3-6
NOTICE:
Don't use a razor blade or something else sharp
on the inside of the rear window. If you do, you
could cut or damage the warming grid or the
integrated rear window antenna, and the repairs
wouldn't be covered by your warranty.
Passenger Climate Control
The front seat passenger can control the air temperature
in his or her seating area. This can be set up to 5F
(3C) cooler or warmer than the primary setting. You
can activate this feature by sliding the lever located on
the right side of the instrument panel toward WARM
or COOL.
If the passenger climate control has been turned on, it
can be turned off by pressing the OFF button on the
climate control system faceplate once. Pressing the OFF
button a second time will turn off the main system.
Personal Choice Comfort Controls
(If Equipped)
This feature enables up to two drivers to store and recall
comfort control settings for the temperature, fan speed
and the direction of the air flow.
The memory buttons (1 or 2) for this feature are located
on the driver's door panel and correspond to the
numbers (1 or 2) found on the back of each remote
keyless entry transmitter.
To recall comfort settings, press the unlock button on the
remote keyless entry transmitter and put the ignition in
ACCESSORY or RUN. The climate control setting last
chosen by the identified driver (1 or 2) will be recalled.
3-7
To program a personal choice comfort control setting,
do the following:
1. Choose a climate control setting for the driver and
if desired, for the passenger. See ªDual Automatic
ComforTemp Climate Controlº and ªPassenger
Climate Controlº earlier in this section.
2. Locate the memory buttons on the driver's door panel.
3. Press a memory button (1 or 2) until you hear two
beeps. The beeps confirm that your selection has
been saved and can now be recalled.
Follow these steps each time you want to change the
stored settings. For more information on the memory
feature, see ªMemory Seat and Mirrorsº in the Index.
Ventilation System
For mild outside temperatures when little heating or
cooling is needed, use VENT in manual mode to direct
outside air through your vehicle. Air will flow through
any of the outlets depending on outside temperatures
and climate control settings.
Your vehicle's flow
-through ventilation system supplies
outside air into the vehicle when it's moving. When the
vehicle is not moving, you can get outside air to flow
through your vehicle by pressing VENT and then using
the AIR FLOW button to select a mode and the FAN
button to select a fan speed.
Change the direction of
airflow by adjusting the
louvered vents.
You have rear passenger
ComforTemp outlets that
you can use to change the
direction of the airflow to
the rear seating area. The
temperature is controlled by
the front passenger.
