2002 Acura CL ECU

Check the f luid level with the engine
at normal operating temperature.Remove the dipstick (yellow loop)
f rom the transmission and wipe it
with a clean cloth. Park the car on level ground. Shut
of f the engine. Insert the dipstick all the way into
the transmission securely as
shown in the illustration.
Remove the dipstick and check
the f luid level. It should be
between the upper and lower
marks.If the level is below the lower
mark, remove the f ill plug and add
f luid to bring it to the upper mark.
Always use Honda ATF-Z1
(Automatic Transmission Fluid). If it
is not available, you may use a
DEXRON
III automatic
transmission f luid as a temporary
replacement. However, continued
use can affect shift quality. Have the
transmission f lushed and ref illed
with Honda ATF-Z1 as soon as it is
convenient.
To thoroughly f lush the transmission,
the technician should drain and ref ill
it with Honda ATF-Z1, then drive the
vehicle a short distance. Do this
three times. Then drain and ref ill the
transmission a final time.
1.
2. 3.
4.5.
Automatic Transmission Fluid
Maint enance230
U UP
PP
PE
ER
R M
M A
AR
RKK
L
LO OW WE ER
R M
M A
AR
RKK
D
D
I
IPP S
ST TI
ICCK K

The f luid level should be between
theMINandMAXmarksontheside
of the reservoir. If the level is at or
below the MIN mark, your brake
system needs attention. Have the
brake system inspected f or leaks or
worn brake pads.
Check the f luid level in the brake
f luid reservoir monthly.
The brake f luid should be replaced
according to the time recommenda-
tion in the maintenance schedule.
Always use Honda Heavy Duty
Brake Fluid DOT 3. If it is not
available, you should use only DOT 3
or DOT 4 f luid, f rom a sealed
container, as a temporary
replacement. However, the use of
any non-Honda brake fluid can cause
corrosion and decrease the lif e of the
system. Have the brake system
f lushed and ref illed with Honda
Heavy Duty Brake Fluid DOT 3 as
soon as possible.
Brake f luid marked DOT 5 is not
compatible with your car’s braking
system and can cause extensive
damage.
Insert the dipstick all the way back
into the transmission securely as
shown in the illustration.
The transmission should be drained
and ref illed with new f luid according
to the time and distance recommen-
dations in the maintenance schedule.
If you are not sure how to add f luid,
contact your Acura dealer. 6. Brake System
Brake Fluid
Maint enance
Automatic Transmission Fluid, Brake Fluid
231
M M I
INN
M
M
A
AX
X

´
µ´
µ
Install the ignition coil. Reinstall
the hexagon socket head cap bolt.
Push the wire connector onto the
ignition coil. Make sure it locks in
place.
Repeat this procedure f or the
other f ive spark plugs.
Reinstall the cover on the front
cylinder bank while putting its
mounting clip in the hole on the
passenger’s side. Secure the cover
by turning the heads of the two
holding clips one-quarter turn
clockwise with a f lat-tipped
screwdriver.
Spark Plug Gap:
Spark Plug Gap:
8.
9.
10.
11. NGK:
DENSO:
NGK:
DENSO:
Spark Plugs
Maint enance
Specif ications:
Premium model
T ype-S
237
0.04 in (1.1 mm)
0.04 in (1.1 mm) PZFR5F-11
PKJ16CR-L11
PZFR6F-11
PKJ20CR-L11
0
0.1 mm0
0.1 mm
Tighten the spark plugs caref ully. A
spark plug that is too loose can
overheat and damage the engine.
Overtightening can cause damage to
the threads in the cylinder head.

The courtesy lights in the doors and
roof come apart the same way. They
do not use the same type of bulb.Removethelensbycarefully
prying on the edge of the lens with
a f ingernail f ile or a small f lat-tip
screwdriver. Do not pry on the
edge of the housing around the
lens.
Remove the bulb by pulling it
straight out. Push the new bulb
into the socket.
Put the lens back in place and
tighten the two screws securely.
Use a small Phillips-head
screwdriver to remove the two
screws. Remove the lens f rom the
license plate assembly.
1. 2.
3.
1.
Replacing a Rear License Plate
Bulb
Replacing Bulbs in the Interior
Courtesy Lights
Lights
Maint enance260
C CE
EI
ILLI INNG G L
LIIGGH HT
T
S
SC CRREEW
WS S

Dirt build-up in the loops of the seat
belt anchors can cause the belts to
retract slowly. Wipe the insides of
the loops with a clean cloth
dampened in mild soap and warm
water or isopropyl alcohol.Clean the windows, inside and out,
with a commercially-available glass
cleaner. You can also use a mixture
of one part white vinegar to ten parts
water. This will remove the haze that
builds up on the inside of the
windows. Use a sof t cloth or paper
towels to clean all glass and clear
plastic surf aces.
If you use a liquid air f reshener,
make sure you f asten it securely so it
does not spill as you drive.
Clean the wood trim with a soft cloth
dipped in clear water and wipe it dry
with another sof t cloth. Soap may
leave a f ilm that dulls the f inish. If you want to use an air f reshener/
deodorizer in the interior of your car,
it is best to use a solid type. Some
liquid air f resheners contain chemi-
cals that may cause parts of the
interior trim and f abric to crack or
discolor.
Windows
A ir Fresheners
Wood T rim
Interior Care
Appearance Care270
The rear window def ogger and
antenna wires are bonded to the inside
of the glass. Wiping vigorously up-and-
down can dislodge and break these
wires. When cleaning the rear window,
use gentle pressure and wipe side-to-
side.

CONT INUED
Remove the center cap before
storing the f lat tire in the trunk
well.Place the flat tire face down in the
spare tire well.
Tighten the wheel nuts securely in
the same crisscross pattern. Have
the wheel nut torque checked at
the nearest automotive service
f acility.
Tighten the wheel nuts to: Remove the spacer cone f rom the
wing bolt, turn it over, and put it
back on the bolt.
Secure the f lat tire by screwing
the wing bolt back into its hole.
16.
15.
17.
18.
19.
Changing a Flat T ire
T aking Care of t he Unexpect ed279
C CEEN
NT TE
ER
R C
CAA P
P W
WI
INNG G B
BOOL LTT S
SPPA
A C
CEER
R C
COON NEE
80 lbf·ft (108 N·m , 11 kgf·m)

Store the jack in its holder. Turn
the jack’s end bracket to lock it in
place. Replace the cover. Store the
tools.Diagnosing why your engine won’t
start f alls into two areas, depending
on what you hear when you turn the
key to START (III):
You hear nothing, or almost
nothing. The engine’s starter
motor does not operate at all, or
operates very slowly.
You can hear the starter motor
operating normally, or the starter
motor sounds like it is spinning
f aster than normal, but the engine
does not start up and run.
Store the center cap in the trunk.
Make sure it does not get scratch-
ed or damaged.
Unhook the handle f rom the trunk
opening and lower the f loor lid.
Close the trunk lid.
20.
21.
22.
23.
Changing a Flat Tire, If Your Engine Won’t Start
T aking Care of t he Unexpect ed
If Your Engine Won’t Start
280
Loose items can fly around the
interior in a crash and could
seriously injure the occupants.
Store the wheel, jack, and tools
securely before driving.

ÎÎ
µ
µ
á áà
à
Î
Î
Circuits Protected
Amps.
No. Circuits Protected
No. Amps.
Fuel Pump
Main SRS
Heater Control, A/C Clutch
Relay, Cooling Fan Relay
Mirror, Heated Seat, Heated
Mirror
Daytime Running Lights
ECU(PCM),CruiseControl,
VSA
Side SRS
ACC Relay, Navigation
Instrument Panel, Back-up
Lights, Memory Seat
Turn Signals
IG Coil
Wiper, Washer
Starter Signal
On Canadian models 15 A
10 A
7.5 A
7.5 A
7.5 A 15 A
7.5 A
7.5 A
7.5 A
7.5 A 15 A
30 A
7.5 A
1
2
3
4
5
6
7
8
9
10
11
12
13 Moonroof Motor
Driver’s Power Seat
Reclining, Memory Seat
Heated Seat
Driver’s Power Seat Sliding,
Memory Seat
Not Used
Right Power Window
Radio, Power Outlet
Navigation System, Daytime
Running Lights
Interior Light, Seat Memory,
HomeLink
Power Door Locks
Clock, Back Up, Small Light
ABS Motor Check
Driver’s Power Window
Not Used
On Canadian models
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16 30 A
20 A
20 A
20 A
20 A
20 A
20 A
20 A
10 A
7.5 A 20 A
15 A
7.5 A 20 A
:
:
Passenger’s Power Seat Sliding
Passenger’s Power Seat Reclining
Fuses
T aking Care of t he Unexpect ed298
F Frroo n
nt
t F
Frroo n
nt
t
INTERIOR FUSE BOXES
DRIVER’S SIDE
PASSENGER’S SIDE