2001 YAMAHA TDR 125 oil type

1
4.Install the transmission oil drain
bolt, and then tighten it to the
specified torque.
5.Add the specified amount of the
recommended transmission oil,
and then install and tighten the
oil filler cap.1.Transmission oil drain bolt
6-9
1
1.Oil filler capTo change the transmission oil
1.Start the engine, warm it up for
several minutes, and then turn it
off.
2.Place an oil pan under the trans-
mission to collect the used oil.
3.Remove the oil filler cap and
drain bolt to drain the oil from the
transmission.
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9Tightening torque:
Transmission oil drain bolt:
15 Nm (1.5 m0kg)
1
2
1.Check window
2.Minimum level mark3.Wait a few minutes until the oil
settles, and then check the oil
level through the check window
located at the right side of the
crankcase.NOTE:
The transmission oil should be above
the minimum level mark.4.If the oil is below the minimum
level mark, remove the oil filler
cap, add sufficient oil of the rec-
ommended type to raise it to the
correct level, and then install and
tighten the cap.
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 44

6-14
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9 4.Lift the front of the fuel tank to
position the fuel tank away from
the air filter case. (Do not discon-
nect the fuel hoses!)
EW000071
w8Make sure that the fuel tank is
well supported.
8Do not tilt or pull the fuel tank
too much, otherwise the fuel
hoses may come loose, which
could cause fuel leakage.
1
3
3
2
1.Relay (´2)
2.Air filter case cover
3.Screw (´7)5.Remove the relays by pulling
them off their holders, and the air
filter case cover by removing the
screws.
1
1.Sponge material6.Pull the sponge material out,
clean it with solvent, and then
squeeze the remaining solvent
out.
7.Apply oil of the recommended
type to the entire surface of the
sponge material, and then
squeeze the excess oil out.NOTE:
The sponge material should be wet
but not dripping.
Recommended oil:
2-stroke engine oil
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 49

6-24
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
EAU03774
Checking the brake fluid
levelInsufficient brake fluid may allow air
to enter the brake system, possibly
causing it to become ineffective.
Before riding, check that the brake
fluid is above the minimum level mark
and replenish if necessary. A low
brake fluid level may indicate worn
brake pads and/or brake system
leakage. If the brake level is low, be
sure to check the brake pads for
wear and the brake system for leak-
age.
1
LOWER
1.Minimum level mark FRONT
8Refill with the same type of brake
fluid. Mixing fluids may result in a
harmful chemical reaction and
lead to poor braking perfor-
mance.
8Be careful that water does not
enter the brake fluid reservoir
when refilling. Water will signifi-
cantly lower the boiling point of
the fluid and may result in vapor
lock.
8Brake fluid may deteriorate paint-
ed surfaces or plastic parts.
Always clean up spilled fluid
immediately.
8As the brake pads wear, it is nor-
mal for the brake fluid level to
gradually go down. However, if
the brake fluid level goes down
suddenly, have a Yamaha dealer
check the cause.
1
LOWER UPPER
1.Minimum level markObserve these precautions:
8When checking the fluid level,
make sure that the top of the
brake fluid reservoir is level.
8Use only the recommended qual-
ity brake fluid, otherwise the rub-
ber seals may deteriorate, caus-
ing leakage and poor braking
performance.REARRecommended brake fluid:
DOT 4
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 59

SPECIFICATIONS
1
2
3
4
5
6
78
9
Specifications
ModelTDR125
Dimensions
Overall length2,120 mm
(F, GB, IRL, B, P, GR, E)
2,185 mm (S, SF, D, CH, A)
Overall width840 mm
Overall height1,295 mm
Seat height850 mm
Wheel base1,405 mm
Ground clearance270 mm
Minimum turning radius2,200 mm
Basic weight (with oil and full
fuel tank)135 kg
136 kg (CH, A)
Engine
Engine typeLiquid cooled 2-stroke,
gasoline
Cylinder arrangementForward inclined single
cylinder
Displacement125 cm
3
Bore ´Stroke56.0 ´50.7 mm
Compression ratio6.6:1
Starting systemElectric starter
Lubrication systemSeparate lubrication
(Yamaha Autolube)Engine oil (2-cycle)
TypeYamalube 2 or equivalent
2-stroke engine oil
Capacity
Total amount1.2 L
Transmission oil
TypeSAE 10W30 SE motor oil
Capacity
Periodic oil change0.75 L
Total amount0.8 L
Cooling system capacity
(total amount)1.05 L
Air filterWet type element
Fuel
TypeRegular unleaded gasoline
Fuel tank capacity11 L
Reserve amount2.2 L
Carburetor
ManufacturerMIKUNI
Model ´quantityTM28SS ´1
EAU01038
SPECIFICATIONS
8-1
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 84

SPECIFICATIONS
1
2
3
4
5
6
78
9
Wheels
Front
TypeCast
Size18 ´MT2.15
Rear
TypeCast
Size17 ´MT2.50
Brakes
Front
TypeSingle disc brake
OperationRight hand
FluidDOT 4
Rear
TypeSingle disc brake
OperationRight foot
FluidDOT 4
Suspension
Front
TypeTelescopic fork
Rear
TypeSwingarm (Monocross)Spring/shock absorber
Front
TypeCoil spring / oil damper
Rear
TypeCoil-gas spring / oil damper
Wheel travel
Front180 mm
Rear180 mm
Electrical
Ignition systemC.D.I.
Charging system
TypeC.D.I. magneto
Standard output14 V, 12A @5,000 r/min
Battery
TypeYTX5L-BS
Voltage, capacity12 V, 4 AH
Headlight typeQuartz bulb (halogen)
Bulb voltage, wattage ´quantity
Headlight12 V, 60/55W ´2
12 V, 35/35W ´2 (GB, IRL)
8-3
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 86