2001 TOYOTA RAV4 fog light bulb

'01 Rav4_U (L/O 0008)
2362001 RAV4 (OM42483U)
Replacing light bulbsÐ
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if scratched
or dropped. Hold a bulb only by its
plastic or metal case. Do not touch
the glass part of a bulb with bare
hands.
NOTICE
Only use a bulb of the listed type.
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just like the
windshield fogged up in the rain. However,
if there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light, contact your
Toyota dealer.Light bulbsBulb
No.WTy p e
HeadlightsÐ60/55A
Front fog lightsÐ51B
Par k i ng and fr ont
side marker lights1685C
Front turn signal
lights (without
front fog lights)
7440A21C
Front turn signal
lights (with front
fog lights)
744021C
Side turn signal
lightsÐ5C
Rear turn signal
lights744021C
Stop/tail and rear
side marker lights744321/5C
Back±up lights744021C
License plate light1685C
High mounted
stop light744021C
ProCarManuals.com

'01 Rav4_U (L/O 0008)
2382001 RAV4 (OM42483U)
ªTOPº mark
3. Install the rubber cover with the
ªTOPº mark upward, and snuggle on
the boss. Insert the connector.
Make sure the rubber cover fits snugly on
the connector and the headlight body.
Aiming is not necessary after replacing
the bulb. When aiming adjustment is nec-
essary, contact your Toyota dealer.
ÐFront fog lights
1. Loosen the retainer screw with a
Phillips±head screwdriver and take
out the front turn signal light unit.2. Remove the front fog light unit.
ProCarManuals.com

'01 Rav4_U (L/O 0008)
2392001 RAV4 (OM42483U)
3. Unplug the connector while depress-
ing on the tab.
If the connector is tight, wiggle it.4. Turn the bulb and remove it.5. Install a new bulb and the connector
into the mounting hole. Install the
front fog light unit then the front
turn signal light unit, and tighten the
retainer screw.
ProCarManuals.com