2002 BUICK RANDEZVOUS headlamp

2-51 Lamps on Reminder
If the driver's door is opened and you turn the ignition
to OFF while leaving the lamps on, you will hear a
warning chime.
Daytime Running Lamps
Daytime Running Lamps (DRL) can make it easier for
others to see the front of your vehicle during the day.
DRL can be helpful in many different driving
conditions, but they can be especially helpful in the
short periods after dawn and before sunset. Fully
functional daytime running lamps are required on all
vehicles first sold in Canada.A light sensor on top of the instrument panel makes
the DRL work, so be sure it isn't covered. The DRL
system will make your reduced intensity high
-beam
headlamps come on in daylight when the following
conditions are met:

The ignition is on,

the exterior lamps control is in AUTO, and

the shift lever is not in PARK (P).
When the DRL are on, only your reduced intensity
high
-beam headlamps will be on. Your instrument panel
won't be lit up.
When it's dark enough outside, the exterior lamps will
come on automatically. When it's bright enough outside,
the exterior lamps will go out and the DRL will turn on.
Of course, you may still turn on the headlamps any time
you need to.
As with any vehicle, you should turn on the regular
headlamp system when you need it.

2-54
The lamps will fade out before the 25 seconds have
passed if the following conditions are met:

The ignition is turned to ON,

LOCK is pressed on the optional remote keyless
entry transmitter, or

the front of the power door lock switch is pressed.
If your vehicle is equipped with the Driver Information
Center (DIC), you can program this feature on or off.
See ªDriver Information Centerº in the Index.
Exit Lighting
With exit lighting, the interior lamps will come on for
about 30 seconds whenever you remove the key from
the ignition if the following conditions are met:

The vehicle is in PARK (P),

the key is out of the ignition,

the interior lamp control is in the DOOR
position, and

all of the doors are closed.
After 30 seconds have passed, the interior lamps will
slowly fade out.The interior lamps will slowly fade out before
30 seconds have passed, if the following conditions
are met:

The ignition is turned to ON,

LOCK is pressed on the optional remote keyless
entry transmitter, or

the front of the power door lock switch is pressed.
If your vehicle is equipped with the Driver Information
Center (DIC), you can program this feature on or off.
See ªDriver Information Centerº in the Index.Perimeter Lighting
The perimeter lighting feature will turn on the
headlamps and parking lamps for 25 seconds when the
following conditions are met:

The ignition is turned to OFF,

the exterior lamp control is in the AUTO position,

UNLOCK is pressed on the optional remote keyless
entry transmitter, and

it is dark enough outside.
After 25 seconds have passed, the headlamps and
parking lamps will turn off.

2-55
The lamps will turn off before the 25 seconds have
passed if the following conditions are met:

The ignition is turned to ON, or

the exterior lamp control is turned out of the
AUTO position.
To program the perimeter lighting feature, see ªRemote
Lock and Unlock Confirmationº under ªVehicle
Customizationº in the Index. If your vehicle is equipped
with the Driver Information Center (DIC), see ªDriver
Information Center, Remote Lock Feedbackº in
the Index.
Headlamp Exit Delay
The headlamp exit delay feature will turn on the
headlamps and parking lamps at night for 30 seconds if
the following conditions are met:

The ignition is turned to OFF,

the exterior lamp control is in the AUTO position,

LOCK is pressed on the optional remote keyless
entry transmitter, and

it is dark enough outside.
After 30 seconds have passed, the headlamps and
parking lamps will turn off.The lamps will turn off before the 30 seconds have
passed if the following conditions are met:

The ignition is turned to ON, or

the exterior lamp control is turned out of the
AUTO position.
To program the headlamp exit delay feature, see
ªVehicle Customizationº in the Index. If your vehicle is
equipped with the Driver Information Center (DIC), see
ªDriver Information Centerº in the Index.
Front Reading Lamps
There are two reading lamps located on the
rearview mirror.
To turn either reading lamp on or off, press the button
located next to each lamp.
These lamps will come on each time you open the
doors, if the interior lamp control is in the ON or
DOOR position.
Rear Reading Lamps
There are two reading lamps with coat hooks in the
second row headliner, above the rear doors.
To turn on or off either reading lamp, press the lens of
the lamp.

2-56
Cargo Lamp/Reading Lamp
The cargo lamp is located in the rear of the vehicle,
above the liftgate opening, and it has an on/off switch.
The lamp will go on each time you open the doors, if the
interior lamp control is in the DOOR position.
There are two reading lamps located on the cargo lamp.
To turn either reading lamp on or off, press the button
located next to the lamp.
Battery Saver
Your vehicle has a feature to help prevent you from
draining the battery, in case you accidentally leave the
interior or exterior lamps on. If the interior lamps are
left on while the ignition is in OFF, they will
automatically turn off after 10 minutes. If the exterior
lamps are left on while the ignition is in OFF with all
doors and the liftgate closed, they will automatically
turn off after 10 minutes.If your vehicle has less than 14 miles (24 km) on the
odometer, the battery saver will turn off the lamps after
only three minutes.
If the interior lamps are turned off as a result of the
battery saver feature, they may be turned back on by
turning the interior lamp control to OFF and then back
to ON. The battery saver will not turn the interior lamps
off automatically after doing this. They will have to be
turned off manually.
Mirrors
Inside Day/Night Rearview Mirror
To reduce glare from headlamps behind you, pull the
lever toward you (to the night position). To return
the mirror to the day position, push the lever away
from you.

2-57 Electrochromic Automatic Dimming
Rearview Mirror (If Equipped)
Your vehicle may have an electrochromic day/night
rearview mirror. Push the button in the center of the
mirror to turn this feature on. The mirror will darken
gradually to reduce glare from headlamps behind you.
This may take a few moments. The mirror will also
lighten whenever you shift to REVERSE (R).
The mirror's two outer buttons operate the lights on the
bottom sides of the mirror.
One photocell on the front of the mirror senses when it
is becoming dark outside. Another photocell, facing
rearward, senses headlamps behind you.To turn the electrochromic feature off, press the button
in the center of the mirror again.
To keep the photocells operating well, occasionally
clean them with a cotton swab and glass cleaner.
Power Outside Rearview Mirrors
The power mirror
controls are located
on the driver's
door armrest.
To choose either the left or right outside mirror,
press the selector switch. Press any of the four arrows
located on the control pad to move the mirrors in the
desired direction.
Adjust each mirror so you can see the side of your
vehicle and the area behind your vehicle.

2-104
Park Lamp Warning Message
United States Canada
If you receive this message, one or both of the
vehicle's parking lamp bulbs needs replacement.
See ªBulb Replacementº in the Index for bulb
replacement instructions.
Highbeam Out Warning Message
United States Canada
If you receive this message, one or both of the vehicle's
high
-beam headlamp bulbs needs replacement. See
ªBulb Replacementº in the Index for more information.

2-111
Headlamp Exit Delay
This feature allows you to customize the headlamps and
parking lamps. This feature can be programmed to one
of the following modes:
OFF: The headlamps and parking lamps will not turn on
at the same instant that the ignition is turned to OFF.
15: The headlamps and parking lamps will stay on for
15 seconds when the ignition is turned to OFF.
30: The headlamps and parking lamps will stay on for
30 seconds when the ignition is turned to OFF.
60: The headlamps and parking lamps will stay on for
60 seconds when the ignition is turned to OFF.Before your vehicle was shipped from the factory, it
was programmed in 30
-second activation mode. The
mode to which the vehicle has been programmed
may have been changed since it left the factory.
To determine the mode to which your vehicle is
programmed or to program your vehicle to a different
mode, do the following:
1. Follow the instructions for ªEntering Programming
Modeº listed previously.
2. Press the MODE button until HEADLMP EXIT
DELAY appears in the DIC.
3. Press the SET button until the arrow is before the
mode you prefer.
The mode you selected is now set. You can either exit
programming mode by following the instructions later in
this section or program the next feature available on
your vehicle.

2-118
Unlock Feedback
The unlock feedback feature can be programmed to one
of the following modes:
LIGHTS: This mode does the following:

During the day, when the ignition is in OFF and
UNLOCK on the remote keyless entry transmitter
is pressed, the headlamps and parking lamps will
flash, or

during the night, when the ignition is in OFF and the
headlamp exit delay feature is programmed to any
mode but OFF, the headlamps and parking lamps
will be activated for the same time period as the
headlamp exit delay feature is programmed to when
UNLOCK is pressed on the remote keyless entry
transmitter (see ªHeadlamp Exit Delayº earlier in
this section), or

during the night, when the ignition is in OFF and the
headlamp exit delay feature is programmed to OFF,
the headlamps and parking lamps will be activated
for 30 seconds when UNLOCK is pressed on the
remote keyless entry transmitter (see ªHeadlamp
Exit Delayº earlier in this section).OFF: The headlamps and parking lamps will not
flash when UNLOCK is pressed on the remote keyless
entry transmitter.
Before your vehicle was shipped from the factory, it was
programmed in LIGHTS. The mode to which the
vehicle has been programmed may have been changed
since it left the factory. To determine the mode to which
your vehicle is programmed or to program your vehicle
to a different mode, do the following:
1. Follow the instructions for ªEntering Programming
Modeº listed previously.
2. Follow the instructions for programming
HEADLAMP EXIT DELAY earlier in this section,
to make sure which mode it is programmed to.
3. Press the SET button until UNLOCK FEEDBACK
appears on the DIC.
4. Press the MODE button until the arrow is before
LIGHTS or OFF.
5. Press the SET button once you have determined
which mode you prefer.
The mode you selected is now set. You can either exit
programming mode by following the instructions later in
this section or program the next feature available on
your vehicle.