2001 YAMAHA YFM400F four wheel drive

4-3
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B061_YFM400FWA-61:YFM600-4.frame
EL
1. Park indicator light “P”
2. Reverse indicator light “R”
3. Neutral indicator light “N”
4. Coolant temperature warning light “ ”
5. Four-wheel-drive indicator light “ ”
1. Témoin de stationnement “P”
2. Témoin de marche arrière “R”
3. Témoin de point mort “N”
4. Témoin d’avertissement de la température du liquide de
refroidissement “ ”
5. Témoin 4x4 “ ”
1. Luz de indicatora de estacionamiento “P”
2. Luz de control de marcha atrás “R”
3. Luz de control de punto muerto “N”
4. Luz de aviso de la temperatura del refrigerante “ ”
5. Luz de control del modo de tracción de cuatro
ruedas “ ”
EBU00043
Indicator lights
EBU00609
Park indicator light “P”
This indicator light comes on when the drive
select lever is in the “P” (park) position.
EBU00602
Reverse indicator light “R”
This indicator light comes on when the trans-
mission is in reverse.
EBU00603
Neutral indicator light “N”
This indicator light comes on when the trans-
mission is in neutral.
EBU00713
Coolant temperature warning light “ ”
When the coolant temperature reaches a spec-
ified level, this light comes on to warn that the
coolant temperature is too hot. If the light
comes on during operation, stop the engine as
soon as it is safe to do so and allow the engine
to cool down for about 10 minutes.

4-5
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B061_YFM400FWA-61:YFM600-4.frame
EL
The coolant temperature warning light circuit
can be checked according to the procedure on
page 4-7.
CAUTION:

l
The engine may overheat if the ATV is
overloaded. If this happens, reduce the
load to specification.
l
Restart after making sure that the light is
out. Continuous use while the light is on
may cause damage to the engine.
EBU00605
Four-wheel-drive indicator light “ ”
This indicator light comes on when the
2WD/4WD switch is in the 4WD position.
NOTE:

Due to the synchronizing mechanism in the dif-
ferential gear case, the light may not come on
until the ATV starts moving.

4-19
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B061_YFM400FWA-61:YFM600-4.frame
EL
EBU00061
On command four-wheel drive switch
“2WD/4WD”
To change from two-wheel drive (2WD) to
four-wheel drive (4WD), stop the ATV and set
the switch to the 4WD position.
To change from four-wheel drive (4WD) to
two-wheel drive (2WD), stop the ATV and set
the switch to the 2WD position.
WARNING

Always stop the ATV before changing from
2WD to 4WD or from 4WD to 2WD. The ATV
handles differently in 2WD than in 4WD in
some circumstances. Changing from 2WD to
4WD or vice-versa while moving may cause
the ATV to unexpectedly handle differently.
This could distract the operator and increase
the risk of losing control and an accident.
1. Four-wheel drive switch “2WD/4WD”
1. Contacteur de commande du mode de traction
“2WD/4WD”
1. Interruptor de modo de tracción “2WD/4WD”

8-117
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B061_YFM400FWA-61:YFM600-8.frame
EL
EBU00745
Fuse replacement
1. The fuse cases are under the seat.
2. If a fuse is blown, turn off the main switch
and the switch of the circuit in question.
Then, install a new fuse of the specified
amperage. Turn on the main switch. If the
fuse immediately blows again, consult a
Yamaha dealer.
Specified fuses:
Main fuse: 30 A
Headlight fuse: 15 A
Ignition fuse: 10 A
Auxiliary DC jack fuse: 10 A
Four-wheel-drive fuse: 3 A
Signal fuse (horn): 10 A
1. Main fuse 2. Spare fuse
1. Fusible principal 2. Fusible de rechange
1. Fusible principal 2. Fusible de repuesto1. Fuse box
1. Boîte à fusibles
1. Caja de fusibles

8-119
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B061_YFM400FWA-61:YFM600-8.frame
EL
WARNING
Always use a fuse of the specified rating. Nev-
er use any type of material or object in place of
the proper fuse. An improper fuse can cause
damage to the electrical system which couldlead to a fire.CAUTION:To prevent accidental short-circuiting, turn off
the main switch when checking or replacing afuse.
1. Headlight fuse
2. Ignition fuse
3. Auxiliary DC jack fuse
4. Four-wheel-drive fuse
5. Signal fuse
6. Spare fuse (´ 3)
1. Fusible principal
2. Fusible d’allumage
3. Fusible de connecteur pour accessoires
4. Fusible du système 4x4
5. Fusible de signalisation
6. Fusible de rechange (´ 3)
1. Fusible del faro
2. Fusible del sistema de encendido
3. Fusible de la toma de CC auxiliar
4. Fusible del sistema de tracción en las cuatro ruedas
5. Fusible señalización
6. Fusible de repuesto (´ 3)

Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B061_YFM400FWA-61:YFM600SPEC-
ER
10-6
Bulb voltage, wattage
´
quantity:
Headlight 12 V, 30 W / 30 W
´
2
Taillight 12 V, 7.5 W
´
1
Neutral indicator light 12 V, 1.7 W
´
1
Reverse indicator light 12 V, 1.7 W
´
1
Coolant oil temperature warning light 12 V, 1.7 W
´
1
Park indicator light 12 V, 1.7 W
´
1
Four wheel drive indicator light 12 V, 1.7 W
´
1 Model YFM400FA / YFM400FWAN