2002.5 Peugeot 406 lights

DRIVING YOUR 406
148
Sport and Snow programmes
In addition to the autoadaptive pro
gramme, you have a choice of two
specific programmes. The pro
gramme selected is displayed on the
instrument panel.
Sport Programme Press button S, once the vehicle
has started and function D has
been selected.
The gearbox automatically favours
dynamic driving.
Snow programme
This programme favours starting
operations and drive to improve
traction.  Press button , once the vehicle
has started and function Dhas
been selected.
The gearbox adapts to driving on
slippery roads.
Note: you can return to the auto
adaptive programme at any time.  Press button Sor again to
cancel the programme selected. Difficulties in operation
Any disruption of the system is sig
nalled by the alternate flashing of the
Sport and Snow lights on the instru
ment panel.
In this case, the gearbox will operate
in downgrade mode (locked in 3rd
gear). You may feel a substantial
knock when reverse is selected fromP
to Ror from Nto R (without any
risk of damage to the gearbox). Do
not exceed 60 m.p.h. (100 km/h),
speed restrictions permitting.
Contact a PEUGEOT dealer without
delay.
MANUAL GEARBOX
Reverse
To change to reverse gear, lift the
ring under the gear lever knob and
push the gear lever to the left then to
the front.
Reverse gear can only be
engaged when the vehicle is sta
tionary with the engine idling.
29-07-2002

29-07-2002
The ESPsystem offers
increased safety during
normal driving, but should
not incite the driver to take
risks or to drive at high speed.
The operation of the system is
assured to the extent to which the
recommendations of the manufac
turer regarding the wheels (tyres
and wheel rims), the braking com
ponents, the electronic compo
nents and the assembly and repair
procedures within the PEUGEOT
network are respected.
After an accident or impact, have
the system checked by a
PEUGEOT dealer.
DRIVING YOUR 406
150
TRACTION CONTROL (ASR)
AND DYNAMIC STABILITY
CONTROL (ESP)
These systems are linked and com
plement the ABS.
The ASR system optimises drive to
prevent the wheels skidding, by act
ing on the brakes of the drive wheels
and on the engine. It also allows the
directional stability of the vehicle to
be improved on acceleration.
If there is a variation between the tra
jectory followed by the vehicle and
that required by the driver, the ESP
system automatically acts on the
engine and the brake of one or more
wheels, in order to put the vehicle
back on course.
Operation of the ASR and ESP
systems
When one of these two sys
tems is operating, this light
flashes. Handbrake
Applying
When parking, pull the handbrake to
immobilise your vehicle.
W
arning: when parking on a slope,
direct your wheels towards the pave
ment and apply the handbrake.
Releasing
Pull the handle and press the button
to release the handbrake.
Disarming the ESP / ASR systems
In certain conditions (vehicle stuck in
mud or snow, or on loose ground...),
it could prove useful to disarm the
ASR system to make the wheels
spin and regain grip. 
Press the switch "ESP OFF", sit
uated to the left of the steering
wheel.
The switch lights up and the indicator
lights come on, accompanied by the
message '' ASR/ESP deactivated''
on the multifunction display: the
ESP and ASR systems no longer
affect the operation of the engine or
the brakes.
They engage again: automatically when the ignition is
switched off,
 manually by pressing the switch
again.
Operating check When a system malfunction
occurs, the switch light
flashes and the indicator
light comes on.
Contact a PEUGEOT dealer to
check the system.

29072002
Amber bulbs must be
replaced by bulbs of iden
tical specification and
colour.
In certain weather conditions (low
temperatures, humidity), the
presence of condensation on
the inside of the headlamp
glass is normal; it disappears a
few minutes after the lights have
been switched on.
CHANGING A BULB
1 Dipped beam headlamps
2 Main beam headlamps
2 bulbs (H755W)
Press the tab and remove the protective cover corresponding to the faulty bulb.
Disconnect the connector.
Press the end of the securing clip to remove it. Change the b ulb.
When fitting, ensure that the direction notches are positi oned correctly and that
the securing clip is corrrectly fixed.
Reconnect the connector.
Refit the protective cover.
3 Side lights (W 5 W)
Turn the socket using the lever and remove it. Change the bul b.
4 Direction indicators (P 21 W)
Turn the bulb holder a quarter turn and remove it. Change t he bulb.
Note: only handle H7 bulbs using a dry cloth.
To replace the lefthand bulbs, remove the protective battery co ver.Direction indicator (WY 5 W)
Pull the rear section of the trans
parent cover and release the
assembly.
Turn the connector a quarter turn and remove it.
Change the bulb.
MAINTENANCE OF YOUR 406
37

29072002
Third brake light saloon
(5 W5W bulbs)
Lower the two metal clips on either
side of the light and slide the cover
towards the rear.
Remove the bulbholder.
Change the faulty bulb. Rear lights, saloon
1 Direction indicators (P 21 W).
2 Reversing lights (P 21 W).
3 Brake lights/Side lights (P 21/5 W).
4 Side lights (P 21/5 W).
5 Fog lamp (P 21 W).
These 5 bulbs are changed from inside the boot:
remove the retaining clips then release the carpet,
remove the connector by pressing the tab
A,
remove the bulb holder by squeezing the tabs,
change the faulty bulb.
MAINTENANCE OF YOUR 406
38

29072002
Tailgate lights
Open the flap using the cutout pro
vided.
Disconnect the connector by releas
ing tab A.
Unscrew the two nuts.
Remove the light by squeezing the
two tabs B. Extract the bulb holder by pressing
the tabs
C.
Change the faulty bulb.
1 Side lights (P 21/5 W).
2 Reversing lights (P 21 W).
3 Fog lamp (P 21 W). Number plate lights (W 5 W)
Remove the translucent protector.
Change the faulty bulb.
MAINTENANCE OF YOUR 406
40

29072002
Rear lights, estate
Wing lights
To remove the trim, pull the handle
towards you and release the panel
upwards.Open the flap using the ignition key.
Remove the connector by pressing
the metal bar
A.
Unscrew the wing nut B.
Release the light. To gain access to the bulbs, press
the tabs and release the bulb holder.
1 Brake/side lights (P21/5 W).
2 Direction indicators (P 21 W).
Change the faulty bulb.
MAINTENANCE OF YOUR 406
39

29072002
Tailgate lights
Open the flap using the cutout pro
vided.
Disconnect the connector by releas
ing tab A.
Unscrew the two nuts.
Remove the light by squeezing the
two tabs B. Extract the bulb holder by pressing
the tabs
C.
Change the faulty bulb.
1 Side lights (P 21/5 W).
2 Reversing lights (P 21 W).
3 Fog lamp (P 21 W). Number plate lights (W 5 W)
Remove the translucent protector.
Change the faulty bulb.
MAINTENANCE OF YOUR 406
40

29072002
Engine compartment fuses
Fuse box
To access the fuse box in the engine
compartment (beside the battery),
unclip the cover.
Carefully close the cover when
you have finished.The electrical system of
your vehicle is designed
to operate with standard
or optional equipment.
Before installing other electrical
equipment or accessories on your
vehicle, contact a PEUGEOT
dealer.
Some electrical accessories or
the way in which they are fitted
can have damaging effects on the
operation of your vehicle; the
electronic control circuits, the
audio circuit and the battery
charging circuit.
PEUGEOT will not accept respon
sibility for the cost incurred in
repairing your vehicle or for recti
fying the malfunctions resulting
from the installation of acces
sories not supplied and not rec
ommended by PEUGEOT and not
installed in accordance with its
instructions, in particular where
the equipment in question con
sumes more than 10 mil
liamperes. *The maxifuses provide addition
al protection for the electrical sys
tems. All work must be carried out
by a PEUGEOT dealer.
Fuse N° Rating Functions
1* 10 A Reversing lights– Double injection relay Oil
temperature Oil level Air conditioning compressor.
2* 15 AFuel pump, canister solenoid valve.
3* 10 AControl unit.
4* 10 AEngine control unit and automatic gearbox.
5 10 A Particulate Emission Filter control unit Rear
windscreen relay.
6 15 AFront fog lamps.
7 20 AHeadlamp wash.
8* 20 A Direct petrol injection engine control unit Clutch pedal.
9* 15 ALefthand dipped beam lights.
10* 15 A Righthand dipped beam lights
MAINTENANCE OF YOUR 406
44