2001 YAMAHA YFM660R weight

7-47
Yuki_DATA2:HM00G210_YFM660R-60:YFM350-7.frameEL
It is important when climbing a hill to make
sure that your weight is transferred forward on
the ATV. This can be accomplished by leaning
forward and, on steeper inclines, standing on
the footboards and leaning forward over the
handlebars.
WARNING
Always follow proper procedures for
climbing hills as described in this Owner’s
Manual.
Always check the terrain carefully before
you start up any hill.
Never climb hills with excessively slip-
pery or loose surfaces.
Shift your weight forward.
Never open the throttle suddenly or make
sudden gear changes. The ATV could flip
over backwards.
Never go over the top of any hill at high
speed. An obstacle, a sharp drop, or an-
other vehicle or person could be on the
other side of the hill.

7-49
Yuki_DATA2:HM00G210_YFM660R-60:YFM350-7.frameEL
If you are climbing a hill and you find that you
have not properly judged your ability to make
it to the top, you should turn the ATV around
while you still have forward motion (provided
you have the room to do so) and go down the
hill.
WARNING
Never attempt to turn the ATV around on any
hill until you have mastered the turning tech-
nique as described in the Owner’s Manual on
level ground. Be very careful when turning on
any hill.
Avoid crossing the side of a steep hill if possi-
ble.
When crossing the side of a hill:
Always follow proper procedures as de-
scribed in the Owner’s Manual.
Avoid hills with excessively slippery or
loose surfaces.
Shift your weight to the uphill side of the
ATV.

7-53
Yuki_DATA2:HM00G210_YFM660R-60:YFM350-7.frameEL
WARNING
Use proper gear and maintain steady speed
when climbing a hill.
If you lose all forward speed:
Keep weight uphill.
Apply the brakes.
Lock parking brake, after you are stopped.
If you begin rolling backwards:
Keep weight uphill.
Never apply the rear brake while rolling
backwards. Apply the front brake.
When fully stopped, apply rear brake as
well, and then lock parking brake.
Dismount on uphill side or to a side if pointed
straight uphill. Turn the ATV around and re-
mount, following the procedure described in
the Owner’s Manual.

7-55
Yuki_DATA2:HM00G210_YFM660R-60:YFM350-7.frameEL
RIDING DOWNHILL
When riding your ATV downhill, shift your
weight as far to the rear and uphill side of the
ATV as possible. Move back on the seat and sit
with your arms straight. Choose a low gear
which will allow the engine compression to do
most of the braking for you. Improper braking
may cause a loss of traction.
Use caution while descending a hill with loose
or slippery surfaces. Braking ability and trac-
tion may be adversely affected by these surfac-
es. Improper braking may also cause a loss of
traction.
Whenever possible, ride your ATV straight
downhill. Avoid sharp angles which could al-
low the ATV to tip or roll over. Carefully choose
your path and ride no faster than you will be
able to react to obstacles which may appear.

7-57
Yuki_DATA2:HM00G210_YFM660R-60:YFM350-7.frameEL
WARNING
Always follow proper procedures for going
down hills as described in this Owner’s Manu-
al.
Note: a special technique is required when
braking as you go down a hill.
Always check the terrain carefully before
you start down any hill.
Shift your weight backward.
Never go down a hill at high speed.
Avoid going down a hill at an angle that
would cause the vehicle to lean sharply to
one side. Go straight down the hill where
possible.

7-59
Yuki_DATA2:HM00G210_YFM660R-60:YFM350-7.frameEL
CROSSING A SLOPE
Traversing a sloping surface on your ATV re-
quires you to properly position your weight to
maintain proper balance. Be sure that you
have learned the basic riding skills on flat
ground before attempting to cross a sloping
surface. Avoid slopes with slippery surfaces or
rough terrain that may upset your balance.
As you travel across a slope, lean your body in
the uphill direction. It may be necessary to cor-
rect the steering when riding on loose surfaces
by pointing the front wheels slightly uphill.
When riding on slopes be sure not to make
sharp turns either up or down hill.

7-61
Yuki_DATA2:HM00G210_YFM660R-60:YFM350-7.frameEL
If your ATV does begin to tip over, gradually
steer in the downhill direction if there are no
obstacles in your path. As you regain proper
balance, gradually steer again in the direction
you wish to travel.
WARNING
Never attempt to turn the ATV around on any
hill until you have mastered the turning tech-
nique as described in the Owner’s Manual on
level ground. Be very careful when turning on
any hill. Avoid crossing the side of a steep hill
if possible.
When crossing the side of a hill:
Always follow proper procedures as de-
scribed in the Owner’s Manual.
Avoid hills with excessively slippery or
loose surfaces.
Shift your weight to the uphill side of the
ATV.

7-69
Yuki_DATA2:HM00G210_YFM660R-60:YFM350-7.frameEL
SLIDING AND SKIDDING
Care should be used when riding on loose or
slippery surfaces since the ATV may slide. If
unexpected and uncorrected, sliding could
lead to an accident.
To reduce the tendency for the front wheels to
slide in loose or slippery conditions, position-
ing your weight over the front wheels will
sometimes help.
If the rear wheels of your ATV start to slide
sideways, control can usually be regained (if
there is room to do so) by steering in the direc-
tion of the slide. Applying the brakes or accel-
erating is not recommended until you have
corrected the slide.