2002 BMW M3 COUPE jump start

Contents

Owner service procedures
Technical data
Index

Replacement procedures:

Onboard tool kit120
Windshield wiper blades120
Lamps and bulbs120
Repairing a flat tire126
Battery130
Fuses130

Giving and receiving
assistance:

Jump-starting131
Towing the vehicle132Engine data136
Dimensions137
Weights138
Capacities139Everything from A to Z142

108n
Engine compartment essentials1 Filler neck for headlamp and
wind-
shield washer system109
2 Coolant expansion tank112
3 Positive terminal connection for
jump-starting (positive terminal)131 4 Engine oil filler neck110
5 Expansion tank for SMG
* hydraulic
unit (checking and possible refilling
by your BMW center)596 Engine oil dipstick110
7 Filler neck for brake fluid113

130n
Battery Fuses
Battery posts, terminals, and
related accessories contain lead
and lead compounds. Wash hands after
handling.<
Battery careThe battery is completely maintenance-
free. That means that the original
battery acid will normally last for the
service life of the battery under
moderate climate conditions.
Please consult your BMW center
whenever you have any questions
concerning the battery. Since the
battery is absolutely maintenance-free,
the following statements are for your
information only.<
Never disconnect the battery
when the engine is running; the
ensuing voltage surge would seriously
damage the vehicle's onboard elec-
tronic systems.<
Charging the battery Charge the battery in the vehicle only
when the engine is not running. Use the
connections provided in the engine
compartment (for correct connections,
refer to "Jump-starting" on page 131.
Return used batteries to a recy-
cling point or your BMW center.
Maintain the battery in an upright posi-
tion for transport and storage. Secure
the battery against tilting in transit.<
Open the glove compartment and turn
the two white quick-release fasteners
outward.
Do not attempt to repair a burned
fuse or replace it with a fuse
having a different color or ampere
rating. To do this could cause a fire in
the vehicle resulting from a circuit over-
load.<

131n
OverviewControlsMaintenanceRepairsDataIndex
Do not use spray starter fluids to start
the engine.
When your battery is discharged you
can use two jumper cables to start your
vehicle with power from the battery in a
second vehicle. You can also use the
same method to help start another
vehicle. Use only jumper cables with
fully insulated handles on the terminal
clamps.
Do not touch the parts conducting
current while the engine is
running. Failure to comply with this
creates a risk of fatal injury.
Carefully observe the following instruc-
tions to avoid personal injury and/or
damage to one or both vehicles.<
1. Ensure that the battery in the support
vehicle is also rated at 12 volts. This
information is provided on the top of
the battery casing
2. Do not disconnect your battery from
your vehicle's electrical system.
Switch off all electrical accessories in
both vehicles
3. Make absolutely certain that there is
no contact between the bodywork of
the two vehicles Ð short circuit
hazard
4. Start the engine on the support
vehicle and allow it to run
5. Use one jumper cable (+) to connect
the positive terminal of the battery in
the support vehicle with the auxiliary
positive terminal provided in the
engine compartment of your BMW
specifically for jump-starting. The
cover of the positive terminal
connector is marked with a "+" sign.
Refer to the illustration. Remove by
pulling the tab (arrow 1)
6. Next, connect one end of the other
jumper cable (-) to either the support
vehicle's negative battery terminal or
a suitable ground on its engine or
bodywork. Connect the other end to
the negative battery terminal or a
suitable ground on the vehicle being
started. There is a special nut
provided for this on the BMW
(arrow 2)
Always adhere to this sequence
when connecting jumper cables;
failure to observe this procedure can
lead to sparks at the battery terminals
and pose an injury hazard.<
7. Allow the engine of the support
vehicle to run at a fast idle for several
minutes, then start the engine on the
vehicle with the discharged battery in
the usual manner. If the first start
attempt is not successful, wait a few
minutes before another attempt in
order to allow the discharged battery
to recharge
8. Allow the engines to run for several
minutes before disconnecting the
jumper cables
9. Then disconnect the jumper cables
in the opposite order.
Have the battery recharged at your
BMW center as required.
Jump-starting

132n
Towing the vehicleTow fittingThe tow fitting, which can be
unscrewed, is in the luggage compart-
ment under the floor panel and must
remain in the vehicle. This fitting
is designed for installation in the tow
sockets located at the front and rear of
the vehicle. It is intended for towing on
paved road surfaces only.
It should not be used to pull a vehicle
out of deep snow, mud, sand, etc.
Comply with all applicable towing laws
and regulations at all times.Access to tow socketsFront:
Press out the cover panel with a screw-
driver above on the recess.
Rear:
Press out the cover panel with a screw-
driver above on the recess.
Screw the tow fittings in until they
are tight. If you do not, the threads
could be damaged.
Do not tow the vehicle by any compo-
nents of the running gear, or lash them
down in any way. If you do, the compo-
nents could be damaged, leading to
possible accidents.<
Keep the vehicles in line and avoid
towing at an offset angle. Ensure
that the tow rope connecting the two
vehicles is tight, with no slack, before
starting off.<
Use only a nylon towing strap to tow
the vehicle, since the inherent resil-
ience of this material helps protect both
vehicles from sudden jerking move-
ments.
The towed vehicle should always
be the lighter of the two vehicles.
If this is not the case, it will not be
possible to control vehicle handling. to page 131.
Never attempt to use your vehicle to
push another vehicle, since damage to
the energy-absorbing bumpers could
result.

Everything from A to Z
145n
OverviewControlsMaintenanceRepairsDataIndex
INSPECTION71
Instrument cluster15
Instrument lighting81
Instrument panel15
Interface socket
for Onboard
Diagnostics116
Interior lamps31, 82
remote control31
Interior motion
sensor37, 38
avoiding unintentional
alarms38
deactivate31
operating via remote
control31
Interior rearview mirror with
automatic dimming
feature49 J
Jump-starting131 K
Key28
with remote control28
Key Memory55
L
Lamps80, 120
LAMPS ON warning80
Lashing eyes97
LATCH child-restraint
system installation53
Leather care, refer to the
"Caring for your vehicle"
manual
Length137
License plate lamp
bulb replacement125t
Lighting, refer to lamps
Load-securing devices97
Locking luggage
compartment lid
separately34
Louvers83, 86
Low ambient
temperatures111
Low beams80
bulb replacement121t
Luggage compartment
capacity138
floor mat36
floor panel36
lighting34
operating via remote
control31 Luggage compartment
lid34
electrical malfunction34
emergency release from
luggage compartment's
interior36
locking it separately34
manual operation34t
Luggage rack97
Lumbar support,
adjusting43
M
M Engine dynamics
control79
M+S-tires106
Maintenance71, 114
Malfunction displays72
Manual operation
doors29t
fuel filler door22t
luggage compartment
lid34t
sliding/tilt sunroof41t
Manual transmission58
Master key28 MFL (Multifunction steering
wheel)21
Microfilter85, 89
Mirror memory46
Mirrors48
automatic curb
monitor48
Modifications,
technical10, 115
Multifunction steering wheel
(MFL)21
N
Navigation system, refer to
the "Onboard Computer
Owner's Manual"
Neckrest44 O
OBD interface socket116
Obstruction protection39
Odometer70
Oil
additives111
capacity139
quality111
specifications111
viscosity111