2002 Acura MDX ignition

µ
Pull up or push down on the f ront of
the switch to move the seat bottom’s
f ront edge up or down. Pull up or
push down on the rear of the switch
to move the rear of the seat bottom
up or down.
Push the horizontal switch forward
or backward to move the seat
forward or backward. The long horizontal switch adjusts
the seat bottom in several directions.
The short vertical switch adjusts the
seat-back angle.
Your Acura has power adjustments
f or the driver’s seat. The two power
seat adjustment switches are on the
outside edge of the seat bottom.
You can adjust the seat with the
ignition switch in any position. Make
all seat adjustments bef ore you start
driving. The Touring package also has power
adjustments f or the f ront passenger’s
seat. The MDX without the Touring
package has manual adjustments.
Thesecondandthirdrowseatsin
both models have manual
adjustments.
See pages f or important saf ety
inf ormation and warnings about how toproperly position seats and seat-backs. 12 13
Inst rument s and Cont rols
Seats
Power Seat A djustments
90
01/09/07 12:10:09 31S3V610_095

To get into the third row seats, pull
upontheleveronthesideof the
passenger’s side second row seat-
back. The seat-back will tilt f orward,
and the seat will slide f orward.
After you return the seat-back to the
upright position, push the whole seat
backwards until it latches. Make
sure the seat is f ully latched bef ore
sitting in it.The lef t and right halves of the
second seat can be f olded up
separately to create more cargo
space.
If you are f olding the lef t half of
the seat, use the ignition key to
release the seat belt from the
detachable anchor. Allow the seat
belt to retract into the roof . Insert
the latch plate into the roof holder.
Lower the head restraint to its
lowest position.
Pull up on the handle on the
outside of the seat-back. Fold the seat-back forward.
Reverse this procedure to return the
seat to the upright position. Make
sure the seat is locked securely
bef ore driving.
(Lef t half ) Remove the seat belt
f rom its holder in the roof , and
connect it to the detachable anchor
(see page ).
2.
3. 1.
4.
98
Seats
Inst rument s and Cont rols
Rear Seat A ccess Folding the Second Seat
95
R REEL
LEE A
A S
SEE L
LEE V
V E
ER
R H
H
A
AN
ND DL
LEE
01/09/07 12:10:55 31S3V610_100

Store the head restraints in the
storage compartment under the
cargo area f loor. Insert the shaf ts
of the head restraints into the
holes in the sides of the storage
compartment.Use the ignition key to release the
seat belt from the detachable
anchor.
To create more cargo space, you can
fold the third seat forward.
To fold the third seat:
Remove the head restraints by
pushing the release buttons and
pulling the restraints out.
1. 2. 3.
Folding the T hird Seat
Inst rument s and Cont rols
Seats
96
R RE
EL
LEE A
A S
SEE B
BUUT TT
TO
ON N
01/09/07 12:11:05 31S3V610_101

Both f ront seats are equipped with
seat heaters. The ignition switch
must be ON (II) to use them. Push
the front of the switch, HI, to rapidly
heat up the seat. After the seat
reaches a comf ortable temperature,
select LO by pushing the back of the
switch. This will keep the seat warm.Follow these precautions whenever
you use the seat heaters:
Use the HI setting only to heat the
seats quickly. Select the LO
setting when the seats f eel warm.
The HI setting draws large
amounts of current f rom the
battery.
Do not use the seat heaters, even
on the LO setting, if the engine is
lef t idling f or an extended period.
They can weaken the battery,
causing hard starting.
The HI or LO indicator lights and
remains lit until you turn it of f by
pushing the opposite side of the
switch lightly. The indicator will turn
off.
In HI, the heater turns of f when the
seat gets warm, and turns back on
after the seat’s temperature drops. It
continues to cycle as long as you
leave it set on HI. The HI indicator
remains lit as a reminder that you
have the heater on.
In LO, the heater runs continuously.
It does not cycle with temperature
changes.
Because of the sensors f or the side
airbag system, there is no heater in
the passenger’s seat-back.
Inst rument s and Cont rols
Seat Heaters
Seat Heaters
99
S SE
EA
A T
T H
HE
EA
A T
TE
ER
RS S
01/09/07 12:11:36 31S3V610_104

Your vehicle’s windows are
electrically-powered. Turn the
ignition switch to ON (II) to raise or
lower any window.Each door has a switch that controls
its window. To open the window,
push the switch down and hold it.
Release the switch when you want
the window to stop. Close the
window by pulling back on the
switch and holding it.The driver’s door armrest has a
master power window control panel.
To open any of the passenger’s
windows, push down on the switch
and hold it down until the window
reaches the desired position. To
close the window, pull back on the
window switch. Release the switch
when the window gets to the position
you want.
Power Windows
Inst rument s and Cont rols100
M M
A
AI
INN S
SWWI ITT C
CH H
D
D R
RIIVV E
ER
R’ ’SS W
WI INND DO
OW W
S
SW WI ITT C
CH H
01/09/07 12:11:42 31S3V610_105

The power window system has a key-
of f delay f unction. The windows will
stilloperateforuptotenminutes
after you turn off the ignition.
Opening either f ront door cancels
the delay function. You must turn
the ignition switch ON (II) again
bef ore you can operate the windows.
Power Windows
Inst rument s and Cont rols102
01/09/07 12:11:54 31S3V610_107

The moonroof has two positions: it
can be tilted up in the back f or
ventilation, or it can be slid back into
the roof . Use the switch under the
lef t dashboard vent to operate the
moonroof . The ignition switch must
be ON (II).To tilt up the back of the moonroof ,
press and hold the center button
( ). To close the moonroof ,
press and hold the top of the switch
( ). To open the moonroof ,
press and hold the bottom of the
switch ( ). Release the switch
when the moonroof gets to the
desired position. Make sure
everyone’s hands are away f rom the
moonroof bef ore opening or closing
it.
The moonroof has a key-of f delay.
You can still open and close the
moonroof f or up to ten minutes af ter
you turn of f the ignition. The key-of f
delay cancels as soon as you open
either f ront door. You must then
turn the ignition ON (II) for the
moonroof to operate.
Moonroof
Inst rument s and Cont rols103
M M
O
OOONNRROOO OFF S
SWWI ITT C
CH H
Opening or closing the
moonroof on someone’s hands
or fingers can cause serious
injury.
Make sure all hands and fingers
are clear of the moonroof
before opening or closing it. If you try to open the moonroof in
below-f reezing temperatures, or when
it is covered with snow or ice, you can
damage the moonroof panel or motor.
01/09/07 12:12:03 31S3V610_108

Adjust the outside mirrors with the
adjustment switch on the lef t side of
the dashboard:Turn the ignition switch ON (II).
Move the selector switch to L
(driver’s side) or R (passenger’s
side). Push the appropriate edge of the
adjustment switch to move the
mirrorright,left,up,ordown.
When you f inish, move the
selector switch to the center (off)
position. This turns of f the
adjustment switch so you can’t
move a mirror out of position by
accidentally bumping the switch.With the selector switch in the
center (of f ) position, the passenger’s
side mirror will pivot downward
slightly when you shif t the
transmission into reverse. This gives
you a better view of the side of the
vehicle while parallel parking. The
mirror returns to its original position
when you take the transmission out
of reverse.
1.
2. 3.
4.
CONT INUED
Touring ModelAdjusting the Power Mirrors
Mirrors
Inst rument s and Cont rols105
S SE
EL
LEE C
CT TO
OR R S
SWWI ITT C
CH H A
AD
DJ
JUUS STTM
M E
EN
NT T S
SWWI ITT C
CH H
01/09/07 12:12:21 31S3V610_110