2001 YAMAHA TDR 125 tires

Transmission oil................................................6-8
Coolant...........................................................6-10
Cleaning the air filter element.........................6-13
Adjusting the carburetor.................................6-15
Adjusting the engine idling speed...................6-16
Adjusting the throttle cable free play..............6-17
Tires................................................................6-17
Wheels............................................................6-20
Adjusting the clutch lever free play.................6-20
Adjusting the brake lever free play.................6-21
Adjusting the brake pedal position..................6-22
Adjusting the rear brake light switch...............6-22
Checking the front and rear brake pads.........6-23
Checking the brake fluid level.........................6-24
Changing the brake fluid.................................6-25
Drive chain slack............................................6-25
Lubricating the drive chain..............................6-26
Checking and lubricating the cables...............6-27
Checking and lubricating the throttle grip
and cable......................................................6-28
Adjusting the Autolube pump..........................6-28
Checking and lubricating the brake and shift
pedals...........................................................6-29
Checking and lubricating the brake and
clutch levers..................................................6-29
Checking and lubricating the sidestand..........6-29Lubricating the rear suspension.....................6-30
Checking the front fork...................................6-30
Checking the steering.....................................6-31
Checking the wheel bearings.........................6-32
Battery............................................................6-32
Replacing the fuse..........................................6-33
Replacing a headlight bulb.............................6-34
Replacing the tail/brake light bulb...................6-35
Replacing a turn signal light bulb....................6-36
Supporting the motorcycle..............................6-37
Front wheel.....................................................6-37
Rear wheel.....................................................6-39
Troubleshooting..............................................6-41
Troubleshooting charts...................................6-42
MOTORCYCLE CARE AND STORAGE.............7-1
Care..................................................................7-1
Storage.............................................................7-4
SPECIFICATIONS...............................................8-1
Conversion table...............................................8-5
CONSUMER INFORMATION.............................9-1
Identification numbers......................................9-1
Key identification number.................................9-1
Vehicle identification number............................9-1
Model label.......................................................9-2
TABLE OF CONTENTS
789
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 6

4-2
PRE-OPERATION CHECKS
1
2
34
5
6
7
8
9
Rear brake¥Check operation.
¥If soft or spongy, have Yamaha dealer bleed hydraulic system.
¥Check fluid level in reservoir.
¥If necessary, add recommended brake fluid to specified level.
¥Check hydraulic system for leakage.3-7, 6-22Ð6-24
Clutch¥Check operation.
¥Lubricate cable if necessary.
¥Check lever free play.
¥Adjust if necessary.3-6, 6-20Ð6-21
Throttle grip¥Make sure that operation is smooth.
¥Lubricate throttle grip, housing and cable if necessary.
¥Check free play.
¥Adjust if necessary.6-17, 6-28
Control cables¥Make sure that operation is smooth.
¥Lubricate if necessary.6-27
Drive chain¥Check chain slack.
¥Adjust if necessary.
¥Check chain condition.
¥Lubricate if necessary.6-25Ð6-27
Wheels and tires¥Check for damage.
¥Check tire condition and tread depth.
¥Check air pressure.
¥Correct if necessary.6-17Ð6-20
Brake and shift pedals¥Make sure that operation is smooth.
¥Lubricate pedal pivoting points if necessary.6-29
Brake and clutch levers¥Make sure that operation is smooth.
¥Lubricate lever pivoting points if necessary.6-29
Sidestand¥Make sure that operation is smooth.
¥Lubricate pivot if necessary.6-29Ð6-30 ITEMCHECKSPAGE
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 29

6-3
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
9
*Tires¥Check tread depth and for damage.
¥Replace if necessary.
¥Check air pressure.
¥Correct if necessary.ÖÖÖÖ
10*Wheel bearings¥Check bearing for looseness or damage.ÖÖÖÖ
11*Swingarm¥Check swingarm pivoting point for play.ÖÖÖÖ
¥Lubricate with lithium-soap-based grease.Every 24,000km
12Drive chain¥Check chain slack.
¥Make sure that the rear wheel is properly aligned.
¥Clean and lubricate.Every 1,000 km and after washing the motorcycle
or riding in the rain.
13*Steering bearings¥Check bearing play and steering for roughness.ÖÖÖÖÖ
¥Lubricate with lithium-soap-based greaseEvery 24,000km
14*Chassis fasteners¥Make sure that all nuts, bolts and screws are properly tightened.ÖÖÖÖÖ
15Sidestand¥Check operation.
¥Lubricate.ÖÖÖÖÖ
16*Sidestand switch¥Check operation.ÖÖÖÖÖÖ
17*Front fork¥Check operation and for oil leakage.ÖÖÖÖ
18*Rear shock absorber
assembly¥Check operation and shock absorber for oil leakage.ÖÖÖÖ
¥Lubricate the pivoting points with molybdenum disulfide
grease.ÖÖ
19*Carburetor¥Check starter (choke) operation.
¥Adjust engine idling speed.ÖÖÖÖÖÖ NO.ITEMCHECK OR MAINTENANCE JOBODOMETER READING (´1,000 km)
ANNUAL
CHECK
16121824
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 38

6-17
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
EAU00634
Adjusting the throttle cable
free playThe throttle cable free play should
measure 3Ð5 mm at the throttle grip.
Periodically check the throttle cable
free play and, if necessary, adjust it
as follows.NOTE:
The engine idling speed must be cor-
rectly adjusted before checking and
adjusting the throttle cable free play.a.Free play
a
2 1
b
a
1.Loosen the locknut.
2.To increase the throttle cable
free play, turn the adjusting nut
in direction a. To decrease the
throttle cable free play, turn the
adjusting nut in direction b.
3.Tighten the locknut.1.Locknut
2.Adjusting nut
EAU03804
TiresTo maximize the performance, dura-
bility, and safe operation of your
motorcycle, note the following points
regarding the specified tires.
Tire air pressure
The tire air pressure should be
checked and, if necessary, adjusted
before each ride.
EW000082
w8The tire air pressure must be
checked and adjusted on cold
tires (i.e., when the tempera-
ture of the tires equals the
ambient temperature).
8The tire air pressure must be
adjusted in accordance with
the riding speed and with the
total weight of rider, passen-
ger, cargo, and accessories
approved for this model.
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 52

6-18
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
EWA00012
wBecause loading has an enormous
impact on the handling, braking,
performance and safety character-
istics of your motorcycle, you
should keep the following precau-
tions in mind.
8NEVER OVERLOAD THE
MOTORCYCLE! Operation of
an overloaded motorcycle may
result in tire damage, loss of
control, or severe injury. Make
sure that the total weight of
rider, passenger, cargo, and
accessories does not exceed
the specified maximum load
for the vehicle.
8Do not carry along loosely
packed items, which can shift
during a ride.
8Securely pack the heaviest
items close to the center of the
motorcycle and distribute the
weight evenly on both sides.
8Adjust the suspension and tire
air pressure with regard to the
load.
8Check the tire condition and
air pressure before each ride.
Tire air pressure
(measured on cold tires)
Load*FrontRear
Up to 90 kg175 kPa
(1.75 kg/cm
2
1.75 bar)200 kPa
(2.00 kg/cm
2
2.00 bar)
90 kgÐmaximum175 kPa
(1.75 kg/cm
2
1.75 bar)225 kPa
(2.25 kg/cm
2
2.25 bar)
Maximum load*180 kg
179 kg (CH, A)
*Total weight of rider, passenger, cargo and
accessories
Tire inspection
The tires must be checked before
each ride. If the center tread depth
reaches the specified limit, if the tire
has a nail or glass fragments in it, or
if the sidewall is cracked, have a
Yamaha dealer replace the tire imme-
diately.NOTE:
The tire tread depth limits may differ
from country to country. Always com-
ply with the local regulations.
1a
1.Side wall
a.Tread depthMinimum tire tread depth
(front and rear)1.6 mm
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 53

6-19
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9Tire information
This motorcycle is equipped with cast
wheels and tubeless tires.
EW000078
w8The front and rear tires should
be of the same make and
design, otherwise the handling
characteristics of the motorcy-
cle cannot be guaranteed.
8After extensive tests, only the
tires listed below have been
approved for this model by
Yamaha Motor Co., Ltd.
EAU00683
w8Have a Yamaha dealer replace
excessively worn tires. Be-
sides being illegal, operating
the motorcycle with excessive-
ly worn tires decreases riding
stability and can lead to loss
of control.
8The replacement of all wheel-
and brake-related parts, inclu-
ding the tires, should be left to
a Yamaha dealer, who has the
necessary professional knowl-
edge and experience.
FRONT
ManufacturerSizeTypeBRIDGESTONE
100/90-18 56PTW53
DUNLOP
100/90-18 56PD602F
REAR
ManufacturerSizeType
BRIDGESTONE
130/80-17 65PTW54
DUNLOP130/80-17 65PD602
EW000079
w8Have a Yamaha dealer replace
excessively worn tires.
Besides being illegal, operat-
ing the motorcycle with exces-
sively worn tires decreases
riding stability and can lead to
loss of control.
8The replacement of all wheel-
and brake-related parts,
including the tires, should be
left to a Yamaha dealer, who
has the necessary profession-
al knowledge and experience.
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 54

1
2
3
4
5
6
7
8
9
7-3
After cleaning
1.Dry the motorcycle with a
chamois or an absorbing cloth.
2.Immediately dry the drive chain
and lubricate it to prevent it from
rusting.
3.Use a chrome polish to shine
chrome, aluminum and stainless-
steel parts, including the exhaust
system. (Even the thermally
induced discoloring of stainless-
steel exhaust systems can be
removed through polishing.)
4.To prevent corrosion, it is recom-
mended to apply a corrosion pro-
tection spray on all metal, includ-
ing chrome- and nickel-plated,
surfaces.
5.Use spray oil as a universal
cleaner to remove any remaining
dirt.
6.Touch up minor paint damage
caused by stones, etc.
7.Wax all painted surfaces.8.Let the motorcycle dry complete-
ly before storing or covering it.
EWA00001
w8Make sure that there is no oil
or wax on the brakes or tires.
If necessary, clean the brake
discs and brake linings with a
regular brake disc cleaner or
acetone, and wash the tires
with warm water and a mild
detergent.
8Before operating the motorcy-
cle test its braking perfor-
mance and cornering behav-
ior.
ECA00013
cC8Apply spray oil and wax spar-
ingly and make sure to wipe
off any excess.
8Never apply oil or wax to any
rubber and plastic parts, but
treat them with a suitable care
product.
8Avoid using abrasive polish-
ing compounds as they will
wear away the paint.NOTE:
Consult a Yamaha dealer for advice
on what products to use.
MOTORCYCLE CARE AND STORAGE
7
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 81

1
2
3
4
5
6
7
8
9
7-5
6.Lubricate all control cables and
the pivoting points of all levers
and pedals as well as of the
sidestand/centerstand.
7.Check and, if necessary, correct
the tire air pressure, and then lift
the motorcycle so that both of its
wheels are off the ground.
Alternatively, turn the wheels a
little every month in order to pre-
vent the tires from becoming
degraded in one spot.
8.Cover the muffler outlet with a
plastic bag to prevent moisture
from entering it.
9.Remove the battery and fully
charge it. Store it in a cool, dry
place and charge it once a
month. Do not store the battery
in an excessively cold or warm
place (less than 0 ¡C) or more
than 30 ¡C). For more informa-
tion on storing the battery, see
page 6-33.
NOTE:
Make any necessary repairs before
storing the motorcycle.
MOTORCYCLE CARE AND STORAGE
7
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 83