4
Central Body Electronics ZKE III
System Components
General Module (GM): The GM is reponsible
for the operation and central coordination of
body electronics. The GM is a micro-computer
that is the central component (heart) of the
Central Body Electronics. The GM is located be-
hind the glove box.
The main objectives for using the GM are:
The GM requires inputcommands to perform
Central Body Electronics functions. The inputs
are supplied by digital switched signals such
as:
• Trunk Lock Microswitch - supplies voltage (KL
30) to the GM when switched. A path to gro-
und is provided by the GM (internally). The
GM monitors the switched input voltage.
• Central Lock Button - supplies a ground cir-
cuit to the GM when switched. The GM sup-
plies and monitors a reference voltage (5v)
that is “pulled” low when the switched gro-
und path is provided.
The GM processesthe input information and
contains “coded” instructions that allow a spe-
cific output control of functions.
The GM will produce outputfunctions using
internal transistors to switch current flow (pro-
viding voltage or ground) through circuits and
actuators. Actuators are the final controlling
devices used by the GM to operate or control
various output functions such as relays and
motors.
• Increase Overall Reliability
• Centralize Electronic Systems
• Decrease Assembly and Service Repairs
• Centralized Diagnosis of all ZKE Components
• Individualization of Features (Coding)
CENTRAL LOCK BUTTONCENTRAL LOCK BUTTON
TRUNK LOCK BUTTONTRUNK LOCK BUTTON
KL 30KL 30
TRUNK LOCK MICROSWITCHTRUNK LOCK MICROSWITCHSignal Monitor
5v
Supply/
Monitor
GM
FUEL
FILLER
FLAP
RELAY
Transistors
GM
12520101.eps
Workshop Hints
Remote Key Initialization: The initialization of the FZV keys is required to establish the
Lock/Unlock signal synchronization with the GM. The initialization procedure provides the
GM with a key identification number and a “rolling code” for each key. If the initialization is
not performed, the GM will not respond to the key signals.
Up to 4 remote keys can be initialized. They must be initialized at the same time. Key ini-
tialization is only possible with the vehicle unlocked.
Procedure:
1. Close all doors and have all keys available.
2. Using key number 1, turn the ignition switch to KL
R, then switch off within 5 seconds and remove the
first key.
3. Within 30 seconds of turning the ignition switch to
“off” Press and holdbutton #2.
4. While holding button #2, press and release(“tap”)
button #1 three timeswithin 10 seconds.
5. Release both buttons. The LED in the key will flash
momentarily (except 2000 MY). The GM will imme-
diately lock and unlock the doors signaling a suc-
cessful initialization.
6. If additional keys need to be initialized repeat steps
3 - 5 within 30 seconds.
7. Switching the ignition to KL R completes the initiali-
zation.
NOTE: The key memory function of the GM responds
to the key identification number of each key. If the keys
are not initialized in the same order prior to initialization,
the key memory functions activated by the keys will not
be assigned correctly. Always initialize the keys in
the same order.
30
Central Body Electronics ZKE III
1
2
615200101.eps
