Page 300 of 343

This indicator comes on f or a f ew
seconds when you turn the ignition
switch ON (II). If it comes on at any
other time, it indicates one of the
engine’s emissions control systems
may have a problem. Even though
you may f eel no dif f erence in your
car’s perf ormance, it can reduce
your f uel economy and cause your
car to put out excessive emissions.
Continued operation may cause
serious damage.If the indicator remains on past three
driving trips, or the f uel cap was not
loose or missing, have the car
checked by the dealer as soon as
possible. Drive moderately until the
dealer has inspected the problem.
Avoid full-throttle acceleration and
driving at high speed.
Youshouldalsohavethedealer
inspect your car if this indicator
comes on repeatedly, even though it
may turn of f as you continue driving. If you have recently ref ueled your
car, the cause of this indicator
coming on could be a loose or
missing f uel f ill cap. Check the cap
and tighten it until it clicks several
times. Replace the fuel fill cap if it is
missing. Tightening the cap will not
make the indicator turn of f
immediately; it takes at least three
driving trips.
Malf unction Indicator L amp
T aking Care of t he Unexpect ed297
M M
A
AL
LFFUUN NCCTTI
IOON N I
INND DI
ICCA A T
TO
OR R L
LAA M
M P
P
If you keep driving with the
malf unction indicator lamp on, you can
damage your car’s emissions controls
and engine. Those repairs may not be
covered by your car’s warranties.
01/09/28 20:13:47 31SZ3660_300
Page 302 of 343

Î
Î
Î
Î
If you must drive the car a short
distance in this condition, drive
slowly and cautiously.
If it comes on at any other time, it
indicates a problem with the car’s
brake system. In most cases, the
problem is a low f luid level in the
brake f luid reservoir. Press lightly on
the brake pedal to see if it f eels
normal. If it does, check the brake
f luid level the next time you stop at a
service station (see page ). If the
fluid level is low, take the car to your
dealer and have the brake system
inspected f or leaks or worn brake
pads. Slow down by shif ting to a lower
gear, and pull to the side of the road
when it is saf e. Because of the
longer distance needed to stop, it is
hazardous to drive the car. You
should have it towed, and repaired as
soon as possible. (See
on page .)
However, if the brake pedal does not
f eel normal, you should take
immediate action. Because of the
brake system’s dual-circuit design, a
problem in one part of the system
will still give you braking at two
wheels. You will f eel the brake pedal
go down much f arther bef ore the car
begins to slow down, and you will
have to press harder on the pedal.
The distance needed to stop will be
much longer. If the ABS indicator and the VSA
system indicator come on with this
indicator, have the car inspected by
your dealer immediately.
The Brake System Indicator
normallycomesonwhenyouturn
the ignition switch ON (II). It is a
reminder to check the parking brake.
It comes on and stays lit if you do not
f ully release the parking brake. 240
306
Brake System Indicator
T aking Care of t he Unexpect ed
Emergency
Towing
299
B BR RAA K
KEE S
SYYSSTTE
EM
M I
INND DI
ICCA A T
TO
OR R
U
U. .SS. .i
inn d
di
icca at too r
r s
shh o
ow
wn n
01/09/28 20:14:02 31SZ3660_302
Page 305 of 343

Check each of the large f uses in
the under-hood f use box by
looking through the top at the wire
inside. Removing these f uses
requires a Phillips-head screw-
driver.Check the smaller f uses in the
under-hood f use box and all the
fuses in the interior fuse box by
pulling out each f use with the f use
puller provided in the door of the
interior f use box.
Remove the cover f rom the f use
box. Turn the ignition switch to LOCK
(0). Make sure the headlights and
all other accessories are off.
If something electrical in your car
stops working, the f irst thing you
should check f or is a blown f use.
Determine f rom the chart on pages
and , or the diagram on the
fuse box lid, which fuse or fuses
control that component. Check those
f uses f irst, but check all the f uses
bef ore deciding that a blown f use is
not the cause. Replace any blown
f uses and check the component’s
operation. 3.
1.
2. 4.
304 305
Checking and Replacing Fuses
Fuses
T aking Care of t he Unexpect ed302
B BL
LOOW WN N F
FU
US SEE
P
P U
UL LLLEE R
R
F
FU
US SEE
01/09/28 20:14:33 31SZ3660_305
Page 307 of 343
µ
No. Amps. Circuits Protected No. Amps. Circuits Protected
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15 20 A
10 A
20 A
15 A
20 A
20 A
20 A
20 A
20 A
10 A
10 A
20 A
30 A
30 A Not Used
Stop, Horn
Hazard
Driver Power Window
TCS
VSA
Power Door Lock
Right Headlight Low
Left Headlight Low
Cooling Fan
Lef t Headlight High
Right Headlight High
Condenser Fan
Moonroof
Front Passenger’s Power
Seat 16
17
18
19
20
21
22
23
24
25
26
27
28
20 A
20 A
15 A
7.5 A 20 A
30 A
50 A
40 A
40 A
120 A 40 A
40 A
50 A Front Fog Light
ETS (Electrical Tilt/
Telescope Steering)
Meter
Back-up, Radio
Interior Lights
Wiper Motor
Ignition Switch
Power Window
Heater Motor
Battery
VSA Motor
Rear Window Defogger
Fuse box
Fuses
T aking Care of t he Unexpect ed304
UNDER-HOOD FUSE BOX
01/09/28 20:14:52 31SZ3660_307
Page 308 of 343
Î
Î
µ
µ
Î
On Canadian models
1
2
3
4
5
6
7
8
9
10
11
12
13 Small Light
Not Used (OP)
Rear Window Defogger
Relay, Cooling Fan Relay
Radio, ACC
A/C Clutch, Heated Seat
ECU (PCM)
SRS
Driver’s Power Seat
Bose Audio System
Daytime Running Lights
Driver’s Power Seat
Daytime Running Lights
Meter, Moonroof 14
15
16
17
18
19
20
21
22
23
24
25
26
7.5 A
7.5 A
10 A
7.5 A 20 A
7.5 A 20 A
20 A
20 A
7.5 A 20 A
30 A
15 A
7.5 A 10 A
20 A
20 A
10 A
20 A
20 A
10 A
20 A
7.5 A
7.5 A Starter Signal
ACG
ACC Socket
Power Window MPCS
Front Right Power Window
Mirror
ECU (Body)
Rear Right Power Window
Fuel Pump
SRS
Rear Lef t Power Window
Ignition Coils
Not Used
1:
No. Circuits Protected No. Amps.
Amps. Circuits Protected
1
1
Fuses
T aking Care of t he Unexpect ed305
INTERIOR FUSE BOX
01/09/28 20:15:01 31SZ3660_308
Page 310 of 343
If you decide to tow your car with all
f our wheels on the ground, make
sure you use a properly-designed and
attached tow bar. Prepare the car for
towing as described above, and leave
the ignition switch in Accessory (I)
so the steering wheel does not lock.
Make sure the radio and any items
plugged into the accessory power
socket are turned of f so they do not
rundownthebattery.
Emergency T owing
T aking Care of t he Unexpect ed307
Trying to lif t or tow your car by the
bumpers will cause serious damage.
The bumpers are not designed to
support the car’s weight.
The steering system can be damaged if
the steering wheel is locked. Leave the
ignition switch in Accessory (I), and
make sure the steering wheel turns
f reely bef ore you begin towing.
01/09/28 20:15:17 31SZ3660_310
Page 312 of 343

Thediagramsinthissectiongive
you the dimensions and capacities of
your Acura, and the locations of the
identif ication numbers. It also
includes inf ormation you should
know about your vehicle’s tires and
emissions control systems.................
Identif ication Numbers .310
................................
Specif ications .312
DOT Tire Quality Grading
.............................
(U.S.Cars) .314
.................................
Treadwear .314
......................................
Traction .314
.............................
Temperature .315
.........................
Oxygenated Fuels .316
......
Driving in Foreign Countries .317 .......................
Emissions Controls .318
.....................
The Clean Air Act .318
Crankcase Emissions Control
....................................
System .318
Evaporative Emissions Control ....................................
System .318
Onboard Ref ueling Vapor ................................
Recovery .318
...
Exhaust Emissions Controls .319
....................
PGM-FI System .319
Ignition Timing Control
................................
System .319
Exhaust Gas Recirculation ...................
(EGR) System .319
Three Way Catalytic ...........................
Converter .319
....................
Replacement Parts .319
..
Three Way Catalytic Converter .320
..............
State Emissions Testing .321
T echnical Inf ormat ion
T echnical Inf ormation309
01/09/28 20:15:25 31SZ3660_312
Page 322 of 343

The exhaust emissions controls
include f our systems: PGM-FI,
Ignition Timing Control, Exhaust
Gas Recirculation and Three Way
Catalytic Converter. These four
systems work together to control the
engine’s combustion and minimize
the amount of HC, CO, and NOx that
comes out the tailpipe. The exhaust
emissions control systems are
separate f rom the crankcase and
evaporative emissions control
systems.
The PGM-FI System uses sequential
multiport f uel injection.
It has three subsystems: Air Intake,
Engine Control, and Fuel Control.
The Powertrain Control Module
(PCM) uses various sensors to
determine how much air is going
into the engine. It then controls how
much f uel to inject under all operat-
ing conditions.This system constantly adjusts the
ignition timing, reducing the amount
of HC, CO and NOx produced.
The Exhaust Gas Recirculation
(EGR) system takes some of the
exhaust gas and routes it back into
the intake manif old. Adding exhaust
gas to the air/f uel mixture reduces
the amount of NOx produced when
the f uel is burned.
The three way catalytic converter is
in the exhaust system. Through
chemical reactions, it converts HC,
CO, and NOx in the engine’s exhaust
to carbon dioxide (CO ), dinitrogen
(N ), and water vapor.
The emissions control systems are
designed and certif ied to work to-
gether in reducing emissions to
levels that comply with the Clean Air
Act. To make sure the emissions
remain low, you should use only new
Genuine Acura replacement parts or
their equivalent f or repairs. Using
lower quality parts may increase the
emissions f rom your car.
2
2
Exhaust Emissions Controls Replacement Parts
PGM-FI Syst emIgnit ion T iming Cont rol Syst em
Exhaust Gas Recirculat ion (EGR)Syst em
Three Way Catalytic Converter
Emissions Cont rols
T echnical Inf ormation319
01/09/28 20:17:12 31SZ3660_322