Page 10 of 264
WARNING LIGHTS AND CHIMES
Base instrument cluster
Optional instrument cluster
Turn signals
Illuminates when the
turn signals or the
hazard lights are
turned on. If the lights
stay on continuously or flash faster, check for a
burned-out bulb.
High beams
Illuminates when the
high beam headlamps
are turned on.
P! BRAKE
L
0
00000 00
C
E
FH
LH
10 203020 406080100
120
140
160
180
405060 70
80
90
100
11 0
1204
5
6
7 3
2
1
H
THEFT
RPMX1000
FUEL DOORSELECT/RESET
LOW
FUELO/D
OFF AIR
BAGSERVICE
ENGINE
SOON
MPH km/h
ABS
.
CHECK
FUEL
CAP
P! BRAKE
L
0
00000 00
C
E
FH
LH
102040608020 40608010 012 0 14 0
160
180
200
220
240
100
120
140
305070 90
110
13 0
1504
5
6
7
8 3
2
1
H
THEFT
RPMX1000
FUEL DOORSELECT/RESET
LOW
FUELO/D
OFF AIR
BAGSERVICE
ENGINE
SOONCHECK
FUEL
CAP
MPH km/h
ABS
.
Instrument Cluster
10
Page 75 of 264

BULBS
Replacing exterior bulbs
Check the operation of the following lamps
frequently:
²Headlamps
²Tail lamps
²Brakelamps
²High-mount brakelamp
²Turn signals
²Backup lamps
²License plate lamp
Do not remove lamp bulbs unless they will be
replaced immediately. If a bulb is removed for an
extended period of time, contaminants may enter
the lamp housings and affect performance.
Using the right bulbs
Replacement bulbs are specified in the chart below.
Headlamp bulbs must be marked with an authorized
ªD.O.T.º for North America and an ªEº for Europe to
assure lamp performance, light brightness and
pattern and safe visibility. The correct bulbs will not
damage the lamp assembly or void the lamp
assembly warranty and will provide quality bulb burn
time.
Function Trade Number
Tail lamp, brakelamp, turn lamp 3157K
Park lamp, turn lamp, side marker
(front)3157 AK (amber)
Backup lamp 3156K
License plate lamp 168
High-mount brakelamp 906
Headlamps 9007
Luggage compartment lamp 906
Dome lamp 575
Lights
75
Page 78 of 264
3. Connect the electrical connector into the plastic
base until it snaps, locking it into position.
4. Install the headlamp on vehicle by aligning the
lamp with the rear snap retainers, push to seat and
secure with two retainer pins.
5. Turn the headlamps on and make sure they work
properly. If the headlamp was correctly aligned
before you changed the bulb, you should not need to
align it again.
Replacing front parking lamp/turn signal bulbs
1. Make sure the headlamp control is in the OFF
position.
2. Open the hood.
3. At the back of the
headlamp, pull two
retainer pins up to
release the headlamp
assembly.
4. Pull headlamp
assembly forward
disengaging the lamp
from the rear snap retainers to expose the back of
the bulb.
5. Rotate the bulb
socket
counterclockwise and
remove from lamp
assembly.
6. Carefully pull the
bulb straight out from
the socket and push in
the new bulb.
7. To complete installation, follow the removal
procedure in reverse order.
Lights
78
Page 262 of 264

K
Keys ................. 100±102
key in ignition
chime ....................... 15
positions of the
ignition .................. 136
removing from the
ignition .................. 157
L
Lamps
bulb replacement
specifications chart.. 75
cargo lamps ............. 72
daytime running
light .......................... 71
fog lamps ................. 71
headlamps ......... 71, 76
headlamps, flash
to pass ..................... 72
instrument panel,
dimming ................... 72
interior lamps ... 74, 76
replacing
bulbs ...... 75±76, 78±80
Lane change indicator
(see Turn signal) ...... 74
Lights, warning
and indicator ............. 10
air bag ...................... 11
anti-lock brakes
(ABS) .............. 14, 144
anti-theft ................. 11
brake ........................ 15
charging system ...... 11
fuel cap light ........... 13
high beam ............... 10
low fuel .................... 13
overdrive off ............ 13
safety belt ............... 11
service engine soon.11
traction control
active ....................... 14
turn signal indicator.10
Limited slip axle
(see Traction Loc) .. 147
Load limits ............... 158
GAWR .................... 158
GVWR .................... 158
trailer towing ........ 158
Locks
doors ........................ 94
Lubricant
specifications ... 249, 251
Lug nuts, anti-theft . 174
Lumbar support,
seats ......................... 105
M
Manual
transmission ............ 154
fluid capacities ...... 247
lubricant
specifications ........ 251
reverse ................... 156
Mirrors
side view mirrors
(power) ................... 84
Motorcraft
parts ................. 227, 246
O
Octane rating .......... 225
Odometer ................... 18
Oil
(see Engine oil) ...... 206
Overdrive ........... 89, 149
Index
262