2001 YAMAHA YFM400F transmission oil

4-29
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B061_YFM400FWA-61:YFM600-4.frame
EL
EBU00608
Drive select lever
The drive select lever is used to shift your ma-
chine into the low, high, neutral, reverse and
park positions. (Refer to pages 6-11 ~ 6-15 for
the drive select lever operation.)
EBU00667
Recoil starter
Firmly grasp the handle and pull slightly until
engagement can be felt. Then pull forcefully,
being careful not to pull the rope all the way
out.
WARNING
Shift the transmission in neutral or set the
shift lever to the park position before starting
the engine or the ATV could start to move un-expectedly, which could cause an accident.
1. Drive select lever
1. Levier de présélection
1. Palanca de selección de marcha1. Recoil starter
1. Lanceur à réenroulement
1. Arranque por tracción de cable

8-41
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B061_YFM400FWA-61:YFM600-8.frame
EL
10. Start the engine and warm it up for sever-
al minutes. While warming up, check for
oil leakage. If oil leakage is found, stop the
engine immediately and check for the
cause.
11. Install the panels.
EBU00705
Final gear oil
Final gear oil measurement
1. Place the machine on a level place.
2. Remove the oil filler bolt and check the oil
level. It should be up to the brim of the
hole. If the level is low, add oil to raise it to
the proper level.CAUTION:Be sure no foreign material enters the finalgear case.
1. Final gear oil
2. Final gear case filler bolt
3. Proper level
1. Huile de transmission finale
2. Boulon de remplissage du carter de transmission finale
3. Niveau correct
1. Aceite de la transmisión final
2. Tapa de la caja del filtro
3. Nivel adecuado

8-43
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B061_YFM400FWA-61:YFM600-8.frame
EL
3. Install the oil filler bolt and tighten to the
specified torque.
Final gear oil replacement
1. Remove the final gear case cover.
2. Place the machine on a level place.
3. Place a container under the final gear
case.
4. Remove the oil filler bolt and the drain
bolt to drain the oil.
5. Install the drain bolt and tighten to the
specified torque. Tightening torque:
Oil filler bolt:
23 Nm (2.3 m·kg)
Tightening torque:
Drain bolt (final gear case):
23 Nm (2.3 m·kg)
1. Bolt (´ 2)
1. Boulon (´ 2)
1. Perno (´ 2)1. Final gear oil drain bolt
1. Boulon de vidange d’huile de transmission finale
1. Perno de drenaje de aceite del engranaje final