µYour dealer will reset this indicator
af ter completing the scheduled
maintenance. If this maintenance is
done by someone other than your
Acura dealer, reset the indicator as
f ollows.
Turn of f the engine.
For the f irst 6,000 miles (9,600 km)
af ter the Maintenance Required
Indicator is reset, it will come on f or
two seconds when you turn the
ignition switch ON (II). Between 6,000 miles (9,600 km) and
7,500 miles (12,000 km) this
indicator will light f or two seconds
when you f irst turn the ignition
switch ON (II), and then f lash f or
ten seconds.
Press and hold the select and reset
buttons next to the instrument pan-
el, then turn the ignition switch
ON (II).
Hold the buttons for
approximately ten seconds until
the indicator resets.
This indicator reminds you that it is
time to take your car in for
scheduled maintenance.
If you exceed 7,500 miles (12,000
km) without having the scheduled
maintenance perf ormed, this
indicator will remain on as a constant
reminder.
Ref er to the Maintenance Schedules
f or Normal and Severe Driving
Conditions on pages . 1.
2.
3.
218 222
Gauges
Inst rument s and Cont rols
Maintenance Required Indicator
61
S SE EL
LEE C
CT T
B
BU UT TT
TO
ON N
R
RE ES
SE ET
T
B
BU UT TT
TO
ON N
M
M
A
AI
INNT TE
EN
NA AN
NC CEE R
REEQ
QU UIIRRE ED
D I
INND DI
ICCA A T
TO
OR R
01/09/28 19:35:16 31SZ3660_064
If you unlock the doors with the
remote transmitter, but do not open
any of the doors within 30 seconds,
the doors automatically relock and
the security system sets.
You cannot lock any of the doors
with the remote transmitter if any
door is not f ully closed or the key is
in the ignition switch. You cannot
unlock any of the doors with the key
in the ignition switch.
To open the trunk, push the Trunk
Release button f or approximately
one second.
You can open the trunk with the
remote transmitter regardless of the
position of the main switch in the
glove box. The trunk will not open if
the key is in the ignition switch.You can program the keyless entry
system so it does not beep when you
lock and unlock the doors. This
procedure only turns of f the beep;
the exterior lights will still f lash.
To turn this feature off, stand near
the car with the remote transmitter.
Press and hold the Trunk Release
button, then press the Lock button
within one second. You should see
the LED on the remote transmitter
come on f or one second. Release the
buttons af ter the LED goes out.
To turn this feature on, repeat the
above procedure. You should see the
LED blink twice.
Af ter you program the remote
transmitter, make sure the trunk lid
is closed.Panic mode allows you to remotely
activate your car’s security system to
attract attention. When activated, the
horn will sound, and the exterior
lights will f lash, f or about 30 seconds.
To activate panic mode, press and
hold the PANIC button for about two
seconds.
To cancel Panic mode bef ore 30
seconds, press any button on the
remote transmitter. You can also
turn the ignition switch to ON (II).
Panic mode will not activate if the
ignition switch is in the ON (II)
position.T urning t he Beep Of f and On
Panic Mode
Keys and Locks
Inst rument s and Cont rols80
01/09/28 19:38:11 31SZ3660_083
Press and release the MEMO
buttononthecontrolpanel.You
will hear a beep. Immediately
press and hold one of the memory
buttons (1 or 2) until you hear two
beeps. The indicator light in the
memory button will come on. The
current positions of the driver’s
seat, steering wheel, and outside
mirrors are now stored.
Your Acura has a memory f eature
f or the steering wheel, driver’s seat,
and outside mirror positions.
Turn the ignition switch ON (II).
You cannot add a new driving
position in the memory unless the
ignition switch is ON (II). You can
recall a memorized position with
the ignition switch in any position.
Store a driving position as explained
in this section only when the car is
parked.
Two seat, steering wheel, and
outside mirror positions f or dif f erent
drivers or driving conditions can be
stored in separate memories. You
select a memorized position by
pushing the appropriate button.
Adjust the seat to a comfortable
position (see page ). Adjust
the steering wheel to a
comf ortable position (see page). Adjust the outside mirrors
f or best visibility (see page ). 3.
1.
2.
71 86
91
CONT INUED
St oring a Driving Posit ion in Memory
Driving Posit ion Memory Syst em
Inst rument s and Cont rols93
M ME
EM
M O
O B
BUUT TT
TO
ON N
01/09/28 19:40:19 31SZ3660_096
To set the clock:Turn the ignition switch ON (II) to
display the time.
Swing down the f ront cover of the
wide button to the right of the
clock display. You will see HOUR,
MIN., and RESET buttons. Press and hold the HOUR button
until the hour advances to the
desired hour.
Press and hold the MIN. button
until the numbers advance to the
desired time.
You can use the RESET button to
quickly set the time to the nearest
hour. If the displayed time is bef ore
the half hour, pressing the RESET
buttonsetstheclockbacktothe
previous hour. If the displayed time
is af ter the half hour, pressing the
RESET button sets the clock f or-
ward to the beginning of the next
hour.
1:06 would RESET to 1:00.
1:52 would RESET to 2:00.
For example:
1.
2. 3.
4.
Digital Clock
Inst rument s and Cont rols103
H H
O
OU URR R
REES
SE ET
T
M
M I
INN. .
01/09/28 19:41:59 31SZ3660_106
You can manually select the f an
speedbyturningthefancontroldial.
When you turn the dial clockwise,
the fan is taken out of automatic
mode and starts to run at its lowest
speed. Turning the dial f ully
clockwise increases the f an’s speed,
which increases air flow.Use the MODE button to select the
vents the air flows from. Some air
will f low f rom the side vents and the
dashboard corner vents in all modes.
Each time you press the MODE
button, the display shows the mode
selected. Press the button four times
to see all the modes.
These two buttons control the
source of the air going into the sys-
tem. In Fresh Air mode ( ),
air is brought in f rom outside the ve-
hicle. In Recirculation mode
( ), air f rom the car’s interior
is sent through the system again.
You can, f or example, manually put
the system in recirculation mode
when driving through an area of
smoke or f umes. When you press
the or button, the
light in that button comes on.
Climat e Cont rol Syst em
Comf ort and Convenience Feat ures
Mode Button
Recirculat ed and Fresh A ir
Fan Cont rol Dial
118
M MO
ODDE
E B
BUUT TT
TO
ON N F
FAA N
N C
COON NTTR
RO OL L D
DI
IAA L
L
R
RE EC
CI IRRC CUUL LAA T
TE
ED
D A
AI
IRR F
FRRE ES
SH H A
AI
IRR
01/09/28 19:44:00 31SZ3660_121
Î
Î
Your Acura’s audio system provides
clear reception on both AM and FM
bands, while the preset buttons allow
you to easily select your f avorite
stations.
The cassette system f eatures Dolby
noise reduction, automatic sensing of
chromium-dioxide (CrO ) tape, and
auto-reverse f or continuous play.
The anti-thef t f eature will disable the
system if it is disconnected f rom the
car’s battery. To get the system
working again, you must enter a
code number (see page ).156
2
Dolby noise reduction manuf actured under
license from Dolby Laboratories Licensing Corpo-
ration. ‘‘DOLBY’’ and the double-D symbol are trademarks of Dolby Laboratories
Licensing Corporation.
A M/FM/Cassette Stereo A udio
System3.5 RL wit hout Navigat ion Syst em
3.5 RL wit h Navigat ion Syst em
Audio System
Comf ort and Convenience Feat ures128
01/09/28 19:45:31 31SZ3660_131
µµ
µ
µ´ ´ µ
You can use any of three methods to
f ind radio stations on the selected
band: TUNE, SEEK, or the Preset
buttons.
Use the TUNE knob to
tune the radio to a desired f requency.
Turn the TUNE knob to the right to
tune to a higher f requency, or to the
lef t to tune to a lower f requency.
Turn the knob right or lef t until the
display reaches the desired
f requency. You can store the
f requencies of your f avorite radio
stations in the six preset buttons.
Each button will store one f requency
on the AM band, and two
f requencies on the FM band.
The SEEK f unction
searches the band for a station with
a strong signal. To activate it, push ei-
ther side of the SEEK/SKIP buttons
( or ). Push the button to
scan up f rom the current f requency,
andthe buttontoscandown.It
stops when it finds a station with a
strong signal.
The band and f requency that the ra-
dio was last tuned to is displayed. To
change bands, press the AM/FM but-
ton. On the FM band, ST will be dis-
played if the station is broadcasting
in stereo. ST will flash if you are driv-
inginanareawheretheradiosignal
is weak. Stereo reproduction on AM
is not available. The ignition switch must be in
ACCESSORY (I) or ON (II) to
operate the audio system. Turn the
system on by pushing the PWR/
VOL knob or the AM/FM button.
Adjust the volume by turning the
knob.
CONT INUED
TUNE
Preset
SEEK
Operating the Radio
Audio System
Comf ort and Convenience Feat ures
3.5 RL wit hout Navigat ion Syst em
129
01/09/28 19:45:42 31SZ3660_132
µIf you are
traveling far from home and can no
longer receive the stations you
preset, you can use the Auto Select
feature to find stations in the local
area.
To activate Auto Select, press the
A. SELECT button. A. SELECT will
appear in the display, and the system
will go into scan mode f or several
seconds. It automatically scans both
bands, looking f or stations with
strong signals. It stores the f requen-
cies of six AM stations and twelve
FM stations in the preset buttons.
You can then use the preset buttons
to select those stations.
If you are in a remote area, Auto
Select may not f ind six strong AM
stations or twelve strong FM stations.
If this happens, you will see a ‘‘0’’
displayed when you press any preset
button that does not have a station
stored. With Auto Select on, you cannot
manually store any f requencies in
the preset buttons. If you do not like
the stations found by Auto Select,
you can use the TUNE and SEEK
f unctions to f ind other stations.
Auto Select does not erase the
f requencies that you preset pre-
viously. When you return home, turn
of f Auto Select by pressing the
A. SELECT button. The preset
buttons will then select the fre-
quencies you originally set.
AUTO SELECT
Audio System
Comf ort and Convenience Feat ures131
A A
M
M /
/F
FM M B
BUUT TT
TO
ON NA
A
U
UT TO
O S
SEEL
LEE C
CT T I
INND DI
ICCA A T
TO
OR R
A
A U
UT TO
O S
SEEL
LEE C
CT T B
BUUT TT
TO
ON N
P
P R
RE ES
SE ET
T B
BUUT TT
TO
ON NSS T
T
U
UN NEE
K
KN NO OBB
S
SE EE
EK
K/ /S
SK KIIPP
B
BU UT TT
TO
ON NSS
01/09/28 19:46:00 31SZ3660_134