8-15
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-8.frame
EL
EBU00772
Engine oil
Engine oil level measurement
1. Place the ATV on a level surface.
2. Warm up the engine for several minutes,
and then stop it.
3. Remove the dipstick, and then wipe it off
with a clean rag. Insert the dipstick in the
filler hole without screwing it in.
NOTE:
Wait a few minutes until the oil level settles be-
fore checking.
4. Remove the dipstick, and then check the
oil level.
5. The oil level should be between the maxi-
mum and minimum marks. If the level is
low, add oil to raise it to the proper level.
CAUTION:
Be sure no foreign material enters the crank-
case.
1. Dipstick 2. Maximum level mark
3. Minimum level mark
1. Jauge 2. Repère de niveau maximum
3. Repère de niveau minimum
1. Varilla de nivel de aceite 2. Marca de nivel máximo
3. Marca de nivel mínimo
8-23
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-8.frame
EL
Oil pressure check
1. Put a cloth around the cylinder.
2. Slightly loosen the oil gallery bolt in the
cylinder head.
3. Start the engine and keep it idling until oil
begins to seep from the oil gallery. If no oil
comes out after one minute, turn the en-
gine off so it will not seize and find the
cause.
4. Start the engine, and then check the oil
pressure.
5. After checking, tighten the oil gallery bolt
to the specified torque.CAUTION:Be sure to check the oil pressure after replac-ing the engine oil. Tightening torque:
Oil gallery bolt:
7 Nm (0.7 m·kg)
1. Oil gallery bolt
1. Boulon de rampe de graissage
1. Perno del conducto de aceite
