2002 BMW MOTORRAD K 1200 GT ABS

3
75
Starting – Riding – Parking
Brake system - with BMW Integral ABS
RESIDUAL BRAKING
FUNCTION
If the BMW Integral ABS develops
a fault, a RESIDUAL BRAKING
FUNCTION only is available in the
brake circuits in question.
The RESIDUAL BRAKING FUNC-
TION is the braking efficiency
without the hydraulic servo assist-
ance of the BMW Integral ABS.
Under these circumstances,
therefore, you must apply CON-
SIDERABLY higher pressure to
the brake levers in question in
order to apply the brakes, and
lever travel is longer.
When the RESIDUAL BRAKING
FUNCTION is active, the ABS
function is unavailable in the
brake system in question.
When the RESIDUAL BRAKING
FUNCTION is active, the integral
braking function is partially or
entirely unavailable.
d Warning:
When the RESIDUAL BRAKING
FUNCTION is active, maintain a
defensive riding style and pro-
ceed immediately to the near-
est specialist workshop,
preferably an authorised BMW
motorcycle dealer.
L Note:
When the RESIDUAL BRAKING
FUNCTION for the front brake is
active, it is advisable to set ad-
juster A (
b 33) of the handbrake
lever to position 4.
The RESIDUAL BRAKING
FUNCTION is active under the
following circumstances:
– Ignition off
– Before and during self- diagnosis (
b 76)
– Fault in the BMW Integral ABS (
b 79)
L Note:
When the RESIDUAL BRAKING
FUNCTION is active for both
brake circuits, the noise of the
pump is no longer audible when
you operate the brake levers.
10k41bkg2.book Seite 75 Donnerstag, 24. Juli 2003 9:17 09

76
Starting – Riding – Parking
3
Self-diagnosis with pull-
away test
The BMW Integral ABS performs
self-diagnosis and a pull-away
test to ensure its operability.
Self-diagnosis is performed auto-
matically when you switch on the
ignition.
d Warning:
Self-diagnosis is not performed
unless both brake levers are in
their fully released positions.
Only the RESIDUAL BRAKING
FUNCTION is available until
self-diagnosis is completed
(b 75).
*n depending on national-market
specification
• Release the brake levers, if necessary
 Switch on the ignition
Initially:
– ABS warning light 1:
Flashes at 4 Hz
– General warning light 2:
ON
bSelf-diagnosis is in
progress
Then:
– ABS warning light 1:
Flashes at 1 Hz
– General warning light 2:
OFF
bSelf-diagnosis successfully
completed
Brake system - with BMW Integral ABS
1*2
10k4103g2.fm Seite 76 Montag, 4. August 2003 2:32 14

3
77
Starting – Riding – ParkingStart the engine.
 Move off
– ABS warning light1:
OFF (as of approx. 5 km/h
(3 mph) road speed)
bPull-away test successfully
completed
bBMW Integral ABS is
available
L Note:
Flashing at 1 Hz = 1 flash per
second (slow flashing)
Flashing at 4 Hz = 4 flashes per
second (fast flashing)
L Note:
Starting on gradients:
Always switch on the ignition
with gear engaged, clutch lever
released and both brake levers
released.
Self-diagnosis cannot be per-
formed if you do not follow this
procedure.
When self-diagnosis com-
pletes, apply the brakes, disen-
gage the clutch, and start the
engine.
*n depending on national-market
specification
1*2
Brake system - with BMW Integral ABS
10k41bkg2.book Seite 77 Donnerstag, 24. Juli 2003 9:17 09

78
Starting – Riding – Parking
3
d Warning:
If the BMW Integral ABS fails
in both brake circuits, a RE-
SIDUAL BRAKING FUNCTION
only is available (b 75).
d Warning:
If the RESIDUAL BRAKING
FUNCTION (
b 75) is active,
maintain a defensive riding
style and proceed immediate-
ly to a specialist workshop,
preferably an authorised BMW
motorcycle dealer.
*n depending on national-market
specification
d Warning:
If there is a fault in the ABS
system, the reserves of safety
normally afforded by ABS are
not available until the defect
has been put right.
There is a risk of dropping the
motorcycle if the brakes are
applied too hard and the
wheels lock or the rear wheel
lifts clear of the ground as a
r e su l t o f a h i g h le v e l o f t yr e ad -
hesion. Have the defect recti-
fied immediately by a
specialist workshop, prefera-
bly an authorised
BMW motorcycle dealer.
1*2
Brake system - with
BMW Integral ABS
10k41bkg2.book Seite 78 Donnerstag, 24. Juli 2003 9:17 09

3
79
Starting – Riding – Parking
BMW Integral ABS - Troubleshooting
OEOptional extra
Warning light,
generaleABS warning
light
l Malfunctions
OFF ON Only RESIDUAL BRAKING FUNCTION available in both circuits (
b 75)
OFF Flashes at 1 HzABS not available
Pull-away test not completed (
b 76)
OFF Flashes at 4 HzOnly RESIDUAL BRAKING FUNCTION
available in both circuits (
b 75)
Self-diagnosis not completed (b 76)
ON OFF Rear light/brake light defective (
b Maintenance Instructions, Chapter 2)
Cruise-control systemOE not available.
ON Flashes at 1 HzAt least one brake circuit without
ABS (
b 78)
ON Flashes at 4 HzAt least one brake circuit in RESIDUAL
BRAKING FUNCTION mode (
b 75)
Alternate
flashing at
1 Hz Alternate
flashing at
1 HzFluid level in BMW Integral ABS too low.
Check the motorcycle as follows:
– Ignition OFF: is brake pressure OK at
the brake levers?
– Are the brakes acting on both wheels?
– Is the brake system leaktight, no signs of brake fluid escaping?
The brake system is defective if the test
outcome is negative.
Alternate
flashing at
4 Hz Alternate
flashing at
4 HzFluid level in the BMW Integral ABS is too
low, perform the checks listed above.
Only RESIDUAL BRAKING FUNCTION
available in at least one circuit (
b 75)
d Warning:
Do not ride the motorcycle if you have
any doubts about the dependability of
the brake system.
10k41bkg2.book Seite 79 Donnerstag, 24. Juli 2003 9:17 09

88
Index
i
AABSFault, 78
ABS - anti-lock brake system, 74
Adjusting footrest plate, 19
Adjusting headlight beam throw,
50, 51, 52
Adjusting headlight for opposite rule of the road, 51
Adjusting headlight for RHD/LHD traffic, 51
Anti-lock Brake System Notes, 74-79
Anti-lock brake system, 72
BBMW Integral ABS, 72-79 ABS - Anti-lock Brake System,
74
Brake booster, 74
Brake-fluid reservoir, 5
Changing brake fluid, 36
Checking brake fluid level, 36
RESIDUAL BRAKING
FUNCTION, 75
Safety reserves, 73
Self-diagnosis with pull-away
test, 76
Sensitive electronic control, 72
Troubleshooting chart, 79
Brake booster, 74 Brake fluid level
CheckFront brake, 38
Rear brake, 39
Brake system with BMW Integral ABS, 36,
37, 38
Brake system, general, 34, 35
Brake system, checking, 34
CCapacity, 31
Case, 23
Catalytic convertor Safety instructions, 57
Checking brake pads, 35
Checking oil level, 28
Clock, 7
Clock (in cockpit), 7
Closing the system case, 24
Clutch lever, adjusting, 32
Cockpit Overview, 6
Cockpit instruments, 6
Coolant level Check, 40, 41
Coolant temperature, 66
Coolant temperature gauge, 6
Cruise control, 14, 15
Cruise-control system
Notes, 14
Operation, 16, 17
A - D
10k41bkg2.book Seite 88 Donnerstag, 24. Juli 2003 9:17 09

91
Index
i
TTank cap, 4
Telltale and warning lightsABS, 7, 66
Battery charge current, 8
Battery charge light, 67
Coolant temperature, 8, 67
Cruise control, 7
Engine oil pressure, 8, 66
High-beam headlight, 8
Low fuel level, 8, 66
Neutral, 7
Turn indicator, right, 7
Telltale lights Turn indicator, left, 7
Toolkit, 4
Tools, 4, 20
Tread depth, tyres, 45, 46
Troubleshooting ABS, 79
Troubleshooting chart, 79
Turn indicator switch, left, 12
Turn-indicator cancel switch, 13
Tyres
Inflation pressure, 46
Running in, 63WWarning lightLow fuel level, 66
Warning lights
ABS, 66
Battery charge light, 67
Coolant temperature, 67
Engine oil pressure, 66
General, 66
Warnings
Braking, 70
T - Z
10k41bkg2.book Seite 91 Donnerstag, 24. Juli 2003 9:17 09