2002.5 Peugeot 406 instrument panel

29072002
CHANGING A FUSE
The fuse boxes are under the fascia
and in the engine compartment.
Fascia fuse box
Turn the three screws a quarter turn
with a coin.
Pull at Aand tilt the cover to access
the fuses. Removing and changing a fuse
Before changing a fuse you must find out the cause of the fa
ult and have it put
right. The fuse numbers are indicated on the fuse box.
Use the special pliers Aattached to the box.
Always change a faulty fuse for one of the same rating.
Correct Incorrect Pliers A
Remove the fascia panel lower trim to access the builtin systems in terface.
Fuse no
. Rating Functions
A 20 A Locking/Unlocking, Deadlocking.
B 10 A Rear fog lamps.
.
C 40 A Demisting the mirrors.
D 15 A Rear screen wiper.
E 30 A Electric windows.
F15 A Supply to instrument panel
Display Audio equipment
Satellite navigation system
Air conditioning.
MAINTENANCE OF YOUR 406 41

Fuse N° RatingFunctions
1 shuntCentral air bag.
25 A Ventilation controls.
3 10 A Instrument panel.
45 A Ignition +ve signal for Builtin Systems Interface.
5 Not used.
6 10 ASteering wheel stalk.
7 15 AAlarm siren.
8 10 ASatellite navigation system.
95 A Battery +ve signal for Builtin Systems Interface.
10 15 A Audio equipment.
11 10 AThird brake light.
12 10 A Righthand brake light.
13 20 ADriver's electric window.
14 30 ARear window lift.
15 Battery +ve towing socket.
16 20 AMemorisation of seats.
17 20 APassenger's electric seat.
18 10 A Lighter lighting Display Lighting for switches and ash tray , automatic gearbox selector lever.
Fascia fuse box
MAINTENANCE OF YOUR 406
42
29072002

29072002
BATTERY
To charge the battery using a battery charger:
Disconnect the battery,
Follow the instructions for use given by the battery charger manufacturer,
Reconnect starting with the negative (–) terminal,
Check that the terminals and connectors are clean. If they are covered with sul
phate (white or greenish deposit), disconnect them and clean t hem.
To start the vehicle from another battery:
Connect the red cable to the positive (+) terminals of the tw o batteries,
Connect one end of the green or black cable to the negat ive (–) terminal of the
slave battery,
Connect the other end of the green or black cable to an e arth point on the bro
ken down vehicle, as far as possible from the battery,
Operate the starter, let the engine run.
Wait for the engine to return to idle, then disconnect th e cables.
Never disconnect a terminal when the engine is running.
Never charge a battery without first disconnecting the terminal s.
Close the sunroof before disconnecting the battery. If it does not
operate normally following reconnection of the battery, you must
reinitialise it by turning the control to the maximum tilt po sition and pressing
it for a few seconds.
After every reconnection of the battery, switch on the igniti on and wait
1 minute before starting to allow the electronic systems to be initialised. If
slight difficulties are experienced after this, please contact a PEUGEOT
dealer. It is advisable to disconnect the battery if the vehicle
is not to be used for a period of more than one month.Economy mode
With the engine switched off and the
ignition key in the "running" or
"accessories" position for about half
an hour, certain electrical equipment
(displays, instrument panel, warning
lights, courtesy lights, electric win
dows, wipers etc.) will switch off
automatically to avoid draining the
battery.
Once the electrical equipment goes
into economy mode, it is necessary
to start the engine to enable the
equipment to work again.
MAINTENANCE OF YOUR 406
46