (see Engine oil) ..................197
P
Panic alarm feature, remote
entry system ................................88
Parking brake ............................138
Parts (see Motorcraft parts) ....227
Power distribution box
(see Fuses) .......................159, 162
Power door locks ..................84, 90
Power steering ..........................140
fluid, checking and adding ....219
fluid, refill capacity ................228
fluid, specifications .........229, 231
R
Rear window defroster ...............48
Relays ........................................156
Remote entry system ...........86, 88illuminated entry ......................89
locking/unlocking doors .....84, 87
opening the trunk .....................87
panic alarm ...............................88
replacement/additional
transmitters ...............................89
replacing the batteries .............88
S
Safety belts (see Safety
restraints) ......................15, 99±103
Safety defects, reporting ..........186
Safety restraints ..................99±103
belt minder .............................104
cleaning the safety
belts .................................108, 192
extension assembly ................108
for adults .........................100±103
for children .............................122
warning light and
chime ...........................13, 15, 104
Safety seats for children ..........123
Seat belts
(see Safety restraints) ...............99
Seats ............................................95
child safety seats ....................123
cleaning ...................................191
SecuriLock passive anti-theft
system ....................................91, 93
Servicing your vehicle ..............195
Spark plugs,
specifications .....................227, 231
Specification chart,
lubricants ...........................229, 231
Speed control ..............................66
Speedometer ...............................17
Index
241