2001 TOYOTA TACOMA child lock

’01 Tacoma U (L/O 0009)
632001 TACOMA (OM35766U)
With the child restraint system installed,
check that your driving position is satis-
factory and that the child restraint system
does not interfere with your driving.
If your driving position is not satisfactory,
or the child restraint system interferes
with your driving, install it at another posi-
tion.
Split bench seat
Adjust the passenger seat forward and
rearward travel as well as seatback posi-
tion so that the child restraint system is
securely restrained.
CAUTION
Ignoring the above instructions may
result in a serious injury in case of
an accident.
CAUTION
Rear−facing child restraint system:
Never put a rear−facing child restraint
system on the front passenger seat
with the passenger airbag manual on−
off switch in the ON" position. In
the event of an accident, the force of
the rapid inflation of the front pas-
senger airbag can cause death or se-
rious injury to the child.
When you put a rear−facing child re-
straint system on the front passenger
seat, turn the passenger airbag manual
on−off switch counterclockwise to the
OFF" position. (For details, see SRS
driver and front passenger airbags" in
this section.)
The indicator comes on when the system
is off.

’01 Tacoma U (L/O 0009)
652001 TACOMA (OM35766U)
CAUTION
After inserting the tab, make sure
the tab and buckle are locked and
that the lap belt is not twisted.
Do not insert coins, clips, etc. in
the buckle as this may prevent you
from properly latching the tab and
buckle.
If the seat belt does not function
normally, it cannot protect your
child from injury. Contact your
Toyota dealer immediately. Do not
use the seat until the seat belt is
fixed.
2. While pressing the convertible seatfirmly against the seat cushion and
seatback, tighten the lap belt by pulling
its free end to hold the convertible seat
securely.CAUTION
Push and pull the child restraint sys-
tem in different directions to be sure
it is secure. Follow all the installation
instructions provided by its manufac-
turer.

’01 Tacoma U (L/O 0009)
672001 TACOMA (OM35766U)
CAUTION
Never put a rear−facing child restraint
system on the right front seat with
the passenger airbag manual on−off
switch in the ON" position. In the
event of an accident, the force of the
rapid inflation of the front passenger
airbag can cause death or serious in-
jury to the child.
When you put a rear−facing child re-
straint system which belongs to a pas-
senger risk group on the right front
seat, turn the passenger airbag manual
on−off switch counterclockwise to the
OFF" position. (For details, see SRS
driver and front passenger airbags" in
this section.)
The indicator comes on when the system
is off.
CAUTION
If you must put a rear−facing child
restraint system on the right front
seat, make sure the front passenger
airbag manual on−off switch is in the
OFF" position and that the indicator
light is on.

’01 Tacoma U (L/O 0009)
682001 TACOMA (OM35766U)
CAUTION
Do not put a rear−facing child re-
straint system on the rear seat if
the child restraint system interferes
with the front seat lock mechanism
or with your proper driving posi-
tion. This can cause severe injury
to the child and front passenger in
case of sudden braking or a colli-
sion.
If your driving position is not satis-
factory, install the child restraint
system at another position.
1. Run the lap and shoulder belt throughor around the infant seat following the
instructions provided by its manufactur-
er and insert the tab into the buckle
taking care not to twist the belt. Keep
the lap portion of the belt tight.
CAUTION
After inserting the tab, make sure
the tab and buckle are locked and
that the lap and shoulder portions
of the belt are not twisted.
Do not insert coins, clips, etc. in
the buckle as this may prevent you
from properly latching the tab and
buckle.
If the seat belt does not function
normally, it cannot protect your
child from injury. Contact your
Toyota dealer immediately. Do not
use the seat until the seat belt is
fixed.

’01 Tacoma U (L/O 0009)
692001 TACOMA (OM35766U)
2. Fully extend the shoulder belt to put itin the lock mode. When the belt is
then retracted even slightly, it cannot
be extended.
To hold the infant seat securely, make
sure the belt is in the lock mode before
letting the belt retract.3. While pressing the infant seat firmly against the seat cushion and seatback,
let the shoulder belt retract as far as
it will go to hold the infant seat secure-
ly.CAUTION
Push and pull the child restraint sys-
tem in different directions to be sure
it is secure. Follow all the installation
instructions provided by its manufac-
turer.

’01 Tacoma U (L/O 0009)
712001 TACOMA (OM35766U)
When you put a rear−facing child re-
straint system which belongs to a pas-
senger risk group on the right front
seat, turn the passenger airbag manual
on−off switch counterclockwise to the
OFF" position. (For details, see SRS
driver and front passenger airbags" in
this section.)
The indicator comes on when the system
is off.
CAUTION
If you must put a rear−facing child
restraint system on the right front
seat, make sure the passenger airbag
manual on−off switch is in the OFF"
position and that the indicator light is
on.
CAUTION
Forward−facing child restraint system:
A forward−facing child restraint sys-
tem which belongs to a passenger
risk group should never be put on
the right front seat with the passen-
ger airbag manual on−off switch in
the ON" position, because the force
of the deploying airbag could cause
death or serious injury to the child in
forward seating position. (For details,
see SRS driver and front passenger
airbags" in this section.)

’01 Tacoma U (L/O 0009)
722001 TACOMA (OM35766U)
CAUTION
Do not put a rear−facing child re-
straint system on the rear seat if
the child restraint system interferes
with the front seat lock mechanism
or with your proper driving posi-
tion. This can cause severe injury
to the child and front passenger in
case of sudden braking or a colli-
sion.
If your driving position is not satis-
factory, install the child restraint
system at another position.
1. Run the lap and shoulder belt throughor around the convertible seat following
the instructions provided by its
manufacturer and insert the tab into
the buckle taking care not to twist the
belt. Keep the lap portion of the belt
tight.
CAUTION
After inserting the tab, make sure
the tab and buckle are locked and
that the lap and shoulder portions
of the belt are not twisted.
Do not insert coins, clips, etc. in
the buckle as this may prevent you
from properly latching the tab and
buckle.
If the seat belt does not function
normally, it cannot protect your
child from injury. Contact your
Toyota dealer immediately. Do not
use the seat until the seat belt is
fixed.

’01 Tacoma U (L/O 0009)
732001 TACOMA (OM35766U)
2. Fully extend the shoulder belt to put itin the lock mode. When the belt is
then retracted slightly, it cannot be ex-
tended.
To hold the convertible seat securely,
make sure the belt is in the lock mode
before letting the belt retract.3. While pressing the convertible seat firmly against the seat cushion and
seatback, let the shoulder belt retract
as far as it will go to hold the convert-
ible seat securely.CAUTION
Push and pull the child restraint sys-
tem in different directions to be sure
it is secure. Follow all the installation
instructions provided by its manufac-
turer.