2002 Acura RL 3.5 Owner's Manual

Ó
µ
Ôµ
The air f low f rom the rear vents can
be adjusted when the climate control
system is on. (Upper position):
Air flows from the upper vents in the
back of the center console.
(Lower position):
Air f lows f rom the lower vents.
(Upper position): Maximum
(Center position): Moderate
(Lower position): Of f (Center position):
Air f low is divided between the upper
vents and the lower vents in the back
of the center console.
You can adjust the direction of the
air coming f rom the upper vents in
the center console by moving the tab
in the center of each vent up-and-
down and side-to-side.
You can also adjust the amount of
the air f low by sliding the air f low
control lever under the upper vents.
Slide this lever upward to increase
the amount of air f low.
Use the mode control lever to select
the air f low level. Air f lows into the
rear seat at three levels.
Rear Ventilation
Mode Cont rol L ever
Climat e Cont rol Syst em
Comf ort and Convenience Feat ures126
M M
O
ODDE
E
C
CO ON NTTR
RO OL L
L
LE E V
V E
ER
R
L
LO OW WE ER
R
V
V E
EN
NT TS
S
A
A
I
IRR F
FLLOOW W
C
CO ON NTTR
RO OL L
L
LE E V
V E
ER
R U
UP
PP
PE
ER
R
V
V E
EN
NT TS
S
01/09/28 19:45:14 31SZ3660_129

Theclimatecontrolsystemhastwo
sensors. A sunlight sensor is located
in the top of the dashboard and a
temperature sensor is next to the
steering column. Do not cover the
sensors or spill any liquid on them. Sunlight Sensor/T emperature
Sensor
Climat e Cont rol Syst em
Comf ort and Convenience Feat ures127
S SUUN NLLIIGGH HT
T S
SEEN
NS SOOR R T
T
E
EM
M P
PE
ER
RA A T
TU
UR REE S
SEEN
NS SOOR R
01/09/28 19:45:21 31SZ3660_130

Î
Î
Your Acura’s audio system provides
clear reception on both AM and FM
bands, while the preset buttons allow
you to easily select your f avorite
stations.
The cassette system f eatures Dolby
noise reduction, automatic sensing of
chromium-dioxide (CrO ) tape, and
auto-reverse f or continuous play.
The anti-thef t f eature will disable the
system if it is disconnected f rom the
car’s battery. To get the system
working again, you must enter a
code number (see page ).156
2
Dolby noise reduction manuf actured under
license from Dolby Laboratories Licensing Corpo-
ration. ‘‘DOLBY’’ and the double-D symbol are trademarks of Dolby Laboratories
Licensing Corporation.
A M/FM/Cassette Stereo A udio
System3.5 RL wit hout Navigat ion Syst em
3.5 RL wit h Navigat ion Syst em
Audio System
Comf ort and Convenience Feat ures128
01/09/28 19:45:31 31SZ3660_131

µµ
µ
µ´ ´ µ
You can use any of three methods to
f ind radio stations on the selected
band: TUNE, SEEK, or the Preset
buttons.
Use the TUNE knob to
tune the radio to a desired f requency.
Turn the TUNE knob to the right to
tune to a higher f requency, or to the
lef t to tune to a lower f requency.
Turn the knob right or lef t until the
display reaches the desired
f requency. You can store the
f requencies of your f avorite radio
stations in the six preset buttons.
Each button will store one f requency
on the AM band, and two
f requencies on the FM band.
The SEEK f unction
searches the band for a station with
a strong signal. To activate it, push ei-
ther side of the SEEK/SKIP buttons
( or ). Push the button to
scan up f rom the current f requency,
andthe buttontoscandown.It
stops when it finds a station with a
strong signal.
The band and f requency that the ra-
dio was last tuned to is displayed. To
change bands, press the AM/FM but-
ton. On the FM band, ST will be dis-
played if the station is broadcasting
in stereo. ST will flash if you are driv-
inginanareawheretheradiosignal
is weak. Stereo reproduction on AM
is not available. The ignition switch must be in
ACCESSORY (I) or ON (II) to
operate the audio system. Turn the
system on by pushing the PWR/
VOL knob or the AM/FM button.
Adjust the volume by turning the
knob.
CONT INUED
TUNE
Preset
SEEK
Operating the Radio
Audio System
Comf ort and Convenience Feat ures
3.5 RL wit hout Navigat ion Syst em
129
01/09/28 19:45:42 31SZ3660_132

To store a f requency:Select the desired band, AM or
FM. FM1 and FM2 let you store
two f requencies with each Preset
button.
Use the TUNE or SEEK f unction
to tune the radio to a desired
station.
Pick the Preset button you want
for that station. Press the button
and hold it until you hear a beep.
Repeat steps 1 to 3 to store a total
of six stations on AM and twelve
on FM.
Once a station’s f requency is stored,
simply press and release the proper
Preset button to tune to it.
The preset f requencies will be lost if
your car’s battery goes dead, is
disconnected, or the radio f use is
removed. 1.
2.
3.
4.
Audio System
Comf ort and Convenience Feat ures130
P P W
WR R//V
V O
OL L
K
KN NO OBB A
A
M
M /
/F
FM M
B
BU UT TT
TO
ON N S
ST
TE
ER
RE EO
O
I
IN ND DI
ICCA A T
TO
OR R T
T
U
UN NEE
K
KN NO OBB
S
SEEE
EK
K/ /S
SK KIIPP
B
BU UT TT
TO
ON NSS
P
P R
RE ES
SE ET
T B
BUUT TT
TO
ON NSS
01/09/28 19:45:52 31SZ3660_133

µIf you are
traveling far from home and can no
longer receive the stations you
preset, you can use the Auto Select
feature to find stations in the local
area.
To activate Auto Select, press the
A. SELECT button. A. SELECT will
appear in the display, and the system
will go into scan mode f or several
seconds. It automatically scans both
bands, looking f or stations with
strong signals. It stores the f requen-
cies of six AM stations and twelve
FM stations in the preset buttons.
You can then use the preset buttons
to select those stations.
If you are in a remote area, Auto
Select may not f ind six strong AM
stations or twelve strong FM stations.
If this happens, you will see a ‘‘0’’
displayed when you press any preset
button that does not have a station
stored. With Auto Select on, you cannot
manually store any f requencies in
the preset buttons. If you do not like
the stations found by Auto Select,
you can use the TUNE and SEEK
f unctions to f ind other stations.
Auto Select does not erase the
f requencies that you preset pre-
viously. When you return home, turn
of f Auto Select by pressing the
A. SELECT button. The preset
buttons will then select the fre-
quencies you originally set.
AUTO SELECT
Audio System
Comf ort and Convenience Feat ures131
A A
M
M /
/F
FM M B
BUUT TT
TO
ON NA
A
U
UT TO
O S
SEEL
LEE C
CT T I
INND DI
ICCA A T
TO
OR R
A
A U
UT TO
O S
SEEL
LEE C
CT T B
BUUT TT
TO
ON N
P
P R
RE ES
SE ET
T B
BUUT TT
TO
ON NSS T
T
U
UN NEE
K
KN NO OBB
S
SE EE
EK
K/ /S
SK KIIPP
B
BU UT TT
TO
ON NSS
01/09/28 19:46:00 31SZ3660_134

µµ
These two
controls adjust the strength of the
sound coming f rom each speaker.
The Balance control adjusts the side-
to-side strength, while the Fader
control adjusts the f ront-to-back
strength.
To adjust the fader, push on the
BASS/FADER control knob to get it
to pop out. Pull it out slightly f arther,
and adjust the f ront-to-back sound to
your liking. Push the knob back in
when you are done so you cannot
change the setting by accidentally
bumping it.
To adjust the balance, push on the
TREBLE/BALANCE control knob
to get it to pop out. Pull it out slightly
f arther, and adjust the side-to-side
sound to your liking. Push the knob
back in when you are done so you
cannot change the setting by
accidentally bumping it. Use these controls
to adjust the tone to your liking.
To adjust the Treble level, push on
the TREBLE/BALANCE control
knob to get it to pop out. Without
pulling it out f arther, turn the knob
to adjust the treble level. Push the
knob back in when you are done so
you cannot change the setting by
accidentally bumping it. To adjust the Bass level, push on the
BASS/FADER control knob to get it
to pop out. Without pulling it out
f arther, turn the knob to adjust the
bass level. Push the knob back in
when you are done so you cannot
change the setting by accidentally
bumping it.
Adjusting the Sound
Balance/Fader
Treble/Bass
Audio System
Comf ort and Convenience Feat ures132
B BAA S
SSS//F
FA A D
DE
ER
R
C
CO ON NTTR
RO OL L T
T
R
RE EB
BL LEE /
/B
BA A L
LAA N
NC CEE
C
CO ON NTTR
RO OL L
01/09/28 19:46:10 31SZ3660_135

ÛWhen the system reaches the end of
the tape, it will automatically reverse
direction and play the other side. If
you want to remove the cassette
f rom the drive, press the EJECT
button.
If you turn the system of f while a
tape is playing, either with the PWR/
VOL knob or by turning of f the
ignition, the cassette will remain in
the drive. When you turn the system
back on, the tape will begin playing
where it lef t of f .
To switch to the radio or CD
changer while listening to a tape,
press the AM/FM or CD/TAPE but-
ton. To change back to the cassette
player, press the CD/TAPE button.
Make sure the tape opening on the
cassette is facing to the right, then
insert the cassette most of the way
into the slot. The system will pull it
in the rest of the way, and begin to
play. The ignition switch must be in
ACCESSORY (I) or ON (II).
The tape direction indicator will light
to show you which side of the
cassette is playing. The indicates
thesideyouinsertedfacingupward
is now playing. If you want to play
the other side, press the PROG/
PLAY button.
Dolby noise reduction turns on when
you insert a cassette. If the tape was
not recorded with Dolby noise reduc-
tion, turn it of f by pressing the
button.
You can use the instrument panel
brightness control dial to adjust the il-
lumination of the audio system (see
page ). The audio system
illuminates when the parking lights
are on, even if the radio is turned of f .
For inf ormation, See page .
66
141
Audio System
Comf ort and Convenience Feat ures
Operating the Cassette Player
A udio System L ighting
Radio Frequencies and Reception
133
01/09/28 19:46:23 31SZ3660_136