2001 TOYOTA CAMRY CNG light

’01CAMRY CNG (L/O0009)
1942001 CAMRY CNG_U (OM33542U)
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just like the
windshield fogged up in the rain. However,
if there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light, contact your
Toyota CNG dealer.Light bulbsBulb
No.WTy p e
Headlights (high)900560A
Headlights (low)900651B
Parking, front side
marker and front
turn signal lights3157
NA27/8E
Rear side marker
lights1943.8D
Rear turn signal
lights3156
or
3157
27D
Stop/tail lights315727/8D
Back−up lights92118D
License plate lights—5D
High mounted
stoplight21CP18D
Interior light—10F
Glove box light—1.2D
Trunk light—3.8D
A: HB3 halogen bulbs
B: HB4 halogen bulbs
C: Single end bulbs
D: Wedge base bulbs
E: Wedge base bulbs (amber)
F: Double end bulbs

’01CAMRY CNG (L/O0009)
1952001 CAMRY CNG_U (OM33542U)
—Headlights
Low beamHi beam
1. Open the hood. Turn the bulb base
counterclockwise to the front of the
vehicle as shown.2. Unplug the connector while depress-
ing the lock release.
If the connector is tight, wiggle it.3. Install a new bulb and connector
into the mounting hole.
Aiming is not necessary after replacing
the bulb. When aiming adjustment is nec-
essary, contact your authorized Toyota
CNG dealer.

’01CAMRY CNG (L/O0009)
1962001 CAMRY CNG_U (OM33542U)
Use a flat−bladed screwdriver. Remove
and install the cover clips as shown in
the following illustrations.Removing the cover clips
Installing the cover clips
Use a flat−bladed screw driver. To protect
the surface, place several sheets of paper
over the surface.
—Parking, front side marker
and front turn signal lights

’01CAMRY CNG (L/O0009)
1972001 CAMRY CNG_U (OM33542U)
Use a Phillips−head screwdriver. Remove
and install the cover clips as shown in
the following illustrations.Removing the cover clips
Installing the cover clips
—Rear side maker, rear turn
signal and stop/tail lights

’01CAMRY CNG (L/O0009)
1982001 CAMRY CNG_U (OM33542U)
a: Rear side marker light
b: Rear turn signal light
c: Stop/tail light
—Stop/tail lights

’01CAMRY CNG (L/O0009)
1992001 CAMRY CNG_U (OM33542U)
—Back−up lights
Use a flat−bladed screwdriver.

’01CAMRY CNG (L/O0009)
2002001 CAMRY CNG_U (OM33542U)
Remove and install the cover clips as
shown in the following illustrations.Removing the cover clips
Installing the cover clips
—License plate lights

’01CAMRY CNG (L/O0009)
2012001 CAMRY CNG_U (OM33542U)
—High mounted stoplight