2002 BUICK RANDEZVOUS seats

1-10
Removing the Split Bench Seat
Each section of the split bench seat can be flipped
forward or removed individually.
1. Unlatch the shoulder belt from the lap-belt.
2. Make sure that the seatback is in the
upright position.
3. Lift up or push forward on the seatback recliner lever
to fold the seatback forward.
Base-Level
4. For base
-level split bench seats, pull the lever at the
base of the seat on the outboard side to release
the rear latches from the floor pins and flip the
seat forward.
For up
-level split bench seats, continue pushing
forward on the recliner lever to release the rear
latches from the floor pins and flip the seat forward.
The seat can stay in this position or it can be removed
from the vehicle by following the next steps.

1-21
Safety Belts: They're for Everyone
This part of the manual tells you how to use safety belts
properly. It also tells you some things you should not
do with safety belts.
And it explains the air bag system.
CAUTION:
Don't let anyone ride where he or she can't wear
a safety belt properly. If you are in a crash and
you're not wearing a safety belt, your injuries
can be much worse. You can hit things inside the
vehicle or be ejected from it. You can be seriously
injured or killed. In the same crash, you might
not be if you are buckled up. Always fasten your
safety belt, and check that your passengers' belts
are fastened properly too.
CAUTION:
It is extremely dangerous to ride in a cargo area,
inside or outside of a vehicle. In a collision,
people riding in these areas are more likely
to be seriously injured or killed. Do not allow
people to ride in any area of your vehicle that is
not equipped with seats and safety belts. Be sure
everyone in your vehicle is in a seat and using a
safety belt properly.
Your vehicle has a light
that comes on as a reminder
to buckle up. See ªSafety
Belt Reminder Lightº in
the Index.
In most states and Canadian provinces, the law says to
wear safety belts. Here's why: They work.

1-26
Q:If I'm a good driver, and I never drive far from
home, why should I wear safety belts?
A:You may be an excellent driver, but if you're in an
accident
-- even one that isn't your fault -- you
and your passengers can be hurt. Being a good
driver doesn't protect you from things beyond your
control, such as bad drivers.
Most accidents occur within 25 miles (40 km)
of home. And the greatest number of serious
injuries and deaths occur at speeds of less than
40 mph (65 km/h).
Safety belts are for everyone.
How to Wear Safety Belts Properly
Adults
This part is only for people of adult size.
Be aware that there are special things to know about
safety belts and children. And there are different rules
for smaller children and babies. If a child will be riding
in your vehicle, see the part of this manual called
ªChildren.º Follow those rules for everyone's protection.
First, you'll want to know which restraint systems your
vehicle has.
We'll start with the driver position.
Driver Position
This part describes the driver's restraint system.
Lap-Shoulder Belt
The driver has a lap-shoulder belt. Here's how to wear
it properly.
1. Close and lock the door.
2. Adjust the seat so you can sit up straight.
To see how, see ªSeatsº in the Index.

1-52
Rear Safety Belt Comfort Guides for
Children and Small Adults
Your vehicle may have rear shoulder belt comfort
guides. This feature will provide added safety belt
comfort for older children who have outgrown booster
seats and for small adults. When installed on a shoulder
belt, the comfort guide better positions the belt away
from the neck and head.
There is one guide for each passenger position in the
second row rear seat. To provide added safety belt
comfort for children who have outgrown child restraints
and for smaller adults, the comfort guides may be
installed on the shoulder belts. Here's how to install a
comfort guide and use the safety belt:
Second Row Outside Positions

1-61
A booster seat (F-G) is a child restraint designed to
improve the fit of the vehicle's safety belt system.
Some booster seats have a shoulder belt positioner,
and some high
-back booster seats have a five-point
harness. A booster seat can also help a child to see
out the window.
Q:How do child restraints work?
A:A child restraint system is any device designed for
use in a motor vehicle to restrain, seat, or position
children. A built
-in child restraint system is a
permanent part of the motor vehicle. An add
-on
child restraint system is a portable one, which is
purchased by the vehicle's owner.
For many years, add
-on child restraints have used
the adult belt system in the vehicle. To help reduce
the chance of injury, the child also has to be
secured within the restraint. The vehicle's belt
system secures the add
-on child restraint in the
vehicle, and the add
-on child restraint's harness
system holds the child in place within the restraint.
One system, the three
-point harness, has straps that
come down over each of the infant's shoulders and
buckle together at the crotch. The five
-point
harness system has two shoulder straps, two hip
straps and a crotch strap. A shield may take the
place of hip straps. A T
-shaped shield has shoulder
straps that are attached to a flat pad which rests low
against the child's body. A shelf
- or armrest-type
shield has straps that are attached to a wide,
shelf
-like shield that swings up or to the side.

1-64
If you're using a top strap-equipped child restraint in the
second row center bench seat and need to temporarily
transport a flat tire for repair, move the child restraint to
a rear seat outboard position. See ªSecuring a Child
Restraint in a Rear Outside Seat Positionº for more on
this, including important safety information.
Once you have the top strap anchored, you'll be ready
to secure the child restraint itself. Tighten the top strap
when and as the child restraint manufacturer's
instructions say.
Your vehicle has top strap anchors already installed for
the rear seating positions. An anchor bar for a top strap
is located at the rear of the seat cushion for each second
row outboard seating position and the anchor bar for
the center position for the bench seat is located on the
floor behind the second row seats. If the vehicle has the
extended rear convenience center, you need to remove
a plastic plug and look under the convenience center to
find the anchor bar for the center position for the bench
seat. If the vehicle has a third row seat and the seatback
is upright, there is an anchor strap located between the
third row seatback and cushion to anchor the child
restraint for the second row center position bench seat.
If the vehicle has a third row seat and the seatback is
folded, there is anchor on the back of the third row
seat for the second row center position bench seat.There is also a top strap anchor for third row passenger's
side outside position. Locate the anchor symbol on the
flap of carpet behind the seat. Lift up the carpet to
access the anchor.
Captain's Chairs

1-65
Second Row Outside Positions Bench SeatSecond Row Center Position Bench Seat
without Third Row Seat

1-66
Second Row Center Position Bench Seat
with Third Row SeatSecond Row Center Position Bench Seat
with Third Row Seat Folded Down