29-07-2002
YOUR 406 IN DETAIL
106
Changing the battery of the
remote control
The information 'battery flat' is
given by an audible signal accompa
nied by a message on the multi
function display.
To replace the battery, unclip the
casing using a coin at the ring
(CR2016/3 volt battery).
If the remote control does not work
after the battery has been changed,
reprogramme the remote control.
Confidential card
The confidential card contains the
identification code necessary for any
work carried out by a PEUGEOT
dealer on the system. This code is
hidden by a film, which should be
removed only if necessary.
Keep your card in a safe place,
never inside the vehicle.
Programming the remote
control Switch off the ignition.
Switch the ignition on again.
press button A.
Switch off the ignition and
remove the remote control key
from the ignition lock. The remote
control is now working again.
DEADLOCKING
Deadlocking the doors is an addtional
safety device.
Warning:
The internal and external door
controls cannot operate when the vehi
cle is deadlocked.
There are two methods of operation:
With the the remote control
To deadlock: pressbutton A.
This is indicated by permanent lighting
of the direction indicators for approxi
mately two seconds.
Press button A within five seconds
of deadlocking to change this to lock
ing only.
This is indicated by permanent lighting
of the direction indicators for approxi
mately two seconds.
With the ignition key from the driver's
door
To deadlock: turn the key towards the
rear of the vehicle.
To lock: within five seconds of deadlock
ing, again turn the key towards the rear
of the vehicle. To unlock: turn the key
towards the front of the vehicle.
Do not operate the dead
locking if there is someone
inside the vehicle.
Do not operate the buttons
of yur remote control while it is in
your pocket, as there is a possibility
that it may unlock your vehicle.
