6-16
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
EAU04253
Chain drive oilThe chain drive oil should be
changed as follows at the intervals
specified in the periodic maintenance
and lubrication chart.
1. Remove panel F. (See page 6-8
for panel removal and installation
procedures.)
2. Place an oil pan under the chain
drive case to collect the used oil.
3. Remove the oil filler cap and
drain bolt to drain the oil from the
chain drive case.4. Install the chain drive oil drain
bolt, and then tighten it to the
specified torque.
5. Add the specified amount of the
recommended oil.
6. Wipe the dipstick clean, insert it
into the oil filler hole (without
screwing it in), and then remove
it to check the oil level.
1
2
1. Maximum level mark
2. Minimum level markNOTE:
The engine oil should be between the
minimum and maximum level marks.7. If the engine oil is below the min-
imum level mark, add sufficient
oil of the recommended type to
raise it to the correct level.
8. Insert the dipstick into the oil filler
hole, and then tighten the oil filler
cap.
ECA00078
cCMake sure that no foreign material
enters the chain drive case.
Recommended chain drive oil:
See page 8-1.
Oil quantity:
0.7 LTightening torque:
Chain drive oil drain bolt:
20 Nm (2.0 m0kg)
1
2
1. Chain drive oil filler cap
2. Chain drive oil drain bolt
5GJ-9-EV 5/26/01 11:04 AM Page 57
