2001 YAMAHA TDR 125 high beam

0
001
0001
00
140
180 120 100 80
1 23456
7
8
9
10
11
12
X1000r/min
km/h
CH
1
2
4
3
EAU03034
Indicator and warning lights
EAU03201
Oil level warning light Ò
7
Ó
This warning light comes on when
the engine oil level is low.
The electrical circuit of the warning
light can be checked according to the
following procedure.
1.Set the engine stop switch to Ò#Ó
and turn the key to ÒONÓ.
2.Shift the transmission into the
neutral position or pull the clutch
lever.3.Push the start switch. If the
warning light does not come on
while pushing the start switch,
have a Yamaha dealer check the
electrical circuit.
NOTE:
Even if the oil level is sufficient, the
warning light may flicker when riding
on a slope or during sudden acceler-
ation or deceleration, but this is not a
malfunction.
EAU00057
Turn signal indicator light Ò5Ó
This indicator light flashes when the
turn signal switch is pushed to the left
or right.
EAU00061
Neutral indicator light ÒNÓ
This indicator light comes on when
the transmission is in the neutral
position.
EAU00063
High beam indicator light Ò&Ó
This indicator light comes on when
the high beam of the headlight is
switched on.
1.Turn signal indicator light Ò5Ó
2.High beam indicator light Ò&Ó
3.Oil level warning light Ò
7
Ó
4.Neutral indicator light ÒNÓ
3-2
INSTRUMENT AND CONTROL FUNCTIONS
1
23
4
5
6
7
8
95AE-9-E4 (ENG) 8/30/00 5:04 PM Page 12

3-4
01140120
10
0
3456
CH1
2
1.Coolant temperature gauge
2.Red zone
EAU01652
Coolant temperature gaugeWith the key in the ÒONÓ position, the
coolant temperature gauge indicates
the temperature of the coolant. The
coolant temperature varies with
changes in the weather and engine
load. If the needle reaches or enters
the red zone, stop the motorcycle
and let the engine cool. (See page
6-43 for further instructions.)
EC000002
cCDo not operate the engine if it is
overheated.INSTRUMENT AND CONTROL FUNCTIONS
1
23
4
5
6
7
8
9
1
2
3
4
EAU00118
Handlebar switches
EAU00134
Light switch
Set this switch to Ò
'
Ó to turn on the
auxiliary light, meter lighting and tail-
light. Set the switch to Ò:Ó to turn on
the headlight also.
EAU00121
Dimmer switch
Set this switch to Ò&Ó for the high
beam and to Ò%Ó for the low beam.
EAU00127
Turn signal switch
To signal a right-hand turn, push this
switch to Ò6Ó. To signal a left-hand
turn, push this switch to Ò4Ó. When
released, the switch returns to the
center position. To cancel the turn
signal lights, push the switch in after
it has returned to the center position.
EAU00129
Horn switch Ò*Ó
Press this switch to sound the horn.
1.Light switch
2.Dimmer switch
3.Turn signal switch
4.Horn switch Ò*Ó
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 14

3-5
INSTRUMENT AND CONTROL FUNCTIONS
1
23
4
5
6
7
8
9
1
2
&
&%
%
LeftRightBulb to be used
Destination3'3
2
'2
3
2
Halogen
bulb
Halogen
bulbFrance Sweden Portugal Spain
Greece Belgium Germany
Switzerland Finland Austria
England
Ireland 3 : High beam light on , 2: Low beam light on
'
: Auxiliary light on
12V
60/55W
12V
60/55W
12V
35/35W
12V
35/35W
EAU00136
Headlight variationsNOTE:
Right and left are defined as seen when standing in front of the motorcycle.
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 15

SPECIFICATIONS
1
2
3
4
5
6
78
9
8-4 Tail/brake light12 V, 5/21W ´2
Front turn signal light12 V, 21W ´2
Rear turn signal light12 V, 21W ´2
Auxiliary light12 V, 4W ´2
12 V, 3.4W ´2 (GB, IRL)
Meter lighting12 V, 3.4W ´3
Neutral indicator light12 V, 3.4W ´1
High beam indicator light12 V, 3.4W ´1
Oil level warning light12 V, 3.4W ´1
Turn indicator light12 V, 3.4W ´1
Fuse20A
5AE-9-E4 (ENG) 8/30/00 5:04 PM Page 87